Marshall VAC-12SH Manual

Marshall Ikke kategoriseret VAC-12SH

Læs gratis den danske manual til Marshall VAC-12SH (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Marshall VAC-12SH, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
INTRODUCTION
FEATURES
•Supported high-definition (HD) formats:
NTSC 525@59.94, PAL 625@50, 720p@50,720p@59.94, 720p@60,
1080i@50, 1080i@59.94, 1080i@60, 1080p@23.97,1080p@24,
1080p@25, 1080p@29.97, 1080p@30, 1080p@50,
1080p@59.94,1080p@60
•Bit Rate: 2.97Gbps, 2.967Gbps, 1.485Gbps, 1.4835Gbps, 270 Mbps
•Auto 3G/HD/SD-SDI detection
•Support HDMI Deep Color
The VAC-12SH 3G/HD/SD-SDI to HDMI Converter with Loop-out provides a
cost-effective way to convert 3G/HD/SD-SDI signal to an HDMI compliant format.
The conversion between SDI and HDMI is purely digital and guarantees no loss of
audio and video signal. Audio is supported.
* The VAC-12SH also provides two (SDI and HDMI) low jitter, re-clocked outputs
for daisy chains or multiple monitors.
*SDI supports 48KHz. Dolby True HD and DTS HD are not supported in SDI.
1910 East Maple Ave. El Segundo, CA 90245
Tel: (800) 800-6608 • (310) 333-0606
• Fax: 310-333-0688
www.LCDracks.com
support@marshall-usa.com
Marshall Electronics
36
PANEL DESCRIPTION
Marshall Electronics
User Manual
VAC-12SH
Device with HDMI Input
Camera
HDMI Cable
Front
Rear
Digital SDI Cable Digital SDI Cable
HDMI OUT
PO WE R
SI GN AL
Device with SDI Inputs
+ 5V DC
SDI OUT
SDI IN
REAR PANEL
FRONT PANEL
1. SDI IN: 3G/HD/SD-SDI Input
2. SDI OUT: 3G/HD/SD-SDI output
3. Signal LED:
<Green> Both power and signal are active.
<Red> Only power is active.
4. HDMI OUT: Connect to a HDMI display with a HDMI male-male cable here.
5. +5V DC: Connect to a 5V DC power supply included.
SDI standards 3G-SDI & HD-SDI & SD-SDI
Auto HD/SD-SDI detection Yes
SDI Data Rate [2.97Gpbs & 2.975/1.001Gbps]
Video support
[3G] - 1080p50/59.94/60 (4:2:2)
[HD] - 720p @50/59.94/60Hz,1080i
@50/59.94/60Hz,1080p
@23.98/24/25/29.97/30Hz
[SD] - NTSC @59.94Hz, PAL @50Hz
Input signal
[SD-SDI] SMPTE 259M
[HD-SDI] SMPTE 292M, 296M
[3G-SDI] SMPTE-424M
Output signal 1x SDI + 1x HDMI
Output impedance 75 ohms
Eye pattern characteristics Extra low alignment jitter 0.05UI at HD
Cable equalization
[3G-SDI] up to 90m (300ft)
[HD-SDI] up to 150m (500ft)
[SD-SDI] up to 300m (1000ft)
Audio support Yes
Input 1x BNC [SDI]
Output 1x HDMI + 1x BNC [SDI]
BNC connector 75 ohm inter-locked socket
HDMI connector Type A [19-pin female]
Housing Metal enclosure
Dimensions [L x W x H] 79 x 84 x 27mm [3.1” x 3.3” x 1.2”]
Weight
Model [TX] – 250g [8.8oz]
Package 780g [1.7 lbs]
Power supply 5V 2A DC with locking power connector
Power consumption 3 Watts [max]
Operation temperature 0~40°C [32~104°F]
Storage temperature -20~60°C [-4~140°F]
Relative humidity 20~90% RH [no condensation]
SAFETY & NOTICE
PACKAGE CONTENTS
SUPPORTED RESOLUTIONS
TABLE OF CONTENTS
INTRODUCTION
FEATURES
PACKAGE CONTENTS
SUPPORTED RESOLUTIONS
DIP SWITCH
SPECIFICATIONS
PANEL DESCRIPTIONS
WARRANTY
3
3
4
4
4
5
6
7
LIMITED WARRANTY
SPECIFICATIONS
For Warranty information please refer to Marshall website page:
https://marshall-usa.com/company/warranty.php
72
54
•VAC-12SH Converter
•5V/2A power adapter
•User Manual
TECHNICAL
M e c h a n i c a l
The VAC-12SH 3G/HD/SD-SDI to HDMI Converter has been tested
for conformance to safety regulations and requirements, and has
been certified for international use. However, like all electronic
equipment, the VAC-12SH should be used with care. Please read
and follow the safety instructions to protect yourself from possible
injury and to minimize the risk of damage to the unit.
•Follow all instructions and warnings marked on this unit.
•Do not attempt to service this unit yourself, except where explained in
`this manual.
•Provide proper ventilation and air circulation. Do not use near water.
•Keep away from objects that might damage the device. Assure that the
placement of this unit is on a stable surface.
•Use only the power adapter, power cords and connection cables
designed for this unit.
•Do not use liquid or aerosol cleaners to clean this unit. Always unplug
the power to the device before cleaning.
3G-SDI Output
SD-S D I OU T PUT
1080p @ 50/ 59.94 / 60Hz SMPTE 424M, SMPTE 425M
HD-SDI Output
720p @ 50Hz SMPTE 296M -3
720p @ 60 / 59.94Hz SMPTE 296M -1, -2
1080i @ 50Hz SMPTE 274M -6
1080i @ 60 / 59.94Hz SMPTE 274M -4, -5
1080p @ 24 / 23.98Hz SMPTE 274M -10, -11
1080p @ 25Hz SMPTE 274M -9
1080p @ 30 / 29.97Hz SMPTE 274M -7, -8
NTSC
PAL B,D,G,H,I

