Majestic SCCMPPT20 Manual

Majestic Ikke kategoriseret SCCMPPT20

Læs gratis den danske manual til Majestic SCCMPPT20 (28 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Majestic SCCMPPT20, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/28

Dear users,

Thank you for choosing our product!

Safety Instructions

1. As this controller deals with voltages that exceed the top limit for human safety, do not

operate it before reading this manual carefully and completing safety operation training.

2. The controller has no internal components that need maintenance or service, thus do

not attempt to disassemble or repair the controller.

3. Install the controller indoors, and avoid component exposure and water intrusion.

4. During operation, the heatsink may reach a very high temperature, therefore install the

controller at a place with good ventilation conditions.

5. It's recommended that a fuse or circuit breaker be installed outside the controller.

6. Before installing and wiring the controller, make sure to disconnect the photovoltaic

array and the fuse or breaker close to the battery terminals.

7. After installation, check if all connections are solid and reliable so as to avoid loose

connections that may give rise to dangers caused by heat accumulation.

Warning: means the operation in question is dangerous, and you

should get properly prepared before proceeding.

Note: means the operation in question may cause damage.

Tips: means advice or instruction for the operator.

Table of Contents

1. Product Introduction ................................................................................................................ 4

1.1 Product Overview ............................................................................................................ 4

1.2 Product Features .............................................................................................................. 4

1.3 Exterior and Interfaces ..................................................................................................... 6

1.4 Introduction to Maximum Power Point Tracking Technology ........................................ 7

1.5 Charging Stages Introduction ........................................................................................ 10

2. Product Installation ................................................................................................................ 13

2.1 Installation Precautions .................................................................................................. 13

2.2 Wiring Specications ..................................................................................................... 14

2.3 Installation and Wiring .................................................................................................. 15

3. Product Operation and Display .............................................................................................. 19

3.1 LED Indicators ............................................................................................................... 19

3.2 Key Operations .............................................................................................................. 21

3.3 LCD Startup and Main Interface ................................................................................... 22

3.4 Load Mode Setting Interface ......................................................................................... 23

3.5 System Parameter Settings ............................................................................................ 24

4. Product Protection Function and System Maintenance ......................................................... 26

4.1 Protection Functions ...................................................................................................... 26

4.2 System Maintenance ...................................................................................................... 27

4.3 Abnormality Display and Warnings ............................................................................... 28

5. Product Specication Parameters .......................................................................................... 29

5.1 Electric Parameters ........................................................................................................ 29

5.2 Battery Type Default Parameters (parameters set in monitor software) ....................... 30

Produkt Specifikationer

Mærke:	Majestic
Kategori:	Ikke kategoriseret
Model:	SCCMPPT20

Har du brug for hjælp?

Hvis du har brug for hjælp til Majestic SCCMPPT20 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Majestic Manualer

Majestic TT 53 Manual

2 September 2024

Majestic SCCMPPT40 Manual

29 August 2024

Majestic SCCMPPT20 Manual

29 August 2024

Majestic ARM2502B Manual

28 August 2024

Majestic AD200 Manual

28 August 2024

Majestic BKT100 Manual

28 August 2024

Majestic ARM2601 Manual

28 August 2024

Majestic ARM102 Manual

28 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Navman MY500XT Manual

1 August 2025

Navman FOCUS150 GPS Manual

1 August 2025

Scheppach TW1000 Manual

1 August 2025

Navman MiVue 750 WIFI Manual

1 August 2025

Navman MiVue Drive FHD Manual

1 August 2025

Midea MEC64 Manual

1 August 2025

Navman MY50T Manual

1 August 2025

Navman M100 Manual

1 August 2025

Navman MiVue 770 SAFETY Manual

1 August 2025

Navman MiVue 790 Manual

1 August 2025