Monogram ZUG30 Manual


Læs gratis den danske manual til Monogram ZUG30 (6 sider) i kategorien Køleskab. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Monogram ZUG30, eller vil du spørge andre brugere om produktet?

Side 1/6
Installation Instructions – ZUG30 Heater Kit/Cover
TO BE USED WITH HOUSEHOLD REFRIGERATORS
30" BUILT-IN
BOTTOM-FREEZER 2 DRAWER,
ALL REFERENCES TO ASSEMBLY ARE FROM THE FRONT OF THE UNITS
PARTS PROVIDED:
Installation Instructions (1)
Transformer (1)
Plastic Cover (1)
Brackets (2)
Tools Required:
#2 Phillips Head Screw Driver
Step Ladder
Open Wrench Set
5 mm. Allen Wrench
IMPORTANT SAFETY NOTICE:
This kit is to be installed by a qualied service technician only. Any attempt to repair a major appliance may result in
personal injury and property damage. Neither the manufacturer nor the seller can be responsible for the interpretation
of this information or assume any liability in connection with its use.
197D9290P001 31-45446-1 05-12 GE
Unit 1 - Spacer Clips Installed
Unit 1
Unit 2
Unit 2 - Heater Installed
Spacer Clips (8)
Strain Relief (1)
Screw, 4.8 x 13 (4)
Bolt, M4 x 18 (2)
Nut, M4 (2)
Washer, star (4)
Bolt, M6 x 45 (3)
Nut, M6 (3)
Washer, at (6)
Wiring 'Y' Splitter (1)
NOTE: WHILE PERFORMING INSTALLATIONS
DESCRIBED IN THIS BOOK, SAFETY GLASSES OR
GOGGLES SHOULD BE WORN.
PPE Required:
Safety Glasses
Safety Gloves
BEFORE YOU BEGIN
Read these instructions
completely and carefully.
Disconnect power to the appliance before beginning installation.
Do not operate the refrigerator until the installation is complete.
WARNING
WARNING
This refrigerator is top heavy and must be handled with care.
Failure to do so can result in the unit tipping over and re
sult in death or serious injury.
Do not cut lower banding on units.
Do not remove foam base pad from front of units.
STOP
1. This heater kit will only t two units, if the doors face each other when opened. Door swing of unit 1 must
be switched from right hand swing to left hand swing. Refer to Installation Instructions 31-46542 for proper
procedure and safety measures.
2. On sides of refrigerators, remove white stickers from top and center location, to reveal holes in the case. Remove
any labels from sides of refrigerators and clean the surfaces.
3. Attach spacer clips to the inner side wall of Unit 1. Line up holes in Spacer Clips 1 and 4 with holes in case. Attach
clips 2 and 3 evenly spaced between 1 and 4. Note that clips 2 and 3 are dierent that the six other clips. It is very
important that you use clips 2 and 3 in those locations only. Clip 6 attaches on the bottom front corner, along the
front edge of Unit 1, same as clips 1 and 4. Clip 5 spaced evenly between clip 4 and 6. Clip 7 attaches to the top,
rear corner of Unit 1. Orientation is not critical. Clip 8 is attached in a later step.
Unit 1 Unit 2
Required Door Swing
(view from above)
Unit 1
Unit 2
Spacer Clips
Unit 1
Unit 2
1
1
7
7
2
2
3
3
4
4
5
5
6
6
8
8
2
1,4-8
Spacer Clips 2,3


Produkt Specifikationer

Mærke: Monogram
Kategori: Køleskab
Model: ZUG30

Har du brug for hjælp?

Hvis du har brug for hjælp til Monogram ZUG30 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Køleskab Monogram Manualer

Køleskab Manualer

Nyeste Køleskab Manualer