Mean Well HRPG-200-15 Manual

Mean Well Ikke kategoriseret HRPG-200-15

Læs gratis den danske manual til Mean Well HRPG-200-15 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Mean Well HRPG-200-15, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
Installation Manual
Type：
：
：
：：Enclosed Type Switching Power Supply
(Families: G3, NE, LRS, SE, PFC, HSP, SPV, USP, RST, G5, MSP)
Introduction
Enclosed type switching power supplies possess a metal or plastic case for covering their internal PCB and will be
installed inside the case of the end system. Mean Well’s enclosed type power supplies include 2 different groups of
power supplies, with built-in fan and without built-in fan, depending on their rated power or design concept.
Installation
（ ）1 Before any installation or maintenance work, please disconnect your system from the utility.
Ensure that it can’t be re-connected inadvertently!
（ ）2 Keep enough insulation distance between mounting screws and internal components of power supplies. Please
refer to case drawing on specifications to receive the maximum length of mounting screw.
（ ）3 Mounting orientations other than standard orientation or operate under high ambient temperature may
increase the internal component temperature and will require a de-rating in output current. Please refer to
the specification sheets to receive the optimum mounting position and information about the de-rating curve.
（ ）4 Fans and ventilation holes must be kept free from any obstructions. Also a 10-15 cm clearance must be kept
when the adjacent device is a heat source.
（ ）5 Input and Output terminal
Terminal Screw
Series Screw Size Suggested
Torque
RSP-750 / 1000 / 1500 / 2000 / 2400 / 3000
SE-450 / 1000 / 1500
HEP-600 MSP-300 ，HRP-300，HRPG-300，
SP-480，SP-750，SPV-1500，USP-500，RST-10000
M4 10-12kgf-cm
HRP-075 / 100 / 150 / 200，HRPG-150 / 200
LRS-035 / 050 / 075 / 100 / 150 / 150F / 200 / 350
MSP-100 / 200
NED-035 / 050 / 075 / 100，NET-035 / 050 / 075
NES-025 / 035 / 050 / 075 / 100 / 150 / 200 / 350
QP-200 / 320 / 375
RD-050 / 065 / 085 / 125，RID-050 / 065 / 085 / 125
RS-035 / 050 / 075 / 100 / 150
RSP-075 / 100 / 150 / 200 / 320
SP-075 / 100 / 150 / 200 / 240 / 320，SPV-150/300
SE-100 / 200 / 350，HSP-250，PSP-600
M3.5 8-10 kgf-cm
RSP-1600
RD-035，RT-050 / 065 / 085 / 125
RQ-050 / 065 / 085 / 125
TP-075 / 100 / 150，QP-100 / 150
RS-015 / 025
NES-015，USP-150
M3 6-8 kgf-cm
ERP-350
HDP-190 / 240
NEL-200 / 300
#6 8-10 kgf-cm
Installation Manual
Terminal Screw
Series
Input Output
Screw Size Suggested
Torque Screw Size Suggested
Torque
HRP-450 / 600
HRPG-450 / 600
MSP-450 / 600
SE-600
M3 6-8kgf-cm M4 10-12kgf-cm
HSP-150 / 200 /300
HSN-200 / 300 M3 6-8kgf-cm M3.5 8-10kgf-cm
RSP-500 M3.5 8-10kgf-cm M4 10-12kgf-cm
RST-5000 M4 10-12kgf-cm 10-12kgf-cm M8
NEL-400 #6 8-10kgf-cm M3 8-10kgf-cm
（ ）6 Recommended wires are shown as below.
AWG 18 16 14 12 10 8
Rated Current of
Equipment (Amp) 6A 6-10A 10-16A 16-25A 25-32A 32-40A
Cross-section of
Lead(mm2 ) 0.75 1.00 1.5 2.5 4 6
Note: Current each wire carries should be de-rated to 80% of the current
suggested above when using 5 or more wires connected to the unit.
Make sure that all strands of each stranded wire enter the terminal connection and the screw terminals are
securely fixed to prevent poor contact.
（ ）7 For other information about the products, please refer to www.meanwell.com for details.
Warning / Caution !!
（ ）1 Risk of electrical shock and energy hazard. All failure should be examined by a qualified technician. Please do
not remove the case of the power supply by yourself!
（ ）2 Please do not install power supplies in places with high moisture or near the water.
（ ）3 Please do not install power supplies in places with high ambient temperature or near fire source. The
maximum ambient temperature please refer to their specifications.
（ ）4 Output current and output wattage must not exceed the rated values on specifications.
（ ）5 The ground(FG) must be connected to earth ground.
（ ）6 All MW’s PSUs are designed in accordance with EMC regulations and the related test reports are available by
request. Since they are belong to component power supplies and will be installed inside system enclosure,
when they are integrated into a system, the EMC characteristics of the end system must be re-verified again.

Produkt Specifikationer

Mærke: Mean Well
Kategori: Ikke kategoriseret
Model: HRPG-200-15

Har du brug for hjælp?

Hvis du har brug for hjælp til Mean Well HRPG-200-15 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Mean Well Manualer

Mean Well

Mean Well LPF-40D-36 Manual

12 Januar 2025
Mean Well

Mean Well ELG-75-C700-3Y Manual

11 Januar 2025
Mean Well

Mean Well ELG-75-C500A-3Y Manual

11 Januar 2025
Mean Well

Mean Well LPF-40-54 Manual

11 Januar 2025
Mean Well

Mean Well HDR-15-5 Manual

5 Januar 2025
Mean Well

Mean Well ELP-75-12 Manual

3 Januar 2025
Mean Well

Mean Well DLP-04R Manual

3 Januar 2025
Mean Well

Mean Well QP-150C Manual

29 December 2024
Mean Well

Mean Well PWM-200-12 Manual

12 December 2024
Mean Well

Mean Well ELN-30-5 Manual

8 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Navman

Navman MY500XT Manual

1 August 2025
Navman

Navman FOCUS150 GPS Manual

1 August 2025
Scheppach

Scheppach TW1000 Manual

1 August 2025
Navman

Navman MiVue 750 WIFI Manual

1 August 2025
Navman

Navman MiVue Drive FHD Manual

1 August 2025
Midea

Midea MEC64 Manual

1 August 2025
Navman

Navman MY50T Manual

1 August 2025
Navman

Navman M100 Manual

1 August 2025
Navman

Navman MiVue 770 SAFETY Manual

1 August 2025
Navman

Navman MiVue 790 Manual

1 August 2025