Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment. This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) this device may not cause interference
(2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee t ah t interference will not occur in a particular installation
If this equipment does cause harmful interference to radio or
televsion reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet an a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
SAR tests are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands, although the SAR
is determined at the highest certified power level, the actual SAR
level of the device while operating can be well below the maximum
value, in general, the closer you are to a wireless base station
antenna, the lower the power output.
Before a new device is a available for sale to the public, it must
be tested and certified to the FCC that it does not exceed the
exposure limit established by the FCC, Tests for each device are
performed in positions and locations as required by the FCC.
For body worn operation, this device has been tested and meet
the FCC RF exposure guidelines when used with an accessory
designated for this product or when used with an accessory that
contains no metal and that positions the handset a minimum of 5
Non-compliance with the above restrictions may result in
violation of RF exposure guidelines.
