Monogram ZET757 Manual

Monogram Ovn ZET757

Læs gratis den danske manual til Monogram ZET757 (16 sider) i kategorien Ovn. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Monogram ZET757, eller vil du spørge andre brugere om produktet?

Side 1/16
Before you begin
Read these instructions carefully and completely
IMPORTANT-Save these instructions for
local inspectors use.
IMPORTANT-Observe all governing
codes and ordiances.
30” Built In Wall Oven
Installation
JTP15, JTP17, JTP18, JTP27, JTP45, JTP47, JTP56,
JT910, JT910WA, JT950AA, JT950, ZET737, ZET757
Note to Installer- Be sure to leave these
instructions with the consumer.
OWNER- Keep these instructions for future
reference.
NOTE- This appliance must be properly
grounded.
Parts Included
Bottom Trim
4 screws (single)
8 screws (double)
Tools You Will Need
Pub. No. 31-10435
229C4053P417-1
1
Materials Needed
ATTENTION: INSTALLER
All electric wall ovens must be hard wired (direct wired) into an approved
junction box. A “plug and receptacle” is not permitted on these products.
1/8” Drill Bit &
Electric or
Hand Drill
Phillips
Screwdriver
Strain Relief
Clamp
Junction
Box
Wire Nuts
36” of String
“If you have questions, call 800-GE-CARES or visit our website at:
www.GEAppliances.com”
Be sure your oven is installed properly by
a qualified installer or service technician.
Be sure the oven is securely installed in a
cabinet that is firmly attached to the
house structure. Weight on the oven door
could cause the oven to tip and result in
injury. Never allow anyone to climb, sit,
stand or hang on the oven door.
Make sure the cabinets and wall cover-
ings around the oven can withstand the
temperatures (up to 200°F.) generated by
the oven.
CAUTION: The electrical power
to the oven supply line must be
shut off while line connections
are being made. Failure to do so
could result in serious injury or
death.
For Your Safety
2
Installation Instructions
This appliance must be supplied with the
proper voltage and frequency, and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or fuse,
having amperage as noted on rating plate.
(Rating Plate is located on oven frame.)
We recommend you have the electrical wiring
and hookup of your oven connected by a
qualified electrician. After installation, have the
electrician show you where your main range
disconnect is located.
Check with your local utilities for electrical
codes which apply in your area. Failure to
wire your oven according to governing codes
could result in a hazardous condition. If there
are not local codes, your range must be wired
and fused to meet the requirements of the
National Electrical Code, ANSI/NFPA No. 70-
Latest Edition. You can get a copy by writing:
National Fire Protection Association
Battery March Park
Quincy, MA 02269
Effective January 1, 1996, the National
Electrical Code requires that new, but not
existing, construction utilize a 4 conductor
connection to an electric range. When
installing an electric range in new
construction, follow the instructions in the
section on NEW CONSTRUCTION AND
FOUR CONDUCTOR BRANCH CIRCUIT
CONNECTION.
You must use a three-wire, single-phase A.C.
208Y/120 Volt or 240/120 Volt, 60 hertz
electrical system. If you connect to aluminum
wiring, properly installed connectors approved
for use with aluminum wiring must be used.
Electrical
Requirements
IMPORTANT SAFETY INSTRUCTIONS


Produkt Specifikationer

Mærke: Monogram
Kategori: Ovn
Model: ZET757

Har du brug for hjælp?

Hvis du har brug for hjælp til Monogram ZET757 stil et spørgsmål nedenfor, og andre brugere vil svare dig