Nemco 7020A-S Manual

Nemco Vaffelmaskine 7020A-S

Læs gratis den danske manual til Nemco 7020A-S (3 sider) i kategorien Vaffelmaskine. Denne vejledning er vurderet som hjælpsom af 65 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 33 anmeldelser. Har du et spørgsmål om Nemco 7020A-S, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

NEMCO Belgian Waffle Baker-Digital

Model Series: 7020A, 7020A-S, 7020A-240, 7020A-S240, 7020A-1, 7020A-1S

7020A-1S240,-7020A-208, 7020A-S208, 7020A-1208 & 7020A-1S208

OPERATING INSTRUCTIONS

INTRODUCTION

1. To get the best operation and life from your machine, please read and comply with these instructions.

2. When using electrical appliances, always follow basic precautions to reduce the risk of fire, electric shock and injury to

persons.

3. Clean machine thoroughly before and after each use using cleaning instructions below

4. Sanitize before use.

SAFETY INSTRUCTIONS

1. Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as listed on the machine model

labels.

2. Always unplug the electric cord when appliance is not in use and before cleaning, adjusting or maintaining this machine.

Do not operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use

authorized service for examination, electrical or mechanical adjustment or repair.

3. This machine will be HOT during use and for a short time after it is turned off – BE CAREFUL. To avoid burns, do not let

bare skin touch hot surfaces. If provided, use handles when moving this appliance. Keep combustible materials away from

appliance.

4. Use extreme caution when any appliance is used by or near children and whenever the appliance is left operating and

unattended.

5. This appliance is not intended for use near or around water. Never locate appliance where it may fall into a water container.

ELECTRICAL REQUIREMENTS

Refer to the product tag (serial plate) on the back of the unit for voltage and wattage requirements. Be sure to plug unit into

grounded outlet with sufficient power

PREPARATION AND PROGRAMMING TIME AND TEMPERATURE

1. Set unit on a flat surface

2. Position unit near the power outlet. Avoid the use of extension cords. Do not run cord under carpeting or cover with

runners or the like. Arrange cord where it will not be tripped over.

3. This appliance has hot and live electrical parts. Do not use it in areas where gasoline, paint or flammable liquids are used

or stored

4. Clean unit thoroughly before use.

5. If unit fails to work properly when first operated call NEMCO customer service at 1-800-782-6761

NOTE: The unit is factory set at 385 degrees Fahrenheit for 3 minutes and 30 seconds.

6. The following steps may be taken to alter factory pre-programmed settings.

7. A cycle may be cancelled by depressing and holding the “ start/stop” button for 3 seconds.

8. To change the pre-programmed time: simply press and hold the “ minute” button until colon disappears: roughly 10

seconds. The

“ minutes” button will scroll settings up, and the “ seconds” button will scroll settings down. By holding the buttons down,

the

settings will scroll quickly.

9. To change the pre-programmed temperature setting; press and hold the “ start/stop” button until colon disappears’;

roughly 10

seconds. NOTE: Temperatures is displayed in degrees Fahrenheit.

10. When changes are done, press the “ start/stop” button and the changes will be stored. NOTE: Any and all changes will be

stored in

the unit , and will not be affected by power supply.

STARTUP AND SEASONING THE GRIDS

1. Wash the machine before using.

2. For best results and to eliminate sticking on aluminum grids, the grids should be seasoned following the steps below. Any

good nonstick agent will work. It will be necessary to re-coat from time to time. NOTE: NON-STICK grids are not

seasoned.

3. Coat only new or clean grids.

4. Spray the grid surface and allow to “dry” for at least 30 minutes.

5. Turn baker on for at least 30 minutes.

Baker is now ready to use

OPERATION

1. Push on-off switch to the “ ON” position.

2. L.E.D display will read “ Lo”, indicating the grids have not reached the set point temperature.

3. Time cycle will be displayed once temperature has been reached, approximately 15 minutes.

4. Open grids and pour batter on lower grid.

5. Close grids, rotate 180 degrees; for proper batter distribution’; and press the start/stop button to begin cycle.

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Vaffelmaskine
Model:	7020A-S

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 7020A-S stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Vaffelmaskine Nemco Manualer

Nemco 7020A-S240 Manual

20 August 2024

Nemco 7020A-240 Manual

20 August 2024

Nemco 7000A Manual

20 August 2024

Nemco 7000A-2S240 Manual

19 August 2024

Nemco 7020A-208 Manual

19 August 2024

Nemco 7030A-2 Manual

19 August 2024

Nemco 7020A-S Manual

19 August 2024

Nemco 7020A-1S Manual

18 August 2024

Nemco 7000A-S240 Manual

18 August 2024

Nemco 7000A-2S Manual

18 August 2024

Vaffelmaskine Manualer

Nyeste Vaffelmaskine Manualer

Breville the Sear & Press Grill BGR710 Manual

7 April 2025

Bestron Sweet Dreams AAW700 Manual

13 Januar 2025

Bestron AMWF600 Manual

13 Januar 2025

Bestron AMWM600 Manual

13 Januar 2025

Breville the Light and Fluffy LEG250 Manual

13 Januar 2025

Cuisinart WAF-F30 Manual

11 Januar 2025

Fritel CW 3638 Manual

3 Januar 2025

Bartscher 1BWR 1750 Manual

3 Januar 2025

Bartscher MDI 1BWR 1750 Manual

3 Januar 2025

Alpina SF-2612 Manual

21 December 2024