Megger AVO410 Manual

Megger Multimeter AVO410

Læs gratis den danske manual til Megger AVO410 (18 sider) i kategorien Multimeter. Denne vejledning er vurderet som hjælpsom af 40 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 20.5 anmeldelser. Har du et spørgsmål om Megger AVO410, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/18

AVO410

Digital multimeter

Digitale Multimeter

Multimèter numérique

Multímetro digitales

Digitale multimeter

User manual

Bedienungsanleitung

Manuel utilisateur

Guía del usuario

Gebruikershandleiding

G SAFETY WARNINGS

Safety warnings must be read and understood before instrument is used.

The following safety information must be observed to insure maximum

personal safety during the operation of this meter:

Do not use in wet environments.

Measurements beyond the maximum selected range must not be attempted.

Extreme care must be taken when measuring above 50 V, especially on live

bus-bars.

To measure voltage, the instrument must not be switched to a current or

resistance range, or to the diode check or buzzer position.

Circuits must be de-energised and isolated before carrying out resistance

tests.

The rotary selector switch must only be turned after removing test

connections.

All external voltages must be disconnected from the instrument before

removing the battery.

Test leads and prods must be in good order, clean, and with no broken or

cracked insulation.

UK Safety Authorities recommend the use of fused test leads when measuring

voltage on high energy systems.

Replacement fuses must be of the correct type and rating.

The instrument must not be used if any part of it is damaged.

Check for correct instrument operation by testing a known voltage before

and after use. Do not use if misleading results are obtained.

Warnings and precautions must be read and understood before an instrument

is used. They must be observed during the operation of this instrument.

CAT IV - Measurement category IV: Equipment connected between the origin

of the low-voltage mains supply and the distribution panel.

CAT III - Measurement category III: Equipment connected between the

distribution panel and the electrical outlets.

CAT II - Measurement category II: Equipment connected between the

electrical outlet and the user’s equipment.

Note

This instrument must only be used by suitably trained and competent persons

Produkt Specifikationer

Mærke:	Megger
Kategori:	Multimeter
Model:	AVO410

Har du brug for hjælp?

Hvis du har brug for hjælp til Megger AVO410 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Multimeter Megger Manualer

Megger DPM1000 Manual

28 December 2024

Megger AVO 415 Manual

7 December 2024

Megger FCC3450 Manual

3 September 2024

19 August 2024

19 August 2024

19 August 2024

16 August 2024

Multimeter Manualer

Nyeste Multimeter Manualer

8 Juni 2025

7 Juni 2025

7 Juni 2025

6 Juni 2025

6 Juni 2025

6 Juni 2025

6 Juni 2025

6 Juni 2025

6 Juni 2025

3 Juni 2025