Hughes & Kettner Statesman DUAL EL34 Manual

Hughes & Kettner Ikke kategoriseret Statesman DUAL EL34

Læs gratis den danske manual til Hughes & Kettner Statesman DUAL EL34 (47 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Hughes & Kettner Statesman DUAL EL34, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/47

english

deutsch

español

français

italiano

Statesman

Head EL34 & Combo 6L6

Manual 1.1

Statesman Series

Foreword

The Hughes & Kettner Statesman Series brings together for the ﬁ rst

time what classic rock as well as blues & country guitarists have been

dreaming about for a long time: From early ‘60s open-back Clean to

early ‘80s stack-drive Cream – and tons of top-drawer crunch tones

in between – these tone monsters deliver the dynamics and state-of-

art features that make life on stage so sweet and simple. With the

marvelous new Statesman series, Hughes & Kettner has debunked the

myth that all classic tube amp designs lack versatility.

The Statesman models’ kinship with ‘60s-era forebears is obvious at

ﬁ rst glance – they share that familiar look & feel. Take a closer look,

though, and you will see its talents transcend mere mimicry, with two

sweet-sounding discrete channels!

Clean delivers the soulful shimmering tone of an open tube combo.

Its Twang switch lives up to its name by adding a healthy helping of

punchy high-mids that put the spank in funk and do the country twang

thang so well; even contemporary ballads beneﬁ t from the upper

mids boost. Dial in a dab more gain, and dive into a world of dynamic

crunch tones and hair-trigger response to every subtlety of your touch.

The Drive channel offers more than merely more gain. It delivers

the secret ingredient that is so critical to a classic rock sound - the

powerful punch of a half-stack. The Gain knob takes you on a magical

mystery tour from a throaty mid-‘60s bark to a typical ‘70s rock

bite. The Boost button is a time machine, taking you and the amp’s

overdrive tone a few years down the road!

We wish you lots of fun with your Statesman!

Your Hughes & Kettner Team

Before the start-up

• Please read the safety notes on Page 42 to 44 before the start-up!

• A word of warning before you start-up your Statesman: It is loud!

High loudness levels can cause hearing damage.

• Ensure a sufﬁ cient air supply to the ampliﬁ er’s cooling surfaces.

Absolutely pay attention to a ﬁ xed storage space, which precludes

mechanical and thermal external inﬂ uences, and thus ensures the

operational safety of the equipment and the safety of individuals.

• The manufacturer cannot assume any liability for damages to the

appliance or to other devices which ensue through improper

operation.

Head Only

First plug the speaker cord into the appropriate output on the Head.

Do not use more than one of these outputs simultaneously! That is, use

either 1x4 ohms, 2x16 ohms, 1x8 ohms, or 1x16 ohms. Don’t mix and

match cabinets either, say by plugging a 4-ohm cabinet into the 4-ohm

output and a 16-ohm cabinet into the 16-ohm output.

Plug the other end of the cord into the speaker cabinet’s Input. This is

vital to every all-tube amp’s life! Power amps may be damaged when

tube amps are operated without a connected speaker load or at an

insufﬁ cient impedance level!

Combo Only

Check to ensure the cable to the internal speaker is connected properly

to the power amp (see ﬁ gure).

Start-up

• Before connecting the Statesman to the power supply network, make

sure that the power switch is turned off and the indicated voltage

value on the back side (see illustration: next to the “Voltage Setting”

arrow) tallies with the local mains voltage.

• The illustration shows the 100/120 volt version as an example. The

indication of 100 volts is next to the arrow.

And so the amp may only be operated on

100 V mains voltage. If the indication on your

Statesman next to the arrow does not tally

with the voltage that you intend to operate

with, it must not be connected!

• In order to avoid unwanted surprises, you should always turn the

CLEAN VOLUME and the DRIVE MASTER controllers to the left stop

before turning the amp on.

• INPUT: Connect your guitar with this input. Please use only suitable,

shielded guitar cable.

• POWER: This switch opens the main current supply; the blue PILOT

LAMP lights up.

• Allow the tubes to warm up before you begin playing. Flip the

STANDBY switch to bring those glowing tubes to life.

Produkt Specifikationer

Mærke:	Hughes & Kettner
Kategori:	Ikke kategoriseret
Model:	Statesman DUAL EL34

Har du brug for hjælp?

Hvis du har brug for hjælp til Hughes & Kettner Statesman DUAL EL34 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Hughes & Kettner Manualer

Hughes & Kettner TubeMeister 36 Head Manual

23 September 2025

Hughes & Kettner WARP 112 Manual

17 September 2025

Hughes & Kettner Statesman DUAL EL34 Manual

17 September 2025

Hughes & Kettner Statesman DUAL 6L6 Manual

16 September 2025

Hughes & Kettner Vortex 212 Manual

16 September 2025

Hughes & Kettner TubeMeister 36 Manual

16 September 2025

Hughes & Kettner Statesman DUAL EL84 Manual

16 September 2025

Hughes & Kettner Triplex Manual

16 September 2025

Hughes & Kettner Tube Clock Manual

16 September 2025

Hughes & Kettner WARP 212 Manual

16 September 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Metro C539-HLFS-L Manual

23 September 2025

Electrolux M2GCP121 Manual

23 September 2025

Crestron CBLR-HD Manual

23 September 2025

Prebena MODUL 11-CNW90 Manual

23 September 2025

Ampetronic ACWP50 Manual

23 September 2025

Prebena 2F-JA45 Manual

23 September 2025

Midea MPC602SBMK Manual

23 September 2025

Chefman RJ51 Manual

23 September 2025

Ikon ISP48 Manual

23 September 2025

T'nB Activ 1000X ACTIV1000X Manual

23 September 2025