Kenwood TKR-750 Manual

Kenwood Radiokommunikation TKR-750

Læs gratis den danske manual til Kenwood TKR-750 (2 sider) i kategorien Radiokommunikation. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 12 anmeldelser. Har du et spørgsmål om Kenwood TKR-750, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

INSTALLATION

To install the handles onto the front panel of the repeater,

align the handles with the holes on the front panel, then

secure the handles using the supplied screws.

Please consult your dealer for installing the repeater and

antenna.

MICROPHONE

Connect an optional KMC-30 (E type only), KMC-27A,

KMC-27B, or KMC-9C KENWOOD microphone to the

MIC jack on the front panel.

VHF FM REPEATER/ UHF FM REPEATER

TKR-750/ TKR-850

INSTRUCTION MANUAL

KENWOOD CORPORATION

09 08 07 06 05 04 03 02

NOTICES TO THE USER

UNPACKING AND CHECKING EQUIPMENT

Note:

The following unpacking information is for use by your

KENWOOD

dealer, an authorized

KENWOOD

service facility, or the factory.

Carefully unpack the repeater. We recommend that you

identify the items listed in the following table before

discarding the packing material. If any items are missing

or have been damaged during shipment, file a claim with

the carrier immediately.

FCC WARNING

This equipment generates or uses radio frequency energy. Changes or

modifications to this equipment may cause harmful interference unless

the modifications are expressly approved in the instruction manual. The

user could lose the authority to operate this equipment if an unauthorized

change or modification is made.

◆

GOVERNMENT LAW PROHIBITS THE OPERATION OF

UNLICENSED RADIO TRANSMITTERS WITHIN THE

TERRITORIES UNDER GOVERNMENT CONTROL.

◆

ILLEGAL OPERATION IS PUNISHABLE BY FINE OR

IMPRISONMENT OR BOTH.

◆

REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.

metI rebmuNtraP ytitnauQ

erutxiferawdraH4X-2048-12J1

ssalgtnorF4X-5362-01B1

retliF4X-9521-11B1

noihsuC4X-1081-31G4

noihsuC4X-2081-31G4

tooF5X-5740-20J2

tooF4X-2940-20J2

temmorG5X-2030-95J2

eldnaH5X-8140-10K1

swercS54-6003-53N5

drocCD5X-7243-03E1

elbacrotcennoC5X-8223-13E1

esuF5X-7351-50F1

)ylnoepytK(dracytnarraW—1

launamnoitcurtsnIXX-7231-26B1

THANK YOU!

We are grateful you purchased this KENWOOD repeater.

We believe this easy-to-program repeater will be highly

effective in your communications system, and will keep

personnel operating at peak efficiency.

KENWOOD incorporates the latest in advanced technol-

ogy into all of our products. As a result, we feel strongly

that you will be pleased with the quality and features of

this product.

FEATURES

•You can easily program channel data using the KPG-66D

software on a PC.

•You can recall 1 of 16 preset channels using either a PF key

or the external control line.

•The firmware can be written to the Flash memory through

an external source.

•QT/DQT signalling can be programmed on each channel. It

simultaneously decodes up to 16 different QT/DQT tones.

•The interface port can be used with external equipment,

such as a repeater controller.

•The repeater has multi-mode capability.

Wide: 30 kHz/ Narrow:15 kHz (TKR-750; K type only)

Wide: 25 kHz/ Narrow:12.5 kHz (TKR-750/ TKR-850)

•You can adjust the following functions from a PC:

•Squelch

•RX audio signal output (RA)

•RX detector signal output (RD)

•RX frequency

•RF output power

•Maximum deviation

•TX audio input (TA)

•Signalling deviation (TD)

•DQT balance

•QT deviation

•DQT deviation

•Test tone deviation

•CW ID deviation

•Repeat gain

•TX frequency

PRECAUTIONS

•Do not expose the unit to rain or moisture; to prevent fire or

electric shock.

•Do not open the unit under any circumstances; to avoid risk

of electric shock.

