Infinity IMS Manual


Læs gratis den danske manual til Infinity IMS (12 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 28 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 14.5 anmeldelser. Har du et spørgsmål om Infinity IMS, eller vil du spørge andre brugere om produktet?

Side 1/12
I N F I N I T Y
®
IMS
Input Management System
Système de Gestion des Entrées
Sistema de Gestión de Entrada
I M S
2
THANK YOU
for purchasing
the Infinity®IMS Input Management
System. So that you may be better served
should your new product require service,
please retain your original purchase
receipt and read the enclosed warranty
registration card.
BOX CONTENTS
Your IMS package should contain all the
items shown in Figure 1:
Figure 1. Contents
WARNING
Playing loud music in an automobile can
hinder your ability to hear traffic and
permanently damage your hearing.
Listening at low or moderate levels while
driving your car is recommended. Infinity
Systems accepts no responsibility for
hearing loss, bodily injury or property
damage resulting from the use or misuse
of this product.
INSTALLATION
IMPORTANT
To get the most out of your IMS’s features,
it is strongly recommended that installation
be entrusted to a qualified professional.
Although these instructions explain how
to install, connect and set up the IMS, they
cannot show all of the different possible
systems that can be assembled using the
IMS. Please ask your authorized Infinity car
audio dealer about professional installation.
INSTALLATION ARNINGS AND IPSW T
• Always use protective eyewear when
using tools.
Turn OFF the vehicle’s audio system and
other electrical devices before beginning
installation. Disconnect the (–) negative
lead from the vehicle’s battery.
Check clearances on both sides of any
planned mounting surface befor drillinge
any holes or installing any screws.
Remember that the screws can extend
behind the mounting surface.
• At the installation locations, locate and
make a note of all fuel lines, hydraulic
brake lines, vacuum lines and electrical
wiring. Use extreme caution when cutting
or drilling in and around these areas.
Before drilling or cutting holes, use a
utility knife to remove unwanted fabric
or vinyl to keep material from snagging
in the drill bit.
• When routing cables, keep input-signal
cables away from power cables and
speaker wires to minimize noise.
• When making connections, make certain
they are secure operl insulated.and pr y
• If the IMS’s fuse must be replaced, use
only the same type and rating as the
original. Do not substitute another kind.
Junction Box
Hands-Free
Microphone
Flush-Mount Ring
Wiring Harness Adhesive Strip
Bag with Installation Screws:
4x #8 x 1" Screws for Junction Box
2x #6 Screws for Control Head
2x 3mm Machine Screws for U-Bracket
Owner’s Manual
and Warranty Card
VELCRO
®
Strip
U-Bracket
Hands-Free Microphone
Surface-Mount Holder
Control Head


Produkt Specifikationer

Mærke: Infinity
Kategori: Ikke kategoriseret
Model: IMS

Har du brug for hjælp?

Hvis du har brug for hjælp til Infinity IMS stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Infinity Manualer

Infinity

Infinity BassLink 4SC Manual

16 December 2024
Infinity

Infinity IMS Manual

16 December 2024
Infinity

Infinity S401 Manual

1 September 2024
Infinity

Infinity iW-1941 RDM Manual

1 September 2024
Infinity

Infinity B401 Manual

1 September 2024
Infinity

Infinity iFX-640 Manual

1 September 2024
Infinity

Infinity INF-BC4 Manual

15 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer