Korg GT-12 Manual

Korg DJ Gear GT-12

Læs gratis den danske manual til Korg GT-12 (9 sider) i kategorien DJ Gear. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Korg GT-12, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/9

Precautions

Location

Using the unit in the following locations can result in a malfunction.

• In direct sunlight

• Locations of extreme temperature or humidity

• Excessively dusty or dirty locations

• Locations of excessive vibration

Power supply

Please connect the designated AC adaptor to an AC outlet of the correct voltage. Do

not connect it to an AC outlet of voltage other than that for which your unit is

intended.

Interference with other electrical devices

This product contains a microcomputer. Radios and televisions placed nearby may

experience reception interference. Operate this unit at a suitable distance from

radios and televisions.

Handling

To avoid breakage, do not apply excessive force to the switches or controls.

Care

If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid

cleaners such as benzene or thinner, or cleaning compounds or flammable polishes.

Keep this manual

After reading this manual, please keep it for later reference.

Keeping foreign matter out of your equipment

• Never set any container with liquid in it near this equipment. If liquid gets into

the equipment, it could cause a breakdown, fire, or electrical shock.

• Be careful not to let metal objects get into the equipment. If something does slip

into the equipment, unplug the AC adaptor from the wall outlet. Then contact

your nearest Korg dealer or the store where the equipment was purchased.

CE mark for European Harmonized Standards

CE mark which is attached to our company’s products of AC mains operated

apparatus until December 31, 1996 means it conforms to EMC Directive (89/

336/EEC) and CE mark Directive (93/68/EEC). And, CE mark which is attached

after January 1, 1997 means it conforms to EMC Directive (89/336/EEC), CE

mark Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC).

Also, CE mark which is attached to our company’s products of Battery operated

apparatus means it conforms to EMC Directive (89/336/EEC) and CE mark

Directive (93/68/EEC).

THE FCC REGULATION WARNING (for U.S.A.)

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Unauthorized changes or modification to this system can void the user’s

authority to operate this equipment.

Owner's Manual

Parts of the GT-12

Power switch

( /ON/OFF )

[TUNING TYPE] dialLCD display Meter

[AUTO/MANUAL] switch

[SOUND] switch

[NOTE] switch

[FLAT] switch

Tuning guide

[CALIB] switch

INPUT jack

Built-in mic

OUTPUT jack

DC IN jack

(connect to AC adapter)

Tuning procedure

The GT-12 has two tuning modes: (auto/manual) in whichMeter mode

you tune while watching a meter, and Sound mode (manual) in which

you tune to an audible reference tone.

■

Meter mode

1. If you are using an instrument with a pickup (such as an electric

guitar) or a mic, connect the instrument or mic to the jack ofINPUT

the GT-12. (If you connect the GT-12's OUTPUT jack to your amp

etc., the sound will be output thru the tuner. During your perfor-

mance however, you may want to turn the GT-12 power switch

OFF to avoid noise.)

If a plug is inserted into the INPUT jack or OUTPUT jack, the built-in

mic cannot be used. Both jacks are mono. They cannot be used with

stereo plugs.

If you wish to tune your instrument using the built-in mic, do not

connect a plug to the INPUT jack or OUTPUT jack. In steps and 5 6,

place your instrument as close as possible to the built-in mic.

2. Turn the power switch to the ON or position. (At the position,

the power will be on, and in addition the display will be illumi-

nated.)

When the power is turned on, the previously-selected reference

pitch (default setting: A=440 Hz) will be selected, and the GT-12

will be in Meter mode (Auto)

3. If you wish to change the reference pitch (calibration), press the

[CALIB] switch. Each time you press it, the reference pitch will rise

1 Hz. If you continue holding it, the pitch will rise continuously.

The available range is 438 Hz–445 Hz.

4. Rotate the [TUNING TYPE] dial to select the appropriate instru-

ment or set to CHROMATIC.

Move the appropriate instrument name to the mark.

Each setting allows the following tuning. ( ): Default values for MANUAL

GUITAR : 6E, 5A, 4D, 3G, 2B, 1E (6E)

OPEN D : 6D, 5A, 4D, 3F, 2A, 1D (6D)

OPEN E : 6E, 5B, 4E, 3G , 2B, 1E (6E)

OPEN G : 6D, 5G, 4D, 3G, 2B, 1D (6D)

OPEN A : 6E, 5A, 4E, 3A, 2C , 1E (6E)

BASS : LB, 4E, 3A, 2D, 1G, HC (LB) LB: Low B, HC: High C

UKULELE : 4G, 3C, 2E, 1A (4G)

CHROMATIC:

C, C



, D, E



, E, F, F



, G, G



, A, B



, B

(A, sound output: A4)

5. Specify the note name.

When using AUTO

Play a single note on your instrument, and the name of the nearest

note will appear in the LCD display. Tune your instrument so that

the correct note name is shown in the LCD display.

When using MANUAL

Press the [NOTE] switch until the note you wish to tune (C–B)

appears in the LCD display.

• Each time you press the [AUTO/MANUAL] switch, the setting will

switch between AUTO and MANUAL.

Thank you for purchasing

the Korg GT-12 guitar/bass

chromatic tuner. Before you

use the GT-12, please read

this owner's manual care-

fully, and use the GT-12 as

directed. Keep this manual

for future reference.

J E F G

Produkt Specifikationer

Mærke:	Korg
Kategori:	DJ Gear
Model:	GT-12

Har du brug for hjælp?

Hvis du har brug for hjælp til Korg GT-12 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

DJ Gear Korg Manualer

Korg Rhythm Master Manual

11 December 2024

Korg PuttRhythm Manual

11 December 2024

7 Oktober 2024

27 September 2024

26 September 2024

23 September 2024

16 September 2024

1 September 2024

Korg Pitchblack X Pro Manual

31 August 2024

Korg KAOSS Replay Manual

28 August 2024

DJ Gear Manualer

Nyeste DJ Gear Manualer

Fuzzix MBR60 Manual

14 Marts 2025

UDG Gear AlphaTheta DDJ-GRV6 Manual

3 Marts 2025

Yamaha UX256 Manual

8 Februar 2025

Eliminator Lighting Event Facade II Manual

7 Februar 2025

Reloop RMX-30 BT Manual

7 Februar 2025

Headliner R4 Manual

30 Januar 2025

Arturia BeatStep Manual

11 Januar 2025

Line 6 Helix Control Manual

11 Januar 2025

Glorious Record Box 55 Manual

5 Januar 2025

Glorious Record Box Display Door Manual

5 Januar 2025