•Do not expose the unit to long periods of direct sunlight, nor

place it close to heating appliances.

•Do not place the unit in excessively dusty and/or humid

areas, nor on unstable surfaces.

•If you detect an abnormal odor or smoke coming from the

unit, disconnect the power from the unit immediately.

Contact your KENWOOD service center or dealer.

REPEATER OPERATION

Note:

Please consult your dealer for programming the repeater.

When power is applied to the unit, the Power indicator

lights:

•Green when using the main DC jack.

•Red when using the Backup terminal.

Rotate the VOLUME control to adjust the volume.

The BUSY indicator lights green while receiving a signal

and the TX indicator lights red while transmitting.

qSpeaker

wCH/STATUS Display

Two, 7-segment digits display the channel number

or status.

eVOLUME control

Rotate to adjust the volume.

rDC SOURCE switch

tPower indicator

Lights green when power is applied from the DC

13.6V jack (DC 13.2V jack on E type versions).

Lights red when power is applied from the BACK

UP battery terminal.

yMIC jack

Connect a microphone to this 8-pin modular jack.

uProgrammable Function keys

Press these keys to activate their programmable

functions.

iBUSY indicator

Lights green while a signal is being received.

oTX indicator

Lights red while transmitting.

■Rear Panel

qTX OUT jack

Connect a TX antenna or a duplexer to this recep-

tacle.

wCONTROL I/O jack

Connect an external programming device or re-

peater controller to this DB-25 interface.

eFUSE

Insert 15 A blade fuses into these fuse holders.

rRX IN jack

Connect a RX antenna or a duplexer to this BNC

receptacle.

tDC 13.6V (K type) / DC 13.2V (E type) jack

Connect a 13.6 V (K type) or 13.2 V (E type) DC

power supply to this jack.

yBACKUP battery terminal

uTEST/SPKR jack

Test input/output jack. Connect an external

speaker to this jack.

TRANSCEIVER OPERATION

■Receive

Adjust the volume to your desired level. You may need

to readjust the volume when you receive a message

from your dispatcher or another member in your fleet.

• The BUSY indicator lights green while a signal is

being received.

■Transmit

1Listen to the channel before transmitting, to make

sure it is not being used.

2Press the microphone PTT switch, then speak in

your normal speaking voice.

•FCC regulations require that you identify the

station you are calling as well as your own

station (your assigned call sign).

• The TX indicator lights red while transmitting.

3When you finish speaking, release the PTT switch.

CONTROLS AND FUNCTIONS

■Front Panel

qww

wrr

rtt

qww

wrr

* The K type model is

shown in this diagram.

Produkt Specifikationer

Mærke:	Kenwood
Kategori:	Radiokommunikation
Model:	TKR-750

Har du brug for hjælp?

Hvis du har brug for hjælp til Kenwood TKR-750 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Radiokommunikation Kenwood Manualer

Kenwood NX-3320 Manual

8 Juli 2024

Kenwood TH-K40E Manual

8 Juli 2024

Kenwood TK-3401D Manual

6 Juli 2024

Kenwood TM-D710GA Manual

6 Juli 2024

Kenwood TK-2160 Manual

6 Juli 2024

Kenwood TK-7360 Manual

5 Juli 2024

Kenwood NXR-800 Manual

5 Juli 2024

Kenwood NX-1300-E2 Manual

5 Juli 2024

Kenwood TK3202E Manual

5 Juli 2024

Kenwood TK-2400 Manual

5 Juli 2024

Radiokommunikation Manualer

Nyeste Radiokommunikation Manualer

President Harry III Manual

15 Januar 2025

President Johnson Manual

15 Januar 2025

President MPB-12000 Manual

15 Januar 2025

President Jackson II Manual

14 Januar 2025

President Jimmy Manual

14 Januar 2025

President EMPEROR NINJA Manual

14 Januar 2025

President James Manual

14 Januar 2025

Rexon RM-03N Manual

20 September 2024

Simrad RS8400 Shipmate Manual

17 September 2024

Intek MT-5050 Manual

25 August 2024