Mean Well HRP-100-5 Manual

Mean Well Ikke kategoriseret HRP-100-5

Læs gratis den danske manual til Mean Well HRP-100-5 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om Mean Well HRP-100-5, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Installation Manual

 Type：

：

：：Enclosed Type Switching Power Supply

(Families: G3, NE, LRS, SE, PFC, HSP, SPV, USP, RST, G5, MSP)

 Introduction

Enclosed type switching power supplies possess a metal or plastic case for covering their internal PCB and will be

installed inside the case of the end system. Mean Well’s enclosed type power supplies include 2 different groups of

power supplies, with built-in fan and without built-in fan, depending on their rated power or design concept.

 Installation

（）1 Before any installation or maintenance work, please disconnect your system from the utility.

Ensure that it can’t be re-connected inadvertently!

（）2 Keep enough insulation distance between mounting screws and internal components of power supplies. Please

refer to case drawing on specifications to receive the maximum length of mounting screw.

（）3 Mounting orientations other than standard orientation or operate under high ambient temperature may

increase the internal component temperature and will require a de-rating in output current. Please refer to

the specification sheets to receive the optimum mounting position and information about the de-rating curve.

（）4 Fans and ventilation holes must be kept free from any obstructions. Also a 10-15 cm clearance must be kept

when the adjacent device is a heat source.

（）5 Input and Output terminal

Terminal Screw

Series Screw Size Suggested

Torque

RSP-750 / 1000 / 1500 / 2000 / 2400 / 3000

SE-450 / 1000 / 1500

HEP-600 MSP-300 ，HRP-300，HRPG-300，

SP-480，SP-750，SPV-1500，USP-500，RST-10000

M4 10-12kgf-cm

HRP-075 / 100 / 150 / 200，HRPG-150 / 200

LRS-035 / 050 / 075 / 100 / 150 / 150F / 200 / 350

MSP-100 / 200

NED-035 / 050 / 075 / 100，NET-035 / 050 / 075

NES-025 / 035 / 050 / 075 / 100 / 150 / 200 / 350

QP-200 / 320 / 375

RD-050 / 065 / 085 / 125，RID-050 / 065 / 085 / 125

RS-035 / 050 / 075 / 100 / 150

RSP-075 / 100 / 150 / 200 / 320

SP-075 / 100 / 150 / 200 / 240 / 320，SPV-150/300

SE-100 / 200 / 350，HSP-250，PSP-600

M3.5 8-10 kgf-cm

RSP-1600

RD-035，RT-050 / 065 / 085 / 125

RQ-050 / 065 / 085 / 125

TP-075 / 100 / 150，QP-100 / 150

RS-015 / 025

NES-015，USP-150

M3 6-8 kgf-cm

ERP-350

HDP-190 / 240

NEL-200 / 300

#6 8-10 kgf-cm

Installation Manual

Terminal Screw

Series

Input Output

Screw Size Suggested

Torque Screw Size Suggested

Torque

HRP-450 / 600

HRPG-450 / 600

MSP-450 / 600

SE-600

M3 6-8kgf-cm M4 10-12kgf-cm

HSP-150 / 200 /300

HSN-200 / 300 M3 6-8kgf-cm M3.5 8-10kgf-cm

RSP-500 M3.5 8-10kgf-cm M4 10-12kgf-cm

RST-5000 M4 10-12kgf-cm 10-12kgf-cm M8

NEL-400 #6 8-10kgf-cm M3 8-10kgf-cm

（）6 Recommended wires are shown as below.

AWG 18 16 14 12 10 8

Rated Current of

Equipment (Amp) 6A 6-10A 10-16A 16-25A 25-32A 32-40A

Cross-section of

Lead(mm2 ) 0.75 1.00 1.5 2.5 4 6

Note: Current each wire carries should be de-rated to 80% of the current

suggested above when using 5 or more wires connected to the unit.

Make sure that all strands of each stranded wire enter the terminal connection and the screw terminals are

securely fixed to prevent poor contact.

（）7 For other information about the products, please refer to www.meanwell.com for details.

 Warning / Caution !!

（）1 Risk of electrical shock and energy hazard. All failure should be examined by a qualified technician. Please do

not remove the case of the power supply by yourself!

（）2 Please do not install power supplies in places with high moisture or near the water.

（）3 Please do not install power supplies in places with high ambient temperature or near fire source. The

maximum ambient temperature please refer to their specifications.

（）4 Output current and output wattage must not exceed the rated values on specifications.

（）5 The ground(FG) must be connected to earth ground.

（）6 All MW’s PSUs are designed in accordance with EMC regulations and the related test reports are available by

request. Since they are belong to component power supplies and will be installed inside system enclosure,

when they are integrated into a system, the EMC characteristics of the end system must be re-verified again.

Produkt Specifikationer

Mærke:	Mean Well
Kategori:	Ikke kategoriseret
Model:	HRP-100-5
Bredde:	97 mm
Dybde:	159 mm
Højde:	38 mm
Vægt:	580 g
Antal pr. pakke:	24 stk
Udgangseffekt:	100 W
Udgangsspænding:	5 V
Udgangsstrøm:	17 A
Bæredygtighedscertifikater:	RoHS
Indgangsspænding:	90 - 305 V