IFM JN2301 Manual


Læs gratis den danske manual til IFM JN2301 (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 11 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 6 anmeldelser. Har du et spørgsmål om IFM JN2301, eller vil du spørge andre brugere om produktet?

Side 1/3
Installation instructions
Inclination sensor JN
JN2300
JN2301
80254489/00 05/2016
UK
2
1 Functions and features
The 2-axis inclination sensor with SAE J1939 interface enables angle levelling and
position detection of mobile machines.
Typical applications are, for example, the position detection of access platforms,
levelling of mobile cranes or set-up of mobile machines.
2-axis inclination sensors with a measuring range of:
JN2300: ±180° / 0...360°
JN2301: ±45°
2 Symbols used
Instructions
Important note
Non-compliance can result in malfunction or interference.
3 Installation
Disconnect the system from power before installation.
3.1 Fastening
Fasten the device using 4 M5 screws on a flat surface.
Screw material: steel or stainless steel.
3.2 Mounting surface
The housing must not be exposed to any torsional forces or mechanical stress.
Use compensating elements if there is no flat mounting surface available.
4 Electrical connection
The unit must be connected by a qualified electrician.
The national and international regulations for the installation of electrical equipment
must be adhered to.
Disconnect the installation from power and connect the unit.
The inclination sensors are fitted with two round 5-pole M12 connectors (A-coded).


Produkt Specifikationer

Mærke: IFM
Kategori: Ikke kategoriseret
Model: JN2301

Har du brug for hjælp?

Hvis du har brug for hjælp til IFM JN2301 stil et spørgsmål nedenfor, og andre brugere vil svare dig