Lumens OIP-AC01 Manual


Læs gratis den danske manual til Lumens OIP-AC01 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Lumens OIP-AC01, eller vil du spørge andre brugere om produktet?

Side 1/2
www.MyLumens.com
Copyright © 2021 Lumens Digital Optics Inc. All rights reserved.
5100462- SEP. 2021 50
OIP-AC01 Quick Installation Guide
1. PACKAGE CONTENTS
6U Rack Chassis
Power Adapter
Power Connector
M5 Screw p1-x8
Cable Clip p1-x5
(Appearance may vary
depending on country/region
2. Power & System Requirements
Power Requirement: DC 12V, 3A power supply for the cooling fan system.
System Requirement:
The 6U rack chassis requires a minimum of 266.7mm (10.5in) contiguous
free space in the rack for mounting.
With the Cooling Fan System installed, an additional 1U space above the
chassis should be left empty to provide space for air to ow freely.
3. Installation Instructions
STEP 1
Install the OIP-AC01 to the rack with M5 Screws*8pcs.
STEP 2
Unscrew the 3 thumbscrews holding the top locking panel in place, and remove
the panel from the front of the chassis. Unscrew the 3 thumbscrews holding the
bottom locking panel in place, and remove the panel from the front of the
chassis.
Note: The thumbscrews are connected to the locking panels with a retention mechanism
and will not come completely free when they have been unscrewed from the chassis.
www.MyLumens.com
Copyright © 2021 Lumens Digital Optics Inc. All rights reserved.
STEP 3
Align and then carefully slide a full or half-length compatible audio/video unit into
the top/bottom grooves of a free slot. Half-length units are designed with a notch
to prevent them from sliding all the way to the back of the rack chassis. Repeat
this step until all units have been installed.
Note: If fewer than 15 units are being mounted it is strongly suggested to leave empty
space between units that get particularly warm to improve airow dissipation.and heat
STEP 4
Reattach the top and bottom locking panels by screwing in the 3 thumbscrews on each
until they are tight and . secure
Note: Be careful to not overtighten the thumbscrews as this could damage the screw
threads.
STEP 5
Connect DC 12V, 3A supply to the cooling fan system power


Produkt Specifikationer

Mærke: Lumens
Kategori: Ikke kategoriseret
Model: OIP-AC01

Har du brug for hjælp?

Hvis du har brug for hjælp til Lumens OIP-AC01 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Lumens Manualer

Lumens

Lumens VC-WM15 Manual

10 Juli 2025
Lumens

Lumens LC-RC01 Manual

3 Juli 2025
Lumens

Lumens VC-TR61 Manual

2 Juli 2025
Lumens

Lumens OIP-AC01 Manual

10 Marts 2025
Lumens

Lumens OIP-D50E Manual

5 September 2024
Lumens

Lumens CamConnect Pro Manual

5 September 2024
Lumens

Lumens OIP-N60D Manual

5 September 2024
Lumens

Lumens DC132U Manual

3 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer