Slide the boot onto the cable
- Position the labeling to the cabelend
Slide the crimp ferrule onto the cable
Spread the braided shield
(It`s easily with the NEUTRIK
“SHIELD-SPREADING-TOOL”!)
Crimp the pin
- position the pin on the center conductor
- Crimp the pin with the tool
(For best crimping-results it is recommended to use the original
Neutrik crimp tool
- HXBNC with the corresponding insert
or hexcrimp acc. to IEC 803-W (SW 1.7)
or squarecrimp acc. to IEC 803-2 (SW 1.6)
- Pin can also be soldered (Optional)!
- Straighten the pin if misaligned.
Insert the cable into the connector body
Slide the crimp ferrule over the shield to the front
and push the cable to it`s end position until you
hear a snap noise.
Crimp the ferrule with the tool
(For best crimping-results it is recommended to use the
original Neutrik tool - HXBNC with the corresponding insert)
Snap the boot onto the connector body
Prepare cable as shown
- Use an adjustable coaxial cable stripper
®
A
A
B
C
D
D
E
EF
G
H
I
B
C
Pin flush to the insulator
Please note:
Position the connector body
Flush with the die face.
CRIMP
OPE RA
TION!
H
Don't damage the foil!
(if existing)
Boot
Crimp ferrule
X
Labeling
F
G
I
H
X
rearTWIST BNC 75 Cable Connector -
Crimp version
| W
AS SEMB LY INSTR UCTION
Draft. Nr.: BDA 076 Update: 17.02.2012 / 3102M0771
I I Data subject to change without prior not ice. 2012 NEUTRIK . ALL RIGHTS RESERVED. NEUTRIK are register ed trademar k.
® ®
©
www.neutrik.com
Assembled Connector
[ ]
C: 4 .16”
[ ]
B:5 .197”
[ ]
A: 12 .473”
NEUTRIK AG LI T: F: +423 / 237 24 24 +423 / 232 53 93
NEUTRIK USA Inc. USA T: F: +1 704 / 972 3050 +1 704 / 438 9202
( )
NEUTRIK UK Ltd. UK T: +44 1983 / 811 441 +44 1983 / 811 439 F:
NEUTRIK Vertriebs GmbH DE/ NL / AT/DK T: F: +49 8131 / 280 890 +49 8131 / 280 830
NEUTRIK France FR T: F: +33 1 / 4131 6750 +33 1 / 4131 0511
NEUTRIK Tokyo Ltd. JP T: F: +81 3 / 3663 4733 +81 3 / 3663 4796
NEUTRIK Hong Kong Ltd. T: F: HK +852 / 2687 6055 +852 / 2687 6052
R
R
