Joovy Peg Perego Car Seat Adapter Manual

Joovy Babyprodukter Peg Perego Car Seat Adapter

Læs gratis den danske manual til Joovy Peg Perego Car Seat Adapter (2 sider) i kategorien Babyprodukter. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 11 anmeldelser. Har du et spørgsmål om Joovy Peg Perego Car Seat Adapter, eller vil du spørge andre brugere om produktet?

Side 1/2
!WARNING
This infant car seat adapter is for use ONLY on the Joovy Zoom Joggers. DO NOT use on other stroller models.
This infant car seat adapter is for use ONLY with the Peg Perego® infant car seat models identied below. DO NOT use other infant car seat
models.
ALWAYS install the infant car seat so that the child is facing toward the rear (handlebar) of the stroller.
ALWAYS position the infant car seat so that it securely snaps into place inside the infant car seat adapter frame.
!WARNING
Before each use, check to make sure all four clamps are secure and all Velcro® straps are fully attached.
Installing/Using the Infant Car Seat Adapter
• UnsnapthevesnapslocatedonBOTHsidesoftheseat.See Figure 1.
• Foldthefabricinsideandunderthestrollerframetubessothatthetubesareclearlyexposedonbothsidesofthestroller.See Figure 2.
• Positionthecanopysoitisopenedhalfway.Reclinetheseattoitsmaximumreclineposition.See Figure 3.
• RemovetheVelcro®strapsfromeachclamp,thenopenallfourclampsontheadapter.
• Placethecarseatadapteronthestrollerframetubessothatthecanopyhingebracketsarebetweentheadapterclamps.See Figure 4.
DO NOT allow any of the seat fabric to be captured by the clamp.
• Closeallfourclampsaroundthestrollerframetubes.See Figure 5. Makesurethatallfourclampsarefullyclosedandnoseatfabricis
capturedbytheclamps.
• InserttheloopendofoneVelcro®strapbetweenoneadapterclampandtheseatfabric.Attachthelooparoundthetabontheclamp.
See Figure 6.
• WraptheVelcro®straptightlyaroundtheclamp.See Figure 7.
• EnsurethatthemiddleloopoftheVelcro®straptsovertheclamptab. See Figure 8.
ContinuewrappingtightlyuntiltheentirelengthoftheVelcro®strapissecuredtogether.MakesuretheedgesoftheVelcro®strapare
alignedformaximumstrength.See Figure 9.
• RepeatfortheotherthreeclampsandVelcro®straps.
• Closethecanopycompletely.
NOTE: Tomaximizespaceforyourbaby,attachthetwosetsofsnapsfoundontheundersideofthecanopy.See Figure 10.
• PlacethePegPerego®infantcarseat(sothecarseatfacesthehandlebar)intotheadapteruntilthecarseatsnapsintoplace.Pullupon
thecarseattoensureitissecure.See Figure 11.
• Toremovetheinfantcarseat,pullthereleaselever(sameleverusedtoreleasethecarseatfromitsbase)andliftup.
NOTE: strollerfoldswithcarseatadapterinstalled.
Removing the Infant Car Seat Adapter
• Toremovethecarseatadapter,rstpositionthecanopysothatitisopenedhalfway.
• RemoveallfourVelcro®strapsfromtheclamps.
• Openallfourclampsandremovetheadapterfromthestroller.
• ReattachthefourVelcro®strapstotheclampsontheadapterandstoretheadapterforfutureuse.
• WraptheseatfabricoverthestrollerframetubesandreattachthevesnapslocatedonBOTHsidesofthestroller.
Zoom
Peg Perego® Car Seat Adapter
00951
PEG PEREGO® CAR SEAT ADAPTER COMPATABILITY
Peg Perego® Primo Viaggio
Figure 1
Figure 7
Figure 2
Figure 8
Figure 5Figure 4
Figure 11Figure 10
Figure 6
Figure 3
Figure 9
©joovy 2013 • Document Version 091313
Joovy•2919CantonStreet•Dallas,TX75226•(877)456-5049•Fax:(214)761-1774Email:customerservice@joovy.com•Website:www.joovy.com


Produkt Specifikationer

Mærke: Joovy
Kategori: Babyprodukter
Model: Peg Perego Car Seat Adapter

Har du brug for hjælp?

Hvis du har brug for hjælp til Joovy Peg Perego Car Seat Adapter stil et spørgsmål nedenfor, og andre brugere vil svare dig