EN
Quick guide
THANK YOU FOR BUYING AN INDESIT PRODUCT
In order to receive a more complete assistance, please
register your product on www . indesit . com/ register
Before using the appliance carefully read the Safety
Instruction.
PRODUCT DESCRIPTION
FIRST TIME USE
Wait at least two hours, after the installation, before connecting the
appliance to the power supply.
Connect the appliance to the power supply and turn the thermostat
knob to switch on the appliance.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally lled
appliance. Position the antibacterial anti-odour lter in the fan as
demonstrated in the lter packaging (if available).
CONTROL PANEL
1. Temperature alarm indicator
2. Fast freezing function
3. Temperature settings
(stand by button)
2.
1.
3.
TEMPERATURE ALARM INDICATOR
When the product is plugged in to the mains, during the rst 10
minutes of working, any temperature sensor failure will be displayed
on the control panel.
Legend:
Led flashing
The appliance will work anyway preserving the food stored, but it is
necessary to contact after-sales service and provide alarm code.
Note: The Temperature alarm may activate if the door is left open for a
prolonged period of time or following the introduction of fresh food in the
freezer compartment; this temporary rise in temperature does not aect
the storage of already frozen food in any way.
FAST FREEZING FUNCTION
The use of this function is recommended to increase the cooling speed
when placing a very high quantity of food in the freezer compartment.
To activate this function press the Temperature button on the control
panel repeatedly until 3 LED’s ash and then remain lit.
The function is automatically deactivated after 48 h.
TEMPERATURE SETTING
Press the Temperature button on the control panel to adjust the
temperature from the warmest through the lower to the coldest level.
Pressing the Temperature button, the temperature setting will change
cyclically.
At rst plug-in of appliance temperature setpoint is present at medium
position (factory setting).
Following table shows temperature setpoints:
Led ON
Led OFF
high temp.
med-high temp.
medium temp.
med-low temp.
low temp.
Note: Displayed set points correspond to the average temperature
throughout the whole freezer.
STAND-BY BUTTON
To put the product in Stand-by, press and hold for 3 seconds the Stand-
by button. All the indicators turn o. To reactivate the appliance press
once (briey) or for 3 seconds this button.
