Instructions Manual
EN
Introduction
Thank you for your purchasing our HSUPA USB modem
with TF fl ash card socket. Device is backward compa-
tible with HSDPA/UMTS standards and supported by
Media-Droid products. Modem has driver stored on
built-in memory. Please take a moment and read this
manual carefully before using the device.
Installation
Note! It is strongly recommended to disable antivi-
rus/fi rewall software before installation procedure.
Please start your computer, and then connect modem
to USB port.
1) System at fi rst will detect new storage device.
2) New storage device is ready to work.
7) Every time you plug modem - manager software will
start automatically. If it does not, click icon on desk-
top to run software manually.
5) Now wait 1-3 minutes, system will add modem to
system devices and appropriate modem manager
software.
3) If you have autoplay function enabled modem
driver installation will start automatically, follow on-
screen messages to fi nish process.
If modem driver instal-
lation does not start
automatically open “My
Computer” right click
“HSDPA USB Modem”
CD-ROM and select “AutoPlay”.
Specifi cation and appearance of product are subject to
change without prior notice. For technical support please
visit www.media-tech.eu.
Troubleshooting
Driver or application software installation failed
a. Ensure at least 50MB of hard free disk space.
b. Before installing the driver, close all other programs
including antivirus software.
LED indicator light, not fl ashing
a. Check SIM card, make sure it is installed properly.
b.
If the indicator light is still not fl ashing, disconnect
from USB port and re-insert SIM card, and re-connect.
Modem manager can not start
a. HSDPA USB Modem connect to the PC, please wait
about 5 seconds and then run an application. The
application will automatically test the equipment
connected or not and the SIM card inserted cor-
rectly or not.
b. Follow below steps to check the modem driver:
right click My Computer ->
Manage -> Device Manager
-> Modems.
I can not read TF fl ash card
a. Make sure you have installed it properly. Plug again
into USB port, TF fl ash card should be recognized as
another drive in the system.
4) Click “Finish” when prompted.
6) On desktop following icon will be shown.
3G HSPA USB MULTIMODEM
High Speed Wireless Connectivity
MT4211
8) Now go to “Tools/Options/Profi le Management”,
click “New” and enter profi le name, APN, Access
number, user name and password provided by your
UMTS operator. Click “Default” to make this connec-
tion default and click OK.
Now click “Connect” button.
At window bottom there is a status bar indicating up-
load/download status.
