Liberty Pumps 230 Manual

Liberty Pumps Pomp 230

Læs gratis den danske manual til Liberty Pumps 230 (18 sider) i kategorien Pomp. Denne vejledning er vurderet som hjælpsom af 49 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 25 anmeldelser. Har du et spørgsmål om Liberty Pumps 230, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/18

*Do not throw away or lose this manual. Keep it with the installation and refer to it often.

Submersible Models 1/4 hp

-Series…Cast Iron 240

240 Manual

241 Wide Angle Float

243 Wide-Angle Float w/Series Plug

247 Vertical Float

Submersible Models 1/3 hp

230-Series…Poly/Aluminum

230 Manual

231 Wide Angle Float

233 Wide-Angle Float w/series plug

237 Vertical Float

Submersible Models 1/2 hp

450-Series…Poly/Aluminum

450 Manual

451 Wide Angle Float

453 Wide-Angle Float w/series plug

457 Vertical Float

Installation Manual 7108000I

For Submersible Sump Pumps

IMPORTANT:

Prior to installation, record Model, Serial Number, and Code

Number from pump nameplate for future reference.

MODEL ______________________

SERIAL ______________________

CODE ______________________

INSTALLATION

DATE ______________________

1. General Information – All Models

Before Installation, read the following instructions carefully. Each Liberty pump is individually factory tested to assure

proper performance. By closely following these instructions, potential operating problems should be eliminated,

providing years of trouble-free service.

 Risk of electric shock. Always disconnect the pump from the power source before handling or making adjustments.

 The electrical connections and wiring for a pump installation should only be made by qualified personnel.

 This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric

shock, be certain that it is connected only to a properly grounded, grounding-type receptacle.

 Always wear rubber boots when water is on the floor and you must unplug the pump.

 DO NOT bypass grounding wires or remove ground prong from attachment plugs.

 DO NOT use an extension cord.

 This pump requires a separate, properly fused and grounded branch circuit. Make sure the power source is properly

sized for the voltage and amperage requirements of the pump, as noted on the nameplate.

 The electrical outlet shall be within the length limitations of the pump power cord, and at least 4 feet above floor level

to minimize possible hazards from flood conditions.

 The installation must be in accordance with the National Electric Code, Uniform Plumbing Code, International

Plumbing Code, as well as all applicable local codes and ordinances.

 Sump and sewage pumps often handle materials which could cause illness or disease. Wear adequate protective

clothing when working on a used pump or piping.

 Never enter a pump basin after it has been used. Sewage and effluent can emit several gases which are poisonous.

 Keep clear of suction and discharge openings. To prevent injury, never insert fingers into pump while it is plugged in.

 DO NOT use this product for flammable or corrosive liquid.

 DO NOT use this product in applications where human contact with the pumped fluid is common (such as swimming

pools, fountains, etc.)

 NEVER dispose of materials such as paint thinner or other chemicals down drains, as they can chemically attack and

damage pump components, potentially causing product malfunction or failure.

 DO NOT use pumps in water over 140



F (60



C).

 DO NOT use pumps in mud, sand, cement, oil or chemicals.

 DO NOT modify the pump in any way.

 DO NOT lift or carry pump by power cord.

 DO NOT remove any tags from pump or cords.

 If pump is installed during construction before power is available, it must be protected from the environment to prevent

water from entering through the cord plug end, etc.

Tools Required:

- Pipe wrench

- Regular screw driver

- Hacksaw (For replacement or removal of existing rigid piping.)

Produkt Specifikationer

Mærke:	Liberty Pumps
Kategori:	Pomp
Model:	230

Har du brug for hjælp?

Hvis du har brug for hjælp til Liberty Pumps 230 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Pomp Liberty Pumps Manualer

Liberty Pumps 250 Manual

30 September 2024

Liberty Pumps 457 Manual

30 September 2024

Liberty Pumps 230 Manual

30 September 2024

Liberty Pumps CSP-257 Manual

30 September 2024

Liberty Pumps LE51A Manual

20 August 2024

Pomp Manualer

Nyeste Pomp Manualer

T.I.P. Clean Jet 800 Plus Manual

12 Januar 2025

JANDY JCP07-3AT-S Manual

11 Januar 2025

Güde INOX 100/24 Manual

11 Januar 2025

Vivaria Vario N-3000 Manual

11 Januar 2025

MSW -FM-N-53 Manual

4 Januar 2025

MSW -OP-56-DC Manual

4 Januar 2025

MSW -PUMP CLEAN 100 Manual

4 Januar 2025

Simpson SCP71008 Manual

2 Januar 2025

Testo 565i Manual

1 Januar 2025

Sauermann Delta Manual

1 Januar 2025