Nissin Di466 Manual

Nissin Blitz Di466

Læs gratis den danske manual til Nissin Di466 (6 sider) i kategorien Blitz. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om Nissin Di466, eller vil du spørge andre brugere om produktet?

Side 1/6
DIGITAL TTL POWER ZOOM FLASH
for
Four Thirds/Micro Four Thirds
INSTRUCTION MANUAL
Nissin Japan Ltd., Tokyo
http://www.nissin-japan.com
Nissin Marketing Ltd., Hong Kong
http://www.nissindigital.com
Design and Specifications are subject to change without prior notice. 466FT.Rev0310.1.2
Nissin Di466 Four Thirds / Micro Four Thirds version has been
developed for digital SLR and (Micro) Four Thirds system cameras
with hotshoe and the latest TTL flash control technolgy.
Note: No film camera can be used with Di466 Four Thirds.
Attach Di466 Four Thirds to your camera, and then almost all jobs
are controlled by the camera for the most proper exposure.
Read this instruction manual and refer your camera owner’s
manual to enjoy flash photography.
Read this instruction manual and refer your canera owner’s manual
to enjoy flash photography.
The compatibility list of Di622 Mark II, please check at our official
website: www.nissindigital.com
WARNING
The flash unit contains high voltage electric parts. Do not try
to open or repair the flash unit. Return it back to the repair
service station or the store you bought it.
Do not touch the inside parts from the opening when the unit
was dropped and broken.
Do not fire the flash direct to the eye at short distance. It may
damage the eye. When taking flash picture especially
toward a baby, it is recommended to keep the flash unit at
least 1 meter (3.3feet) away from the subject.
Or use diffuser or bounce the light to the ceiling or to the wall
to soften its intensity.
Do not use the flash unit in the flammable gas, chemicals or
such liquids. It may cause fire or electric shock.
CAUTIONS
Do not leave or store the flash unit in the temperature over
40°C, such like in the automobile.
The flash unit is not water resistant. Keep the unit away from
rain, snow and humidity.
Do not use benzene, thinner or other alcoholic agents to
clean the unit.
Do not use this flash with the cameras which is not listed in
the compatibility list at our official website, otherwise it may
damage the camera’s circuitry.
Remove the batteries when not in use for a longer period of
time.
This sign refers the danger or serious damage.
This sign refers the damage or defect.
Fill-in reflector
Light diffusing panel
Wireless flash sensor
Flash head
AF-assist light
Accessories: Flash stand, Pouch
Pilot lamp (Test flash button)
On / Off switch (Press button)
Mode select button / indicator
(TTL Manual Slave 1 Slave 2) → →
Flash power level indication lamps (6 LEDs)
Flash power level select button
Lock ring
Mounting foot
Hotshoe contacts
Battery magazine
Nomenclature
Flash stand
Filter
guide
12-53
For 4/3 Digital Cameras
NOTE
Remove the battery magazine and
insert 4 x size AA batteries as shown
in the picture.
The battery compartment is designed
so that each cell is placed in same
direction to avoid the confusion in
poor light situation.
It is recommended to use all 4 batteries in same brand and type, and
replace them all at the same time. Wrong insertion of each cell does
not make electric contact.
+ / - symbol is clearly marked at the
battery compartment.
Place the battery magazine back
into the body.
Basic Operation
Inserting batteries
Mounting Di466 Four Thirds on the Camera
Removing Di466 Four Thirds from the Camera
NOTE
Before mounting or removing Di466 Four Thirds into or from the
camera, it is recommended to turn off the power switch of both Di466
Four Thirds and the camera.
Loosen the lock ring and slide the mounting foot of Di466 Four Thirds off
the hotshoe of the camera. Make sure to turn the lock ring all the way to
completely clear the lock pin off the hooking slot on the hotshoe.
Slide the mounting foot of Di466 Four
Thirds into the hotshoe of camera.
Turn the lock ring to loosen it as shown in
the picture.
Turn the lock ring to opposite direction
and tighten it.
Lock pin comes out to hook the foot at
the hotshoe for sure contact.
Turn on the flash unit
To save battery energy, the power is automatically turned off (to
stand-by mode), both in TTL mode & Manual Power mode, in about 2
minutes of idle use.
While Di466 Four Thirds is in the stand-by mode a Pilot lamp blinks
every 2 seconds showing the flash unit is in stand-by mode.
To turn on Di466 Four Thirds again, press the camera’s shutter button
halfway or press any button of the flash unit.
In case Di466 Four Thirds is not in use over 30 minutes, the unit is
completely turned off and shut out the current leakage from the
batteries.
To turn on Di466 Four Thirds again, take the first step of turning the
flash unit on.
In case of using Di466 Four Thirds as a slave flash (at slave mode*5),
Di466 Four Thirds will not go into the stand-by mode. It will however
automatically turn off when not used over 60 minutes.
*5: Slave mode : Refer instruction below.
Di466 Four Thirds has energy saving double power off function.
For a test flash, press the Pilot lamp. When using the test flash as an
open flash, please note that the reference guide number in this case is
G.No.10 (ISO 100).
To turn off the flash unit manually, press the On / Off switch for 2
seconds.
Press the On / Off switch and Pilot lamp
turns red showing the unit is turned on.
In a few seconds, the Pilot lamp turns
green. Di466 Four Thirds is ready to shoot.


Produkt Specifikationer

Mærke: Nissin
Kategori: Blitz
Model: Di466

Har du brug for hjælp?

Hvis du har brug for hjælp til Nissin Di466 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Blitz Nissin Manualer

Blitz Manualer

Nyeste Blitz Manualer

Neewer

Neewer RF1-N Manual

29 Marts 2025
Neewer

Neewer RF1-S Manual

29 Marts 2025
Bresser

Bresser BRM-300AM Manual

27 Marts 2025
SmallRig

SmallRig 4774 Manual

26 Februar 2025
Neewer

Neewer NW665 Manual

8 Januar 2025
Godox

Godox V100 S Manual

8 Januar 2025
Godox

Godox V100 O Manual

8 Januar 2025