Microchip RN4871 Manual


Læs gratis den danske manual til Microchip RN4871 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Microchip RN4871, eller vil du spørge andre brugere om produktet?

Side 1/2
© Microchip Technology, Inc. 20 RN4870 v1.42 Release Notes 21
RN4870/ Firmware 71 1.42 Release Note
9/ / 01 2021
1 Overview
This release note provides details on the firmware Rev 1.42 that is released for the
RN4870 and RN4871 modules.
2 New Features
Rev 1.42 incorporates a new command to change the UART immediately
without the need for a reboot (unlike the SB command).
- SBI, <8-bit hex value>
- The input parameter is an 8-bit hex value in the range of 00 to 0B,
representing baud rate from 2400 to 921K as shown in table below.
-
Hex value
Baud rate
00
921000
01
460800
02
230400
03
115200
04
57600
05
38400
06
28800
07
19200
08
14400
09
9600
0A
4800
0B
2400
- Default: 03
- Example: SBI,07 //Set the UART baud rate to 19200
immediately
- Response: AOK //Success
- ERR //Syntax error or invalid parameter
3 Resolved Issues
Fixed ANSSI vulnerabilities
Fixed Sweyntooth vulnerabilities
Modified the SM command to limit the range of timers 2 and 3. The value can
be set for these timers should be between 0 to 0x0FFE.


Produkt Specifikationer

Mærke: Microchip
Kategori: Ikke kategoriseret
Model: RN4871

Har du brug for hjælp?

Hvis du har brug for hjælp til Microchip RN4871 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Microchip Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer