Martin Logan Monolith II Manual


Læs gratis den danske manual til Martin Logan Monolith II (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 18 anmeldelser. Har du et spørgsmål om Martin Logan Monolith II, eller vil du spørge andre brugere om produktet?

Side 1/3
MO N O L I T H I & II
W a r n i n g !
The Monoliths are not designed to be bi-wired.
The internal crossover network of the Monolith is a 6dB per
octave, phase coherent network and as such, it can not be
bi-wired properly!
If you attempt to bi-wire the speaker with the “HI” and
“LOW” inputs you will be by-passing the internal crossover.
This could do serious damage to the electrostatic panel
interface device, as it is not designed for such operation.
The Monolith loudspeakers have been designed for two meth-
ods of operation:
1 Full range with two channels of amplification and a
single pair of cables.
2 Bi-amplification with an external electronic crossover,
four channels of amplification and two pairs of speaker
cables.
2101 Delaware Street, Lawrence, Kansas 66046, USA tel 785.749.0133 fax 785.749.5320 www.martinlogan.com
c l s e l e c t r o s t a t i c
MA R T I N LO G A N
©2000 MartinLogan, All rights reserved Rev. #110702


Produkt Specifikationer

Mærke: Martin Logan
Kategori: Ikke kategoriseret
Model: Monolith II

Har du brug for hjælp?

Hvis du har brug for hjælp til Martin Logan Monolith II stil et spørgsmål nedenfor, og andre brugere vil svare dig