Jøtul F 602 CB Manual


Læs gratis den danske manual til Jøtul F 602 CB (20 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Jøtul F 602 CB, eller vil du spørge andre brugere om produktet?

Side 1/20
Jøtul F 602 CB
Non-catalytic Wood Heater
tul F 602 CB
Installation and Operating Instructions
for the United States and Canada
The Jøtul F 602 CB non-catalytic stove is
listed to burn solid wood only. Do not
burn any other fuels.
Read this entire manual before you
install and use this appliance.
Save these instructions for future
reference and make them available to
anyone using or servicing the fireplace
insert.
This wood heater requires periodic
inspection and repair for proper
operation. See this manual for specific
maintenance information. It is against
federal regulations to operate this
wood heater in a manner inconsistent
with the operating instructions in this
owner’s manual.
2
F CB _R August 602 139677 05 2018
NOTE: for a new, painted stove It is normal
to emit odor and smoke during initial fires,
depending on temperatures over time. This is
caused by the curing of the high temperature
paint and manufacturing materials. This
condition can be alleviated by opening
a window or door to provide additional
ventilation.
Table of Contents
Combustion Specifications,
Building Codes, .................................................................3
1.0 Safety Notices 3 ................................................................
2.0 Initial Assembly
2.1 Inspect Contents 4 ...................................................................
2.2 Flue Collar Reversal 4 ..............................................................
3.0 Installation
3.1 Chimney Connection 4 ..........................................................
3.2 Wall Pass-throughs 4 ..............................................................
3.3 Chimney Requirements 5 ......................................................
3,4 Hearthmount to a Fireplace 5 ..............................................
3,5 Factory-built Prefabricated Chimney 5 ..............................
4.0 Clearances Requirements
4.1 Floor Protection 6 .....................................................................
4.2 Alternate Floor Protection 6 ..................................................
4.3 Clearances to Combustible Materials 6 .............................
4.4 Rear Heat Shield 6 ....................................................................
4.5 Wall Protection 6 .....................................................................
4.6 Alcove Clearances 6 .................................................................
4.7 Fireplace Mantel and Trim Clearances 6 ............................
5.0 Operation
5.1 Combustion Efficiency......................................................... 7
5.2 CO Emissions 7 .........................................................................
5.3 Wood Fuel and Performance 7 .............................................
5.4 Air Flow and Control 7 ............................................................
5.5 Break-in Procedure 8 ...............................................................
5.6 Top-down Fire Starting ....................................................... 8
5.7 Adding Fuel 9 ...........................................................................
5.8 Open Door Fire-viewing 9 ......................................................
5.9 Ash Removal........................................................................... 9
6.0 Maintenance
6.1 Glass Care 10 ...............................................................................
6.2 Glass Removal 10 .......................................................................
6.3 Gaskets .................................................................................... 10
6.4 General Inspection 10 ...............................................................
6.5 Chimney System 10 ...................................................................
7.0 Illustrations
7.1 Clearance Chart 11 .....................................................................
7.2 Figures 12 .....................................................................................
8.0 Part List 17 .........................................................................
9.0 Appendix A - Alternate Floor Protection 17 ........................
10.0 Warranty 18 .............................................................................
Standards
The Jøtul F solid fuel heater has been tested and 602 CB
listed to :
U.S. Standards: ANSI/UL 737 and ANSI/UL 1482.
Canadian Standards:
CAN/ULC-S627-M and CAN/ULC-S628-M00 93
Certified Safety Tests performed by:
Intertek Testing Services, Middleton,
Wisconsin U.S.A.
Manufactured by:
Jøtul North America, Inc.
55 Hutcherson Drive
Gorham, Maine 04038, USA
and
Jøtul AS, P.O. Box 1411, Fredrikstad, Norway
This heater meets the U.S. Environmental 2015
Protection Agency’s emission limits for wood
heaters manufactured after May 15, 2015.
This heater may not to be sold after May 15, 2020.
WARNING !
THIS WOOD HEATER HAS A MANUFACTURER-SET
MINIMUM LOW BURN RATE THAT MUST NOT BE
ALTERED. IT IS AGAINST FEDERAL REGULATIONS TO
ALTER THIS SETTING OR OTHERWISE OPERATE THIS
WOOD HEATER IN A MANNER INCONSISTENT WITH
OPERATING INSTRUCTIONS IN THIS MANUAL.
THE JØTUL F CB IS NOT APPROVED FOR USE IN 602
MOBILE HOMES.


Produkt Specifikationer

Mærke: Jøtul
Kategori: Ikke kategoriseret
Model: F 602 CB

Har du brug for hjælp?

Hvis du har brug for hjælp til Jøtul F 602 CB stil et spørgsmål nedenfor, og andre brugere vil svare dig