OneConcept Mic-700 Manual

OneConcept Mikrofon Mic-700

Læs gratis den danske manual til OneConcept Mic-700 (9 sider) i kategorien Mikrofon. Denne vejledning er vurderet som hjælpsom af 11 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 6 anmeldelser. Har du et spørgsmål om OneConcept Mic-700, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/9

BUS AUDIO IN

BUS CONTROL IN

3-261-849- (1)21

Cautions

• This unit is designed for negative earth 12 V DC

operation only.

• Do not get the leads under a screw, or caught in

moving parts (e.g. seat railing).

• Before making connections, turn the car ignition

off to avoid short circuits.

• Connect the power input leadsyellow and red

only after all other leads have been connected.

•Run all earth leads to a common earth point.

• Be sure to insulate any loose unconnected leads

with electrical tape for safety.

Notes on the power supply lead (yellow)

• When connecting this unit in combination with

other stereo components, the connected car

circuit’s rating must be higher than the sum of

each component’s fuse.

• When no car circuits are rated high enough,

connect the unit directly to the battery.

Parts Iist (1)

• The numbers in the list are keyed to those in the

instructions.

• The bracket 1 and the protection collar 5 are

attached to the unit before shipping. Before

mounting the unit, use the release keys to6

remove the bracket and the protection collar 1 5

from the unit. For details, see “Removing the

protection collar and the bracket ( )” on the4

reverse side of the sheet.

• Keep the release keys 6for future use as they

are also necessary if you remove the unit from

your car.

Caution

Handle the bracket carefully to avoid injuring1

your fingers.

Note

Before installing, make sure that the catches on both

sides of the bracket are bent inwards 2 mm. If the1

catches are straight or bent outwards, the unit

will not be installed securely and may spring out.

Connection example (2)

Notes (2-A)

• Be sure to connect the earth lead before connecting

the amplifier.

• If you connect an optional power amplifier and do not

use the built-in amplifier, the beep sound will be

deactivated.

Tip ( )2-B-

For connecting two or more CD/MD changers, the source

selector XA-C30 (optional) is necessary.

Installation/Connections

Instalación/Conexiones

安裝線路連接

FM AM/

Compact Disc

Player

Connection diagram (3)

1To a metal surface of the car

First connect the black earth lead, then connect the

yellow and red power input leads.

2To the power aerial control lead or power

supply lead of aerial booster amplifier

Notes

• It is not necessary to connect this lead if there is no

power aerial or aerial booster, or with a manually-

operated telescopic aerial.

• When your car has a built-in FM/AM aerial in the

rear/side glass, see “Notes on the control and

power supply leads.”

3To AMP REMOTE IN of an optional power

amplifier

This connection is only for amplifiers. Connecting

any other system may damage the unit.

4To the interface cable of a car telephone

5To the +12 V power terminal which is energized

in the accessory position of the ignition key

switch

Notes

• If there is no accessory position, connect to the +12

V power (battery) terminal which is energized at

all times.

Be sure to connect the black earth lead to a metal

surface of the car first.

• When your car has a built-in FM/AM aerial in the

rear/side glass, see “Notes on the control and

power supply leads.”

6To the +12 V power terminal which is energized

at all times

Be sure to connect the black earth lead to a metal

surface of the car first.

Notes on the control and power supply leads

• The power aerial control lead (blue) supplies +12 V DC

when you turn on the tuner.

• When your car has built-in FM/AM aerial in the rear/

side glass, connect the power aerial control lead (blue)

or the accessory power input lead (red) to the power

terminal of the existing aerial booster. For details,

consult your dealer.

• A power aerial without relay box cannot be used with

this unit.

Memory hold connection

When the yellow power input lead is connected, power

will always be supplied to the memory circuit even when

the ignition key is turned off.

Notes on speaker connection

• Before connecting the speakers, turn the unit off.

• Use speakers with an impedance of 4 to 8 ohms, and with

adequate power handling capacities to avoid its damage.

• Do not connect the speaker terminals to the car

chassis, or connect the terminals of the right speakers

with those of the left speaker.

• Do not connect the earth lead of this unit to the

negative (–) terminal of the speaker.

• Do not attempt to connect the speakers in parallel.

• Connect only passive speakers. Connecting active

speakers (with built-in amplifiers) to the speaker

terminals may damage the unit.

• To avoid a malfunction, do not use the built-in speaker

leads installed in your car if the unit shares a common

negative (–) lead for the right and left speakers.

• Do not connect the unit’s speaker leads to each other.

Note on connection

If speaker and amplifier are not connected correctly,

“FAILURE” appears in the display. In this case, make sure

the speaker and amplifier are connected correctly.

AUDIO OUT REAR

AUDIO OUT FRONT

BUS AUDIO IN

BUS CONTROL IN

Equipment used in illustrations (not supplied)

Equipo utilizado en las ilustraciones (no suministrado)

插圖中的裝置（非附送）

Rear speaker

Altavoz posterior

後揚聲器

Front speaker

Altavoz frontal

前揚聲器

Power amplifier

Amplificador de potencia

功率放大器

Active subwoofer

Subwoofer activo

有源超低音揚聲器

CDX-F5500X

Catch

Rotary commander RM-X4S

Mando rotativo RM-X4S

旋轉式控制器 RM-X4S

1 2

× 4

4 6 75

× 2

CD/MD changer

Cambiador de CD/MD

CD/MD 換碟機

Source selector*

Selector de fuente*

音源選擇器*

XA-C30

*not supplied

no suministrado

非附送

Produkt Specifikationer

Mærke:	OneConcept
Kategori:	Mikrofon
Model:	Mic-700

Har du brug for hjælp?

Hvis du har brug for hjælp til OneConcept Mic-700 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Mikrofon OneConcept Manualer

OneConcept BTF11 Manual

20 August 2024

OneConcept Mic-700 Manual

10 Juli 2024

Mikrofon Manualer

Nyeste Mikrofon Manualer

BONAOK Q37 Manual

2 November 2025

Phenyx Pro PTV-2000A Manual

2 November 2025

Saramonic Blink500T4 Manual

2 November 2025

Logitech Bluebird SL Manual

2 November 2025

2 November 2025

2 November 2025

2 November 2025

1 November 2025

Icon Space 103 Manual

31 Oktober 2025

Fifine AmpliGame AM8PROT Manual

30 Oktober 2025