Kelvinator KI130CF2 Manual

Kelvinator Fryser KI130CF2

Læs gratis den danske manual til Kelvinator KI130CF2 (8 sider) i kategorien Fryser. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 9 anmeldelser. Har du et spørgsmål om Kelvinator KI130CF2, eller vil du spørge andre brugere om produktet?

Side 1/8
Instruction Manual
Chest Freezer
MODEL: KI130CF2
INSTALLATION INSTRUCTIONS
Before Using Your Freezer
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
Storage Basket
Divider
Instruction Manual
Plastic Scraper
Before connecting the freezer to the power source, let it stand upright for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Freezer
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
Allow 15 cm of space between the back and sides of the freezer, which allows the proper air circulation.
Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the freezer not to perform properly.
Avoid locating the freezer in moist areas.
Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before placing
food in the freezer compartment.
OPERATING YOUR FREEZER
Temperature Control
Your freezer has one control for regulating the temperature. The temperature control is located on the
lower right hand corner.
The rst time you turn the unit on, switch on the Fast Freeze switch and run for at least 2 hours before
putting frozen foods inside. This will ensure the cabinet is thoroughly chilled before food is put in.
rn off the Fast Freeze switch. Tu
The range of the temperature control is from position" 1" the warmest to "6" the coldest. Adjust the
temperature control to the setting that best suits your needs. The setting of “4” should be appropriate for
home or office freezer use.
To turn the freezer off, turn the temperature control to "OFF".
NOTE:
Turning the temperature control to "OFF " position stops the cooling cycle but does not shut off the
power to the freezer.
If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before restarting the unit.
If you attempt to restart before this time delay, the freezer will not start.
Large amounts of food will lower the cooling efficiency of the appliance.
If you choose to change the thermostat setting, adjust thermostat control by one numerical increment at
a time. Allow several hours for temperature to stabilize between adjustments.


Produkt Specifikationer

Mærke: Kelvinator
Kategori: Fryser
Model: KI130CF2

Har du brug for hjælp?

Hvis du har brug for hjælp til Kelvinator KI130CF2 stil et spørgsmål nedenfor, og andre brugere vil svare dig