2
ENGLISH (Original instructions)
SPECIFICATIONS
Model DTW250 DTW251
Standard bolt M10 - M16 M10 - M16
Capacities High tensile bolt M10 - M14 M10 - M14
Square drive 12.7 mm 12.7 mm
No load speed (min-1) 0 - 2,200 0 - 2,100
Impacts per minute 0 - 3,200 0 - 3,200
Max. fastening torque 230 N.m 230 N.m
Overall length 165 mm 165 mm
Net weight 1.6 kg 1.5 kg
Rated voltage D.C.14.4 V D.C.18 V
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
END004-4
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ Only for EU countries
Do not dispose of electric equipment or
battery pack together with household
waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment, 2006/66/EC on
batteries and accumulators and waste
batteries and accumulators and their
implementation in accordance with
national laws, electric equipment and
battery pack that have reached the end
of their life must be collected separately
and returned to an environmentally
compatible recycling facility.
ENE036-1
Intended use
The tool is intended for fastening bolts and nuts.
ENG905-1
Noise
The typical A-weighted noise level determined according
to EN60745:
Model DTW250
Sound pressure level (L
pA) : 90 dB (A)
Sound power level (L
WA) : 101 dB (A)
Uncertainty (K) : 3 dB (A)
Model DTW251
Sound pressure level (L
pA) : 94 dB (A)
Sound power level (L
WA) : 105 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model DTW250
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (ah) : 14.5 m/s2
Uncertainty (K) : 1.5 m/s2
Model DTW251
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (ah) : 11.0 m/s2
Uncertainty (K) : 1.5 m/s2
ENG901-1
• The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
•
The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Cd
Ni-MH
Li-ion
