MTX Audio RT8PT Manual

MTX Audio Modtager RT8PT

Læs gratis den danske manual til MTX Audio RT8PT (54 sider) i kategorien Modtager. Denne vejledning er vurderet som hjælpsom af 64 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 32.5 anmeldelser. Har du et spørgsmål om MTX Audio RT8PT, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/54

RT8PT

20cm (8") Powered Tube Enclosure

120W RMS

Designed in Phoenix - AZ, USA

www.mtx.eu.com

www.mtx.com

Line In

PWR

Gain

6V-0.1V 50Hz-200Hz

Rem.

Prot.

PWR

GND+12V

FUSE

LPF

EBC PortHLI

www.mtx.com - www.mtx.eu.com

Introduction

Thank you for purchasing an MTX Audio Hi-Performance powered tube. Proper installation matched with MTX

speakers and ampliers provide superior sound and performance for endless hours of waking the neighbors,

slammin' your friends or at out stomping wanna-be players. Congrats and enjoy the ultimate audio experience

with MTX !

Features

• Powered vented enclosure

• Subwoofer : 20cm (8")

• Amplier Max Power : 360W

• Amplier RMS Power : 120W

• EBC remote included

• High and low level inputs

• Dimensions : 25x25x54cm

Control Panel on the Amplier

Owner’s Manual - RT8PT

Speaker level inputs - This input will allow the amplier to operate from source units with speaker-level outputs.

Output speaker leads from the source unit should be tied directly to the wire harness provided with the amplier.

Note : When speaker level inputs are used, a remote turn on wire must used to switch the amplier on and o.

EBC Port (External Bass Control) - The Remote Subwoofer Level Control (EBC) plugs directly into this port, while

the EBC itself can be placed anywhere in the vehicle for on demand bass adjustments. EBC is included.

RCA Inputs - These RCA inputs are used with source units that have RCA or Line level outputs. (Source units need

a minimum level of 100mV output for proper operation of the amplier).

MTX recommends only high quality twisted pair cables (such as StreetWires) to decrease the possibility of radi-

ated noise entering the system.

Gain Control - The gain control matches the input sensitivity of the amplier to the source unit being used. The

operating range varies from 100mv to 6V.

Adjusting the gain

1. Turn the gain control on the amplier all the way down (counter clockwise).

2. Turn up the volume control on the source unit to approximately 3⁄4 of maximum.

3. Adjust the gain control on the amplier until audible distortion occurs.

4. Adjust the gain control down until audible distortion disappears.

5. The amplier is now calibrated to the output of the source unit.

Low Pass X-Over Frequency Control - Used to select the desired low-pass (LP) x-over frequency. The frequency is

adjustable from 50Hz to 200Hz..

Protection LED - When the amps is in thermal protection, the LED turns to red.

PowerOn LED - The LED illuminates red when the amp is switched on.

Produkt Specifikationer

Mærke:	MTX Audio
Kategori:	Modtager
Model:	RT8PT
Bredde:	540 mm
Dybde:	250 mm
Højde:	250 mm
Produktfarve:	Grå
Lavpasfilter:	Ja
Forstærker klasse:	D
Subwoofer driver diameter (britisk):	8 "
Antal forstærkerkanaler:	2 kanaler
Basrefleks:	Ja
Maks. udgangseffekt (RMS):	360 W
Lavpasfilterområde:	50 - 200 Hz
RMS udgangseffekt pr. kanal (2 ohm):	120 W
Indgangsfølsomhed:	100 mV