Kicker SubStage SWRA411 Manual

Kicker Subwoofer SubStage SWRA411

Læs gratis den danske manual til Kicker SubStage SWRA411 (11 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om Kicker SubStage SWRA411, eller vil du spørge andre brugere om produktet?

Side 1/11
SWRA411 - ©2012 Stillwater Designs 9-27-12 Page 1 of 8
Designed for 2011 and newer Jeep Wrangler vehicles
SWRA411
T-TAP p1-x2
10MM BOLT
FUSE 25 AMP
WIRE TIES p1-x6
SUBWOOFER ASSEMBLY
200 WATT AMP
POWER HARNESS
OVERLAY HARNESS
SWRA411 - ©2012 Stillwater Designs 9-27-12 Page 2 of 8
Fig. 3
Fig. 1
Fig. 4
Fig. 5
A
A
A
AAm
m
m
mmp
p
p
pp
I
I
I
IIn
n
n
nns
s
s
sst
t
t
tta
a
a
aal
l
l
lll
l
l
lla
a
a
aat
t
t
tti
i
i
iio
o
o
oon
n
n
nn
1. Disconnect the negative battery cable.
2. Gently pull out on the panel just below the steering column, rotate down and remove. Fig. 1
3. Remove the two 7mm screws securing the plastic panel below the steering column indicated by the
arrow in Fig. 2 , and the one 7mm screw near the kick panel. Also, remove the two 10mm bolts
securing the metal plate and remove plate.
4. Remove the dash end panel by prying loose with a panel removal tool. Fig. 3
5. Install the amp into position by lining up the holes in the amp bracket with the two holes for the bolts
that retained the metal plate. Fig. 4
6. Install the supplied 10mm bolt into the bottom hole and leave loose. Fig. 5
7. Reinstall the metal plate over the top of the amp bracket and replace the factory bolts and tighten.
8. Tighten the bottom bolt.
Fig. 2


Produkt Specifikationer

Mærke: Kicker
Kategori: Subwoofer
Model: SubStage SWRA411

Har du brug for hjælp?

Hvis du har brug for hjælp til Kicker SubStage SWRA411 stil et spørgsmål nedenfor, og andre brugere vil svare dig