Moxa INJ-24A-T Manual

Moxa Wifi repeater INJ-24A-T

Læs gratis den danske manual til Moxa INJ-24A-T (10 sider) i kategorien Wifi repeater. Denne vejledning er vurderet som hjælpsom af 28 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 14.5 anmeldelser. Har du et spørgsmål om Moxa INJ-24A-T, eller vil du spørge andre brugere om produktet?

Side 1/10
P/N: 1802000240025
*1802000240025*
INJ- 24A Series
Quick Installation Guide
Moxa High Injector-Power PoE+
Vers 20ion January 4.2, 21
Technical Support Contact Information
www.moxa.com/support
2 . A20 1 Moxa Inc ll rights reserved.
- - 2
Overview
The Moxa INJ- -24A Series high power PoE+injector is a 1-port PoE+
injector that delivers both data and electrical power to Ethernet-enabled
devices using a single Ethernet cable. The INJ-24A can supply up to 36
watts of power in 2- 4-pair mode or 60 watts in pair mode through the
Ethernet port, and can power IEEE 802.3af/at compliant powered devices
(PD), such as wireless access points or IP cameras, eliminating the need
for additional wiring. The INJ it communication, which -24A supports Gigab
is vital for high- -speed and low latency applications. The INJ-24A also
offers a wide operating temperature range of -40 to 75°C, and is designed
to withstand a high degree of vibration and shock. An innovative
hardware design enhances the INJ-24A with flexible options of Mode A
and Mode B PoE powering modes. This makes the INJ-24A perfect for
outdoor field installation of M12-connector wireless APs and IP cameras
which only have 4 pins in the cable. In addition, the - t INJ 24A can resis
3KV surges from the PoE port, protecting s system operation in critical
industrial environments, and complies with CE/FCC and UL standards for
safet y.
Wiring Requirements
WARNING
Do not disconnect modules or wires unless the power supply has
been switched off or the area is known to be non
-
hazardous. The
devices may only be connected to the supply voltage shown on
the type plate. The devices are designed for operation with a
Safety Extra
-Low Voltage. Thus, they may only be c
onnected to
the supply voltage connections and to the signal contact with the
Safety Extra
-Low Voltages (SELV) in compliance with IEC
60950 1.-1/EN 60950-
WARNING
The power for this product is intended to be supplied by a Listed
Power Unit, with output marked LPS, and rated to deliver 24 DC
at a maximum of 3.72 A.
WARNING
This unit is a built
-in type. When the unit is installed in another
piece of equipment, the equipment enclosing the unit must
comply with fire enclosure regulation IEC 60950
- -1/EN60950 1
(or similar regulation).


Produkt Specifikationer

Mærke: Moxa
Kategori: Wifi repeater
Model: INJ-24A-T

Har du brug for hjælp?

Hvis du har brug for hjælp til Moxa INJ-24A-T stil et spørgsmål nedenfor, og andre brugere vil svare dig