NUVO Broadstone 60/8114 Manual

NUVO Ikke kategoriseret Broadstone 60/8114

Læs gratis den danske manual til NUVO Broadstone 60/8114 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om NUVO Broadstone 60/8114, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

FOR YOUR SAFETY

WARNING: BE SURE THE ELECTRICITY TO THE WIRES

YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS

REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.

GENERAL

You don’t need special tools to install this xture. Be sure to follow

the steps in the order given. Under no circumstances should a

xture be hung on house electrical wires, nor should a swag type

xture be installed on a ceiling which contains a radiant type heating

system. Read instructions carefully. If you are unclear as to how to

proceed, consult a qualied electrician.

NOTE: Proper wiring is essential for the safe operation of this xture.

FIXTURE ASSEMBLY

Carefully remove the xture from the carton and check that all parts

are included as shown in gure. Be careful not to misplace any of

the screws or parts, which are needed to install this xture.

INSTALLATION

STEP 1: While supporting the xture, connect the electrical wires.

If your post has a ground wire (green or bare copper), connect the

xture ground wire to it. If not, consult your electrician for proper

grounding. After the wires are connected, tuck them carefully inside

the post (A).

STEP 2: Place the xture onto pole, and secure with the 3 mounting

screws (C).

GROUNDING INSTRUCTIONS

STEP 1: Insert the green grounding screw into the hole with two

raised dimples on the mounting bar. Wrap the ground wire from the

xture (if supplied) around the green grounding screw, then connect

it to ground wire from the outlet box (if not xed on the outlet box)

using a wire connector (not supplied). If ground wire from the xture

is not supplied, wrap the ground wire (if not xed on the outlet box)

from the outlet box around the green grounding screw and tighten it.

NEVER CONNECT GROUND WIRE TO BLACK OR WHITE

POWER SUPPLY WIRES.

STEP 2: Take note of the color of the wire(s) on your xture. Identify

which group your xture wire(s) falls into and connect the wires

according to the directions below:

GROUP A:

Connect to Black House Wire

GROUP B:

Connect to White House Wire

BLACK WHITE

* PARALLEL WIRE (round & smooth) * PARALLEL WIRE (square & ridged)

WHITE OR GREY WITH TRACER WHITE OR GREY WITHOUT TRACER

BROWN, GOLD OR BLACK

WITHOUT TRACER

BROWN, GOLD OR BLACK

WITH TRACER

NOTE: When parallel wire (SPT-I & SPT-2) is used, the tracer wire is

square shaped or ridged and the less tracer wire is round in shape

or smooth (seen best when viewed from wire end.)

STEP 3: Take your xture wire(s) from group A and place evenly

against the black wire from the outlet box. Do NOT twist wires

together before using wire connectors.

STEP 4: Fit a wire connector over the wires and screw the

connector clockwise until you feel rmness.

STEP 5: Try gently to pull the connector off the wires. If you can pull

the connector off, carefully re-do steps 3 and 4 as above, and check

again for a rm connection.

STEP 6: Connect the xture wire from group B to the white wire

from the outlet box in the same manner. Make sure no bare wires

can be seen outside wire connectors.

FINAL ASSEMBLY

STEP 1: Take off the cage (F) and the glass (E) from the bottom

plate (D) by loosening loop (G).

STEP 2: Install Bulb E12 candelabra base (not included). Do not

exceed maximum wattage rating.

STEP 3: Attach the cage (F) and the glass (E) back to the bottom

plate (D) and secure loop (G).

CLEANING

To clean, wipe xture with a soft cloth. Clean glass with a mild soap.

Do not use abrasive materials such as scouring pads or powders,

steel wool or abrasive paper.

ORDERING PARTS

Keep this sheet for future reference, and in case you need to order

replacement parts. Be sure to use exact wording from illustration

when ordering parts.

Line art shown may not exactly match the xture enclosed. However, the installations

do apply to this xture.

La ilustración puede no concordar exactamente con la pieza enviada. Sin embargo,

las instalaciones sí aplican para esta pieza.

Les images peuvent ne pas correspondre exactement au luminaire de la boîte.

Par contre, les directives d’installation s’appliquent au luminaire.

INSTALLATION AND SAFETY INSTRUCTIONS

ITEM NO: 60-8114

ARTÍCULO Nº: 60-8114

ARTICLE N°: 60-8114

FIGURE

Produkt Specifikationer

Mærke:	NUVO
Kategori:	Ikke kategoriseret
Model:	Broadstone 60/8114

Har du brug for hjælp?

Hvis du har brug for hjælp til NUVO Broadstone 60/8114 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret NUVO Manualer

NUVO Starfish 65/940 Manual

19 December 2025

NUVO Broadstone 60/8114 Manual

22 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Yamazen RTPS-1515 Manual

27 December 2025

Reelcraft L 4545 123 7Q Manual

27 December 2025

Gamdias Aura GL360 Digital Manual

27 December 2025

Kenmore DU1265 Manual

27 December 2025

KoolStar Starter 950 Manual

25 December 2025

VOX SETSF5702B Manual

25 December 2025

Yamazen SUC-202 Manual

25 December 2025

Vaxcel OW37081 Manual

25 December 2025

Vaxcel T0253 Manual

25 December 2025

Reelcraft L 4525 123 7A Manual

25 December 2025