Nemco 8036GD Manual

Nemco Brødrister 8036GD

Læs gratis den danske manual til Nemco 8036GD (8 sider) i kategorien Brødrister. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Nemco 8036GD, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

Model Series: 8010, 8018, 8027, 8036, 8045W, 8045N, & 8075

Includes Chrome, or GripsIt, Flat or Slant, and 120 Volt or 220 Volt Units

OPERATING AND MAINTENANCE INSTRUCTIONS

AND SERVICE PARTS LIST

INTRODUCTION

1. Please read instructions before using

2. Clean machine thoroughly before and after all uses using cleaning instructions below

3. This machine will be HOT during use and for a short time after it is turned off – BE CAREFUL

SAFETY INSTRUCTIONS

1. Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as listed on the

machine model labels. Units with two cords must be plugged into outlets on individual branch circuits.

2. There is one motor in the units that have one on/off switch.

3. There are two motors in units that have two on/off switches. The left switch controls the rotation of the

front set of rollers and the right switch controls the rotation of the rear set of rollers.

4. On units with two temperature controls, the left dial controls the front half of the rollers which are

denoted by black bearings. The right dial controls the rear rollers which have white bearings.

5. Units with four temperature controls operate from left to right across front panel.

♦ Switch #1 controls the heat in the front four rollers 1-4 which are designated by black bearings.

♦ Switch #2 controls the heat in the next four rollers 5-8 which are designated by white bearings.

♦ Switch #3 controls the heat in the next four rollers 9-12 which are designated by white bearings.

♦ Switch #4 controls the heat in the next four rollers 13-16 which are designated by black bearings.

PREPARATION

1. Set unit on a flat surface

2. Position unit near the power outlet. Avoid the use of extension cords.

3. Clean unit thoroughly before use.

4. If unit fails to operate properly when first installed call NEMCO customer service at 1-800-782-6761.

STARTUP

1. Turn on/off switches to the on position and make sure rollers are turning.

2. Turn temperature controls to desired temperature

♦ Knob setting #2: temperature is at 150º ; HOLD

♦ Knob setting #4: temperature is at 180º ; HOLD

♦ Knob setting #8: temperature is at 220º ; COOK

♦ Knob setting #10: temperature is at 300º ; PREHEAT

3. Allow rollers to heat for 5 to 10 minutes before placing product on rollers.

4. Plastic tongs are included with units with Gripsit rollers. Use plastic to prevent serious damage to these

rollers. Never use metal utensils or tools on the Gripsit rollers.

ELECTRICAL REQUIREMENTS

Refer to the product tag (serial plate) on the back of the unit for voltage and wattage requirements. Be sure to

plug unit into outlet with sufficient power.

Produkt Specifikationer

Mærke:	Nemco
Kategori:	Brødrister
Model:	8036GD

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 8036GD stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Brødrister Nemco Manualer

Nemco 8024-BW Manual

15 Juni 2025

Nemco 6550-DW3 Manual

15 Juni 2025

Nemco 8036-CGD Manual

15 Juni 2025

Nemco 8018GD Manual

14 Juni 2025

Nemco 8045WGD Manual

14 Juni 2025

Nemco 6550-DW1 Manual

14 Juni 2025

Nemco 8036GD Manual

14 Juni 2025

Nemco 6550-DW2 Manual

14 Juni 2025

Nemco 8300 Manual

14 Juni 2025

Nemco 8075-CGD Manual

14 Juni 2025

Brødrister Manualer

Nyeste Brødrister Manualer

Star 70SSA Manual

15 Juni 2025

Star 35SSC Manual

15 Juni 2025

Vollrath 40820 Manual

15 Juni 2025

Star 30ST Manual

15 Juni 2025

Avantco 184T3300B2S Manual

14 Juni 2025

Cloer 3569 Manual

14 Juni 2025

Cloer 3579 Manual

14 Juni 2025

Avantco T140 Manual

14 Juni 2025

Prince Castle 464-B Manual

14 Juni 2025

Avantco RG1818 Manual

13 Juni 2025