Indesit IDC 8T3 B K (UK) Manual

Indesit Tørretumbler IDC 8T3 B K (UK)

Læs gratis den danske manual til Indesit IDC 8T3 B K (UK) (4 sider) i kategorien Tørretumbler. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Indesit IDC 8T3 B K (UK), eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Instruction booklet

TUMBLE DRYER IDC 8T3 B (UK)

IDC 8T3 B K (UK)

IDC 8T3 B S (UK)

Step 1

Open the door of your dryer.

Step 2

Pull out the ﬁlter (using the two

ﬁnger grips).

Step 3

Clean the ﬂuff off the ﬁlter and

replace it correctly.

Step 4

Make sure the ﬁlter is pushed fully home -

NEVER run the dryer without the ﬁlter in position.

Failure to clean the ﬁlter after EVERY drying

cycle will affect the drying performance of your

machine.

It will take longer to dry and as a result will use

more electricity during drying.

Step 1

Open the condenser cover.

Step 2

Remove the condenser by turning

the 3 catches and

pulling the condenser

towards you. It is normal for some

residual water to be left in the

condenser unit.

Step 3

Flush the condenser

from the rear with water to remove

any ﬂuff deposits.

Step 4

Replace the condenser unit and

make sure that all 3 catches are

closed and that the position arrows

on the front of the condenser are

pointing upwards.

Less than 1m

This symbol reminds you to read this booklet

WHERE TO INSTALL THE TUMBLE DRYER

Install the dryer far from

gas ranges, stoves, radiators

or hobs as ﬂames may

damage it. If the dryer is

installed below a worktop,

ensure there are 10 mm

between the upper panel of

the dryer and any objects

above it and 15 mm between

the sides of the machine

and the walls or furniture units adjacent to it. This

ensures adequate air circulation.The appliance

must be installed with the rear surface placed

against a wall.

! We do not recommend that the dryer is installed

in a cupboard but the dryer must never be

installed behind a lockable door, a sliding door or

a door with a hinge on the opposite side to that of

the dryer door.

Priming the Water Collection System.

When your dryer is new, the water container will not collect water

until the system is primed. This will take 1 or 2 drying cycles. Once

primed it will collect water during every drying cyc .le

WATER DRAINAGE CONNECTION

If the dryer is installed next to a drain the

water can be plumbed into this drain. This

does away with the need to empty the

water container. The height of the drain

must be less than 1m from the bottom of

the dryer. Remove the existing hose from

the dryer and connect it to the drain (if

required add an additional length of hose).

ELECTRICAL CONNECTIONS

The socket must be grounded.

! The power cord must be regularly checked. If

the supply cord is damaged it must be replaced

by the manufacturer, its service agent or similarly

qualiﬁed persons in order to avoid a hazard.

BEFORE YOU START USING YOUR DRYER

Once you have installed your dryer and before

you use it clean the inside of the drum to remove

any dust that could have accumulated during

transport.

CONDENSER UNIT

You MUST clean the ﬂuff from the condenser

EVERY month. Failure to clean the condenser

could cause premature failure of your dryer.

Remove the condenser unit regularly (at least

monthly) and clean off any ﬂuff deposits.

10 mm

15 mm 15 mm

WATER CONTAINER

You empty the water container after MUST EVERY

drying cycle. Removing the water container:

Step 1 Pull the water container

towards you and remove it

completely from the dryer.

Step 2 Empty all the water in the

water container.

Step 3 Replace the water

container making sure that it is securely ﬁxed.

! Failure to empty the water container will

cause the machine to stop heating and the

load may still be wet at the end of the drying

cycle. The ‘Empty Water’ light will tell you

that the water container needs to be emptied

FLUFF FILTER

You must clean the ﬂuff ﬁlter after EVERY drying cycle.

Produkt Specifikationer

Mærke:	Indesit
Kategori:	Tørretumbler
Model:	IDC 8T3 B K (UK)

Har du brug for hjælp?

Hvis du har brug for hjælp til Indesit IDC 8T3 B K (UK) stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Tørretumbler Indesit Manualer

Indesit YTM1091REU Manual

2 September 2025

Indesit IDH E90W IRE Manual

26 August 2025

Indesit IDH E80W IRE Manual

25 August 2025

Indesit BDE 96436 SV UK Manual

22 August 2025

Indesit BDE 107436 WV UK Manual

21 August 2025

Indesit C YD C82 WWGL UK Manual

20 August 2025

Indesit C YD 92D SS UK Manual

20 August 2025

Indesit C YD 92D WW UK Manual

19 August 2025

Indesit C YSD 82D WW UK Manual

19 August 2025

Indesit C YSD 82D BB UK Manual

19 August 2025

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

Whirlpool WP B8X WBS EE Manual

28 December 2025

Whirlpool ST U 92X EU Manual

28 December 2025

Whirlpool AWZ 8457 Manual

28 December 2025

Bosch WTZ2741C Manual

28 December 2025

Whirlpool AWZ 681 Manual

27 December 2025

Whirlpool HSCX 70311 Manual

25 December 2025

Whirlpool AWZ 8458 Manual

25 December 2025

Whirlpool CAREMOTION 710A+ Manual

25 December 2025

Bosch WTZ27510 Manual

25 December 2025

Siemens WS14S4B8HK Manual

24 December 2025