Produkt Specifikationer

Mærke: Marshall
Kategori: Ikke kategoriseret
Model: VAC-12SH

Har du brug for hjælp?

Hvis du har brug for hjælp til Marshall VAC-12SH stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Marshall Manualer

Marshall

Marshall CV228 Manual

16 Juni 2025
Marshall

Marshall CV355-30X-NDI Manual

15 Juni 2025
Marshall

Marshall RCP-PLUS Manual

15 Juni 2025
Marshall

Marshall VSC-100 Manual

15 Juni 2025
Marshall

Marshall CV574 Manual

15 Juni 2025
Marshall

Marshall AR-DM51-B Manual

14 Juni 2025
Marshall

Marshall AR-AM4-BG-2 Manual

14 Juni 2025
Marshall

Marshall CV-H20-HF Manual

14 Juni 2025
Marshall

Marshall VAC-12SH Manual

14 Juni 2025
Marshall

Marshall AR-DM61-BT Manual

14 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Festo

Festo DFM-32-100-B-PPV-A-KF Manual

17 Juni 2025
Playtive

Playtive IAN 285777 Manual

17 Juni 2025
Festo

Festo VAEM-L1-S-M3-26 Manual

17 Juni 2025
Festo

Festo DFPC-320 Manual

17 Juni 2025
EFX

EFX ICAK12 Manual

17 Juni 2025
Bearware

Bearware 307294 Manual

17 Juni 2025
Futaba

Futaba MC-9200H/A Manual

17 Juni 2025
Hansgrohe

Hansgrohe AXOR Montreux 16517800 Manual

17 Juni 2025
OmniMount

OmniMount 2N1-S Manual

17 Juni 2025
Festo

Festo DSNU-S-12- -F1A Manual

17 Juni 2025