JUNG RAD ES 2928 Manual

JUNG Radio RAD ES 2928

Læs nedenfor 📖 manual på dansk for JUNG RAD ES 2928 (3 sider) i kategorien Radio. Denne guide var nyttig for 18 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/3
Flush-mounted radio with
display RAD...
Device descripon
The Jung ush-mounted radio RAD… consists
of a display cover and a ush-mounted
power supply unit.
The display cover is used for display and
operaon. All the sengs are made using
the sensor buons. The display shows the 8
staon informaon from RDS, the me and
the current sengs.
The radio power supply unit contains the
connecons for the mains voltage, inputs
and the loudspeaker.
The radio can be operated with one or two
LSM... loudspeaker modules.
The extension input allows the radio to be
switched on or o, e.g. together with the
light.
The radio signal is obtained from the
connecon to the mains voltage. In
situaons where recepon is dicult, the
oponal cord aerial can be used.
Other audio sources can be played back
using an AUX input, e.g. using the music
centre MC..100… .
Safety information
Electrical equipment must only be installed
and assembled by qualied electricians.
Failure to comply with these instrucons
may result in damage to the device, re or
other hazards.
This product is only intended for use in dry
rooms.
These instrucons are a component part of
the product and must remain with the end
customer.
Operaon
The lower half of the cover is used for
operaon. All operaon is carried out using
8 sensor buons.
When idle, the buons and display may be
hidden, depending on the sengs.
They are reacvated when the sensor
buons are touched again.
Switch-on / Switch-o
The radio is switched on and o
here.
If the buon is pressed for 3 seconds when
the system is switched on, then the sleep
mer (fall asleep funcon) can be acvated.
Sengs
Basic conguraon of brightnesses,
alarm me, and much more.
Alarm funcons
The alarm, which has a gradually
increasing volume, is switched on
and o here.
If the buon is pressed for longer than
3 seconds, this opens the menu for seng
the alarm me.
Favourites
Preferred staons can be saved to
the Favourites or the AUX input
selected.
Operang buons
Staon search, volume seng and the
navigaon/
seng in the menu.
Brightness of display during standby
adjusts the brightness for the
standby state.
The lowest level is Night mode.
Night mode
In Night mode, the display is switched o
completely as standby.
Pressing any buon brings the display back
from Night mode.
Main menu
Aer switch-on, the staon informaon and
status line are shown in the display.
The status line provides informaon on the
selected favourites, me and alarm
operaon.
When idle, this informaon is reduced to the
me and date.
Staon selecon
The next staon is selected using the
buons.
RDS (Radio Data System)
During operaon, the display shows the
staon name and, in some cases, addional
informaon, e.g. on the current song.
If this informaon is not available, then
frequency informaon on the selected radio
staon is displayed.
Adjusng the volume
The volume is adjusted using .
Favourites
Briey pressing the buon selects the
saved favourites or the AUX input.
Cancel Select -/+ Conrm
In radio operaon, a long press of the
buon (> 3 s) adds the current staon to the
Favourites list.
Up to 8 favourites are possible.
Sengs
The submenus can be found using the
buon. The menu is operated with the
sensor buons below.
Cancel Select -/+ Conrm
Here you can select one of the following 8
submenus with the +/- buons.
With the buon you get into the
selected submenu to change required
sengs.
AUX input
When the AUX input is acvated, radio
recepon is terminated and playback comes
from the external source. If the input is
deacvated again, radio operaon will
recommence.
Alarm me
The set alarm me starts the radio with an
increasing volume.
The display and buons are previously
illuminated at full brightness.
The buons terminate any further
increase in volume.
The buon switches the alarm o.
The buon switches the funcon on and
o.
Sleepmer (Fall asleep funcon)
The Sleepmer (fall asleep funcon)
switches the radio o automacally aer
the selected period of me.
The countdown is displayed in the status
line.
Buon brightness
The brightness and switch-o behaviour of
the buons can be varied.
On switching-o, the informaon in the
display is reduced to the display of staon
name and the me.
If the system is operated again, the buons
become brighter again.
Brightness of operaonal display
The display brightness can be reduced.
Loudspeaker
During operaon, the radio switches
between stereo and mono operaon
automacally. If recepon condions are
variable, it may be wise to select connuous
mono operaon. This allows two dierent
areas to be lled with sound.
Time
Normally, the recepon of an RDS staon is
sucient to perform this seng
automacally. However, the current me
can also be set manually.
Default seng
The state as delivered is restored. In so
doing, the 8 strongest staons are saved
automacally.


Produkt Specifikationer

Mærke: JUNG
Kategori: Radio
Model: RAD ES 2928

Har du brug for hjælp?

Hvis du har brug for hjælp til JUNG RAD ES 2928 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Radio JUNG Manualer

JUNG

JUNG DAB ES1 Manual

5 Maj 2024
JUNG

JUNG DABCD1BTWW Manual

26 Marts 2024
JUNG

JUNG RAD A 518 SW Manual

12 Marts 2024
JUNG

JUNG R AN AS M 514 WW Manual

31 December 2023
JUNG

JUNG DABCD2BTWW Manual

19 December 2023
JUNG

JUNG RADCD508 Manual

19 December 2023
JUNG

JUNG DABAL2BT Manual

29 November 2023
JUNG

JUNG DAB ES2 Manual

3 Oktober 2023
JUNG

JUNG RADES2918 Manual

20 September 2023
JUNG

JUNG RADCD528 Manual

18 September 2023

Radio Manualer

Nyeste Radio Manualer