GENERAL
GENERAL
GENERAL
GENERAL GENERAL
Carefully read the following important information regarding installation, safety and
maintenance. Keep this information booklet accessible for further consultations.
The appliance has been designed with two venting options: exhausting version (external exhaust)
or filter version (internal air recycle) cooker hood.
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS SAFETY PRECAUTIONS
Take care when the cooker hood is operating simultaneously with an open fireplace or
burner as they depend on the air in the environment and the cooker hood removes the
air from the environment.
The negative pressure in the environment must not exceed 4 Pa (4×10 –5 bar).
Provide adequate ventilation in the environment for a safe operation of the cooker
Follow the local laws applicable for external air evacuation.
WARNING!!
WARNING!!
WARNING!!
WARNING!! WARNING!!
In certain circumstances electrical appliance may be a danger hazard.
• There must be adequate ventilation in the room when the cooker hood is
used at the same time as appliances burning gas or other fuels.
• Do not check the status of the filters while the cooker hood is operating.
• Do not touch the light bulb within half an hour after appliance use.
• Do not ambé under the cooker hood.
• Avoid opening gasometer when there is no pan on the stove , as it is
damaging for the filters and a fire hazard
• Constantly check frying food to avoid overheated oil becoming a fire hazard
• Disconnect the electrical plug prior to any maintenance.
INST
INST
INST
INSTINSTALLA
ALLA
ALLA
ALLAALLATION INSTRUCTIONS
TION INSTRUCTIONS
TION INSTRUCTIONS
TION INSTRUCTIONS TION INSTRUCTIONS
• This cooker hood is designed for permanent fixture.
• Connect to mains supply. Check voltage and frequency given on the rating plate located on the
inside of the hood. Connect the mains cable to a power socket or to a omnipolar switch with a
contact gap of at least 3mm. The mains cable must be connected to a suitable and easily
accessible fixed power point. As the electrical installation must comply with the laws and
regulations in force only a qualified and authorized electrican must install the hood including
connecting it to a omnipolar switch with a contact gap of at least 3mm.
• Connect the mains cable if provided with a plug to a power socket. The user must have access
to the power socket to be able to connect and disconnect the plug once the hood is mounted
