JBL Control 50S/T Manual

JBL Subwoofer Control 50S/T

Læs gratis den danske manual til JBL Control 50S/T (2 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 7 anmeldelser. Har du et spørgsmål om JBL Control 50S/T, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Installing Control 50S/T Subwoofer

Using Included Wall Bracket

1. The Control 50S/T comes with the speaker plate of the wall

bracket pre-attached to the speaker. Ensure that that screws

holding this plate to the speaker are tight.

2. Run the wiring from the power amplier to the location

desired for mounting the JBL Control 50S/T subwoofer. Also

run the wiring that will connect the subwoofer to the Control

52 satellite speakers.

3. Using a level, secure the wall plate of the mounting

bracket to the wall. Be sure to use appropriate wall anchors

for attaching the bracket plate. Use all ve screw holes for

maximum integrity and safety.

(Tapping screws shown. Actual hardware and anchors

utilized may differ, depending on the requirements

of the wall material and structure. Secure and safe

attachment is the responsibility of the installer.)

4. Attach a safety cable (not included) to the 6 mm insert on

the back of the Control 50S/T cabinet using the included 6

mm screw. Prepare to attach the other end of the cable to a

secondary attachment point on the wall.

5. Position Control 50S/T subwoofer toward wall, in the

orientation shown, slightly higher than the on-wall plate, then

slide the Control 50S/T subwoofer downward while maintaining

pressure toward the wall until the two bracket plates engage.

Make sure the retaining spring latches securely into place.

6. Remove the input terminal cover, connect wiring and set

the tap selector rotary switch. Replace input terminal cover,

routing wires through the side opening, dressing the wiring

toward the the back side of the cabinet.

CAUTION: Installation must be

done by qualied persons using

safe rigging standards

The installer is responsible for proper selection

and use of mounting hardware, to properly and

safely wall-mount the speakers

6 mm screw and insert point for

secondary safety cable

Removing from Wall -- If there is a need to remove the

subwoofer, insert an object such as long-shaft screwdriver

from the top. Leverage the handle of the screwdriver away

from the wall in order to press the spring latch toward the wall

to disengage the latch. While maintaining pressure on the

latch in this manner, lift the subwoofer upward to remove it

from the wall bracket.

(viewed from top)

Wall Bracket Dimensions

151 [6.0]

147 [5.8]

43 [1.7] 43 [1.7]33 [1.3]

64 [2.5]

58 [2.3]

10 [0.4]

6.4[0.25] dia (x5)

116 [4.5]

JBL Professional

8500 Balboa Boulevard, P.O. Box 2200

Northridge, CA 91329 USA

C50 Inst 6/09

Produkt Specifikationer

Mærke:	JBL
Kategori:	Subwoofer
Model:	Control 50S/T
Produktfarve:	Sort
Pakkevægt:	10200 g
Pakketype:	Kasse
Materiale:	Krydsfiner
Impedens:	8 ohm (Ω)
Subwoofer RMS-effekt:	150 W
Monteringsbeslag inkluderet:	Ja
Subwoofer driver diameter (britisk):	8 "
Subwoofer driver diameter:	200 mm
Subwoofer type:	Aktiv subwoofer
Subwoofer frekvensomrpde:	32 - 200 Hz
Subwoofer spidseffekt:	600 W
Subwoofer, følsomhed:	115 dB
Subwoofer dybde:	203 mm
Subwoofer bredde:	391 mm
Trådløs subwoofer:	Ingen
Subwoofer vægt:	9000 g
Subwoofer højde:	256 mm
Antal subwoofere:	1
Subwoofer crossover-frekvenser:	50 - 150 Hz