La Germania AMS9IND 61 B X Manual

La Germania Ovn AMS9IND 61 B X

Læs gratis den danske manual til La Germania AMS9IND 61 B X (48 sider) i kategorien Ovn. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om La Germania AMS9IND 61 B X, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/48
1
INSTALLATION, MAINTENANCE
AND USE INSTRUCTIONS
FOR COOKERS
Pag.2
90x60 cm (TYPE M9/M9V)
NOTICE D’INSTALLATION, D’ENTRETIEN
ET MODE D’EMPLOI DE LA CUISINIERE A GAZ
page 14
90x60cm (MODELE M9/ M9V)
code 310504
2
PLEASE READ THE INSTRUCTIONS BOOKLET BEFORE INSTALLING AND USING THE APPLIANCE.
These instructions are only for those countries whose symbols appear on the front of the booklet
and on the serial no. plate of the appliance.
The manufacturer may not be held liable for any damage to objects or people, resulting from the
improper or erroneous installation of the appliance.
The manufacturer is not responsible for any inaccuracies, due to printing or typing errors, in this booklet.
The drawings (in the figures) are indicative only.
The manufacturer may make product modifications when considered necessary and useful, without this
changing essential safety and operating characteristics.
HEIGHT-ADJUSTABLE FEET (figure) 1)
The feet are packed in the top box.
The feet should be installed with the cooker close to its final installation position; the feet are not safe to
move the cooker long distances.
After unpacking the cooker, lift it with your foot, to fit the cooker feet in the bases at the bottom. Slowly lower
the cooker so its weight is resting on the feet and on the assembly fixings. We recommend using a lifting
device or pallet instead of tilting the cooker.
INSTALLING THE TOEKICK PANEL (only available for some models)
After installing the feet, install the cooker skirt as shown in the pictures in Figure 2. 2
INSTALLING THE (UPSTAND) RISER
Remove the 2 screws securing the hob at the rear, as shown in (figure 3)
Put the upstand in place and secure at the bottom with the two screws, as shown in (figure 3)
Secure the middle of the upstand using the screws provided with the upstand (figure 3)
INSTALLING THE HOB RAIL AND OVEN HANDLE
The rail and handle are packed with the upstand.
The rail is only available on some models.
Assemble the hob rail and oven handle as shown in the pictures (figures 4A – 4B- 4C)
CONNECTING THE APPLIANCE TO THE GAS MAINS
Before connecting the appliance to the gas mains, make sure the data on the rating plate affixed inside the
warming drawer or at the rear of the oven correspond to those of the gas mains.
A label on the last page of this booklet and inside the warming drawer (or at the rear) of the appliance
gives information for adjusting the appliance: type of gas and operating pressure.
IMPORTANT: this appliance must be installed in compliance with current national standards in force and
used only in a well-ventilated room.
NOTE: The gas union of the appliance has a ½ cylindrical male gas thread, conforming to UNI-ISO 228-1
standards.
To connect the appliance to the gas mains using a flexible rubber pipe, an additional rubber union is
required (Figure 6 ) supplied with the appliance, conforming to the UNI 7141 standard.
ADJUSTMENT FOR DIFFERENT TYPES OF GAS
BEFORE CARRYING OUT ANY MAINTENANCE, UNPLUG THE APPLIANCE FROM THE GAS AND
ELECTRICITY MAINS
REPLACING NOZZLES FOR OPERATION WITH ANOTHER TYPE OF GAS:
To change the hob burner nozzles, proceed as follows:
1. Unplug the appliance from the mains, to avoid all electrical contact.
2. Remove the pan supports from the hob (Figure 7).
3. Remove the burner heads (Figure 7).
4. Use a 7 mm tubular hex wrench to loosen the nozzles and replace them with those suitable for the new type of
gas (Figure 8) as indicated in table no. 1.
To change the oven burner nozzle proceed as follows:
1. Remove the hob by removing screws G (Figure 9) and then the hob.
2. Loosen screw and remove the burner from its housing, taking care to avoid damaging the spark ignition and V
thermocouple (Figure 10).
3. Use a 7 mm tubular hex wrench to replace nozzle R with a nozzle suitable for the new type of gas as indicated
in table no. 1.

Produkt Specifikationer

Mærke: La Germania
Kategori: Ovn
Model: AMS9IND 61 B X

Har du brug for hjælp?

Hvis du har brug for hjælp til La Germania AMS9IND 61 B X stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ovn La Germania Manualer

La Germania

La Germania F6011LAGPSNE Manual

24 Oktober 2024
La Germania

La Germania AMS96C71BCR Manual

24 Oktober 2024
La Germania

La Germania AMS96C61LBCR Manual

24 Oktober 2024
La Germania

La Germania F969LAGEKGN Manual

24 Oktober 2024
La Germania

La Germania AMS96C61LBVI Manual

24 Oktober 2024
La Germania

La Germania DA2MR Manual

30 August 2024
La Germania

La Germania DA2MX Manual

30 August 2024
La Germania

La Germania TUS96C71BX Manual

30 August 2024
La Germania

La Germania TUS96C61LBX Manual

30 August 2024
La Germania

La Germania TUS95L61LDX Manual

30 August 2024

Ovn Manualer

Nyeste Ovn Manualer

Schneider

Schneider SCEO2345CTB Manual

12 September 2025
Neff

Neff XED342 Manual

12 September 2025
Zanussi

Zanussi ZPCNA7XN Manual

12 September 2025
Whirlpool

Whirlpool AKP9 785 IX Manual

12 September 2025
Robinhood

Robinhood OBAC606D57SS Manual

12 September 2025
Robinhood

Robinhood RHBO65DX Manual

12 September 2025
BEKO

BEKO AeroPerfect BBIM18301XFPE Manual

12 September 2025
Haier

Haier H6 ID2P3T1HTB Manual

11 September 2025
Zanussi

Zanussi ZOHIQ3K2 Manual

11 September 2025
Infiniton

Infiniton CC-B550V3 Manual

11 September 2025