Microchip MIC5375/6 Manual

Microchip Ikke kategoriseret MIC5375/6

Læs gratis den danske manual til Microchip MIC5375/6 (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Microchip MIC5375/6, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/6

MIC5375/6 Evaluation Board

High Performance Low Dropout

150mA LDO

MLF and MicroLeadFrame are registered trademarks of Amkor Technology, Inc.

Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com

January 2009 M9999-012109-A

General Description

The MIC5375/6 is a low quiescent current, low dropout

regulator designed for optimal performance in a small

space. When the MIC5376 is disabled an internal resistive

load is automatically applied to the output to discharge the

output capacitor. The MIC5375/6 is capable of sourcing

150mA of output current while only consuming 29µA of

operating current. This high performance LDO offers fast

transient response and good PSRR while consuming a

minimum of current.

Ideal for battery operated applications; the MIC5375/6

offers low dropout voltage 120mV typically @ 150mA. The

MIC5375/6 can also be put into a zero-off-mode current

state, drawing virtually no current when disabled.

An input capacitor may be required when the power supply

is more than 4-inches from the device. The evaluation

board includes an input capacitor of 10μF to compensate

for long inductive test leads.

Requirements

The MIC5375/6 evaluation board requires an input power

supply of 400mA with a voltage range of 2.3V to 5.5V to

the VIN.

Precautions

The evaluation board does not have reverse polarity

protection. Applying a negative voltage to the VIN terminal

may damage the device.

Getting Started

1. Connect an external supply to VIN. Apply desired

input voltage to the VIN (J1) and ground terminal

(J2) of the evaluation board, paying careful

attention to polarity and supply voltage. An

ammeter may be placed between the input supply

and the VIN terminal to the evaluation board.

Ammeter and/or power lead resistance can reduce

the voltage supplied to the input.

Ensure that the supply voltage is monitored at VIN

terminal. There is 10uF capacitor connected from

VIN (J1) to GND (J2).

2. Enable/Disable the MIC5375/6. The YMT (1x1

TMLF) evaluation board is provided with a 100kΩ

pull up resistor on enable pin (EN) to VIN, where as

the YC5 (SC-70) evaluation board is provided with

a 100kΩ pull down resistor from the enable pin

(EN) to GND. Simply jumper the enable pin (EN)

to VIN to enable the regulator output, or to GND to

disable the output. The enable pin must be either

pulled high or low. Removing the pull up resistor

and leaving the EN pin floating will cause the

regulator to operate in an indeterminate state.

3. Connect the loads to the VOUT terminal (J3) and

ground terminal (J2). The load can be either a

passive (resistor) or active (electronic load). Be

sure to monitor the output voltage at the VOUT (J3)

terminals. The evaluation board has a 1uF

capacitor connected from VOUT (J3) to GND (J2).

Ordering Information

Part Number Description

MIC5375-2.8YMT High Performance Low Dropout 150mA LDO,

1x1 TMLF,VOUT = 2.8V Evaluation Board

MIC5375-2.8YC5 High Performance Low Dropout 150mA LDO,

SC-70, VOUT = 2.8V Evaluation Board

MIC5376-2.8YMT High Performance Low Dropout 150mA LDO,

1x1 TMLF, VOUT = 2.8V Evaluation Board

MIC5376-2.8YC5 High Performance Low Dropout 150mA LDO,

SC-70,VOUT = 2.8V Evaluation Board

Produkt Specifikationer

Mærke:	Microchip
Kategori:	Ikke kategoriseret
Model:	MIC5375/6

Har du brug for hjælp?

Hvis du har brug for hjælp til Microchip MIC5375/6 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Microchip Manualer

Microchip M2GL060 Manual

2 December 2025

Microchip RTPF500TS Manual

2 December 2025

Microchip M1A3P600L Manual

1 December 2025

Microchip M2S090TS Manual

1 December 2025

Microchip M1A3P1000L Manual

1 December 2025

Microchip M2S090 Manual

30 November 2025

Microchip A3PE3000L Manual

30 November 2025

Microchip HC12-100S0s Manual

30 November 2025

Microchip M2GL010T Manual

29 November 2025

Microchip M2GL150T Manual

29 November 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Vinotemp BR-RETRO-01-W Manual

17 December 2025

NightStick INTRANT XPP-5566RX Manual

17 December 2025

Vaxcel T0690 Manual

17 December 2025

Silverstone TS12 Manual

17 December 2025

TOTO Silas TS210P Manual

17 December 2025

Wine-Mate WM-8500DS Manual

17 December 2025

Arçelik A75L 8870 5B Manual

17 December 2025

Dals RWS48-CC Manual

17 December 2025

Vinotemp BR-30SSGG Manual

17 December 2025

Gamdias Aura GC1 Elite Manual

17 December 2025