NaceCare Solutions AV 4X Manual

NaceCare Solutions Ikke kategoriseret AV 4X

Læs gratis den danske manual til NaceCare Solutions AV 4X (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om NaceCare Solutions AV 4X, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Avenger Upright Spotting Extractor

Model: AV 4X

NOTE: As with all electrical equipment, care and attention must be exercised at all times during its use,

in addition to ensuring that routine and preventative maintenance is carried out periodically in order to

ensure its safe operation. In particular the electrical supply cable should be regularly inspected by a

competent person and immediate action taken to rectify any faults found. Failure to carry out

maintenance as necessary, including replacement of parts to the correct standard, could render the

equipment unsafe and the manufacturer can accept no responsibility in this respect. See the enclosed

exploded drawings for correct replacement parts.

____________________________________________________

Before using your machine, you must familiarize yourself with all its components.

____________________________________________________

MACHINE COMPONENTS

Vacuum Dome

The vacuum dome is located on top of the recovery tank. It is held in place by 2 moulded clips under the

rim. On the left side (from behind the machine) there is a debris screen to prevent debris from entering

the vacuum hose leading to the vacuum motor. The ports which accept the hose cuffs from the vacuum

shoe and the vacuum motor are different sizes so they cannot be attached incorrectly.

Handle

The handle of the machine is adjustable to suit different operators. To increase or decrease the handle

height, loosen the knurled knob at the rear of the handle and slide up or down as required. Re-tighten the

knob when the desired height is reached. The hand grip rotates in a counterclockwise direction. This

action depresses a microswitch that starts the solution pump (when the solution switch is in the lower “I”

position). Solution stops flowing when the grip is released or when it is rotated in a clockwise direction.

Recovery Tank

The recovery tank is located on the top of the machine. It is attached to the solution tank (lower) by two

latches. It is easy to remove the recovery tank from the solution tank for emptying and clean-out.

Solution Tank

The solution tank is the lower unit. It can be filled with water via the rear fill hole that is covered with a

round black cap using a clean bucket or with a hose direct from the faucet. The cap has a retaining strap

so that it does not become misplaced. Inside the solution tank, the water pick-up hose has with an inlet

filter and weight. The weight must be at the inlet filter end of the hose to keep it submerged.

At the rear of the machine beneath the handle is a panel that encloses the pump. Exiting from this panel

is a quick coupler. For normal use, the short water hose running underneath the machine should be

connected to the quick coupler.

If accessory cleaning attachments are used, disconnect the solution line at the rear of the machine and

replace it with the accessory solution hose.

The rear panel also incorporated the electrical switches. On the right side is the vacuum switch. On the

left is the 3 position pump switch. In the middle position, the pump is off. In the lower position the pump

will only activate when the hand grip on the handle is twisted. In the upper position, the pump operates

continuously. Use this position when using accessory cleaning attachments.

NOTE: Never fill the unit using a dirty bucket. This may cause damage to the pump system.

Vacuum Shoe

The vacuum shoe is fitted with a hard floor wet pick-up squeegee. When using the machine on hard

surfaces rotate the black lever on the front of the squeegee assembly counterclokwise to lower it. When

using the mahcine on carpeted surfaces rotate the lever fully clockwise.

Fitted at the back of the vacuum shoe is a black spraybar with a twist-off spray tip. If the spray pattern

becomes erratic or there is poor water flow to the floor, remove and clean the spray tip.

Produkt Specifikationer

Mærke:	NaceCare Solutions
Kategori:	Ikke kategoriseret
Model:	AV 4X

Har du brug for hjælp?

Hvis du har brug for hjælp til NaceCare Solutions AV 4X stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret NaceCare Solutions Manualer

NaceCare Solutions TP 4X Manual

16 September 2025

NaceCare Solutions AV 4X Manual

16 September 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Vestil WTJ-20-4-DC Manual

17 September 2025

Canarm CNP100 Manual

17 September 2025

Pro1 T725 Manual

17 September 2025

Vestil FPG-3 Manual

17 September 2025

Vestil BOL-42-5.5 Manual

17 September 2025

Turbo Air M3H24-1-TS Manual

17 September 2025

Dry Ager UX1500 PRO Manual

17 September 2025

Vestil IBC-TLT Manual

17 September 2025

Vestil LAD-FM-96 Manual

17 September 2025

Vestil FHS-4-10 Manual

17 September 2025