Megger DPM1000 Manual

Megger Multimeter DPM1000

Læs gratis den danske manual til Megger DPM1000 (33 sider) i kategorien Multimeter. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Megger DPM1000, eller vil du spørge andre brugere om produktet?

Side 1/33
DPM1000
User guide
EN
G Safety Information
Understand and follow the operating instructions carefully.
G WARNING
Identify hazardous conditions and actions that could cause BODILY HARM or DEATH
When using test leads or probes, keep your fingers behind the finger guards.
Personal protective equipment should be used if there are ACCESSIBLE HAZARDOUS
LIVE PARTS in the installation where measurement is to be carried out.
Remove test leads from meter before opening the battery door or meter case.
Use the meter only as specified in this manual; otherwise, the protection provided by
the meter may be impaired.
Always use the proper input terminals, switch position, and range for measurements.
Verify the meters operation by measuring a known voltage. If in doubt, have the meter
calibrated.
Do not apply more than the rated voltage, as marked on the meter, between terminals
or between any terminal and earth.
Use caution with voltages above 30 V AC rms, 42 V AC peak, or 60 V DC. These voltages
pose a shock hazard.
To avoid false readings that can lead to electric shock and injury, replace the battery as
soon as the low battery indicator blinks.
Disconnect circuit power and discharge all high-voltage capacitors before testing
resistance, continuity, diodes, or capacitance.
Do not use the meter around explosive gas or vapour.
To reduce the risk of fire or electric shock do not expose this product to rain or moisture.
Probe assemblies to be used for MAINS measurements shall be RATED as appropriate
for MEASUREMENT CATEGORY III or IV according to EN 61010-031 and shall have a
voltage RATING of at least the voltage of the circuit to be measured.
DO NOT USE the test leads if the internal white insulation layer is exposed.
DO NOT USE the test leads above maximum ratings of CAT Environment or voltage and
current that are indicated on the probe and probe tip guard.
Do not apply a current with a frequency that is higher than the frequency response
range specified in the Electrical Specifications section.
Do not apply or remove the clamp or test leads on or around uninsulated hazardous live
conductors where a potential to cause electric shock, electrical burns or arc flash exists.
User Guide www.megger.com
2


Produkt Specifikationer

Mærke: Megger
Kategori: Multimeter
Model: DPM1000

Har du brug for hjælp?

Hvis du har brug for hjælp til Megger DPM1000 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Multimeter Megger Manualer

Megger

Megger BMM2500 Manual

11 Oktober 2025
Megger

Megger DCM330 Manual

11 Oktober 2025
Megger

Megger DCM310 Manual

11 Oktober 2025
Megger

Megger DCM1500S Manual

11 Oktober 2025
Megger

Megger DCM300E Manual

11 Oktober 2025
Megger

Megger MET1000 Manual

11 Oktober 2025
Megger

Megger AVO850 Manual

8 September 2025
Megger

Megger KC-C Manual

6 September 2025
Megger

Megger DPM1000 Manual

28 December 2024
Megger

Megger AVO 415 Manual

7 December 2024

Multimeter Manualer

Nyeste Multimeter Manualer