Package
ECP-01T (Transmitter)
ECP-01R (Receiver)
Quick Start
Guide
Hardware Overview
Right
Left
Top
상태 표시등
LINK
상태 표시등
ACT
RJ45PoE 스위치 ON/OFF
(ECP-01T 만 해당)
DC 전원 어댑터BNC 커넥터
제품 고정
나사용 홀
제품 고정
나사용 홀
Status LED Indicator
LINK
Status LED Indicator
ACT
DC Power JackBNC connector
PoE Switch ON/OF
(ECP-01T only)
Mounting
Screw Hole
Mounting
Screw Hole
Overview
ECP-01 Series are High-Speed, long distance Ethernet & PoE extender
that makes possible to transmit the Ethernet signal and PoE up to
400m through coaxial cables in different situations.
It is cost-effective and time saving solution to migrate existing
analog system to IP based system since ECP-01 series support easy
installation utilizing the existing coaxial cable.
With long distance transmission feature, the device makes to
overcome 100 meters distance limitation easily and reduces the
construction cost significantly compared with fiber optic configuration.
Features
Long reach Ethernet & PoE extension over existing coaxial cable
Data + Power over coaxial cable
Data distance up to 1000 m
100Mpbs Full Duplex
PoE, PoE+, Extra PoE (Max. 60W PoE output, ECP-01T model only
with DC Power adapter)
LED Indication (Data, Power)
Plug & Play
Support PoE, PoE+ Input (25.5W) from PoE Switch / PoE NVR
(ECP-01R model only)
Slim design
Quick Start Guide
ECP-01T / ECP-01R
Please read carefully the instruction manual before use.
Contents of this manual are subject to change without prior notice
for reasons such as functionality enhancements.
Installation Guide
1. Connect Ethernet cable (Cat5e or better) from PoE Switch/NVR to
ECP-01R. Check LEDs on ECP-01R.
Ethernet cable
(Cat5e or better)
Coaxial cable
(RG59 or better)
PoE Switch/NVR
Check LEDs
Ethernet cable
(Cat5e or better)
Check LEDs
2. Connect coaxial cable (RG59 or better) to ECP-01R.
Connect coaxial cable from ECP-01R to ECP-01T.
Ethernet cable
(Cat5e or better)
Coaxial cable
(RG59 or better)
PoE Switch/NVR
Check LEDs
Ethernet cable
(Cat5e or better)
Check LEDs
3. Connect Ethernet cable (Cat5e or better) from ECP-01T to IP
Camera (PoE Model Only). Check LEDs on ECP-01T.
Î
Set ECP-01T, PoE Switch ON to supply direct power to IP camera.
Set ECP-01T, PoE Switch OFF to connect PC or network switch
devices.
Ethernet cable
(Cat5e or better)
Coaxial cable
(RG59 or better)
PoE Switch/NVR
Check LEDs
Ethernet cable
(Cat5e or better)
Check LEDs
LED Indicators
Indicator Color Function
LINK
Ethernet Data Act
ACT
Ethernet Connect Act
Rev.6.7
