2 - Rubber waterproof gaskets - (1 pre-installed into device)
1 - Micro-USB charging cord
1 - Quick Start Guide (For Activation)
Original (Full) Tracking and Energy Saver Modes
The unit is automatically set on motion based tracking upon arrival. In this mode the unit
will track based on motion only, and enter a dormant sleep state when stationary. When the unit
is activated, and powered on we recommend taking it for a 10 - 15 minute drive to allow it to fully
connect with your account. The unit will begin tracking the movement based on the plan selected
upon activation. In the motion sensing Full/Original tracking mode the unit will enter its sleep
state after 2-3 minutes of motionlessness. During its period of sleep the unit is completely
dormant and will not discharge battery life.
In Energy Saver Mode (ESM), the unit's motion sensor is turned off and the unit is placed
onto a timer instead. The unit willThis will cause the unit to not update when it is in motion.
only wake up at the end of each cycle of time, attempt to register a new update, and then go back
To place the device into an ESM, navigate to the Energy Saver menu in the SilverCloud
mobile application. From this menu you will see the below options.
1. Update location every 30 minutes (10 to 15 day battery life)
2. Update location every 1 hour (15 to 30 day battery life)
3. Update location every 2 hours (1 to 1.5 month battery life)
4. Update location every 4 hours (1.5 to 2.5 month battery life)
5. Update location every 6 hours (2 to 3 month battery life)
6. Update location every 12 hours (3 to 4 month battery life)
7. Update location every 24 hours (4 to 6 month battery life)
8. Full or Original Tracking Mode (Your subscription rate)
*Please note the energy saver battery life projections are based on the device beginning
at 100% charged. Sending the energy saver commands force the unit to wakeWILL NOT
Upon selecting one of these options and sending the command to your unit, the next
update it registers the unit will receive the command and shift into the option you have selected.
This means, if your unit is currently in an ESM, it will not receive the command to adjust settings
until the end of the cycle it was set to. (i.e. If the unit is in 24 hour ESM, it will not receive any
new commands until the 24 hour cycle elapses and the unit wakes up again. If the unit is
in full/original tracking mode it will not enter ESM until it senses motion.)
