Oregon Scientific RMR203HGA Manual

Oregon Scientific Vejrstation RMR203HGA

Læs gratis den danske manual til Oregon Scientific RMR203HGA (2 sider) i kategorien Vejrstation. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Oregon Scientific RMR203HGA, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/2
Temperature and Humidity Station
with Atomic Time
Model: RMR203HGA
USER MANUAL
EN
OVERVIEW
FRONT VIEW (FIG 1)
1. Remote sensor reception indicator
2. Clock signal reception indicator
3. : Change settings / display MODE
4. : Activate backlight for 5 seconds LIGHT
5. / : Increase / decrease settings; activate /
deactivate clock reception signal
6. Outdoor temperature and humidity
Wireless sensor included does not include humidity.
To receive outdoor humidity you need a wireless sensor with
the humidity function.
7. Indoor temperature and humidity
8. Time zone
9. Clock with weekday
10. : View current, maximum, minimum temperature / MEM
humidity
11. Ice alert LED indicator
BACK VIEW (FIG 2)
1. : Select temperature unit °C / °F
2. : Reset unit to default settings RESET
REMOTE SENSOR (FIG 3)
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. switch CHANNEL
GETTING STARTED
INSERT BATTERIES
1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see FIG 2).
LOCATION MEANING
Clock / alarm Main unit batteries low
Outdoor temperature Sensor batteries low
and humidity area
REMOTE SENSOR
The main unit can collect data from up to 3 sensors.
To set up the sensor:
1. Open the battery compartment (see FIG 3).
2. Select a channel then press . RESET
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
Ideal placements for the sensor would be in any TIP
location on the exterior of the home at a height of not more
than 5 ft and which can shield it from direct sunlight or wet
conditions for an accurate reading.
Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.
SENSOR DATA TRANSMISSION
To search for a sensor:
Press and hold + MODE simultaneously.
The sensor reception icon in the remote sensor area shows
the status:
ICON DESCRIPTION
Main unit is searching for sensor(s).
A channel has been found.
The sensor cannot be found.
TIP The transmission range may vary depending on many
factors. You may need to experiment with various locations
to get the best results.
CLOCK
CLOCK RECEPTION
This product is designed to synchronize its clock automatically
with WWVB-60 signal, within 3200km (2000 miles) of Fort
Collins Colorado.
To enable / disable signal reception:
Press and hold to enable or to disable signal
reception.
Reception takes 2-10 minutes. If the signal is weak,
it can take up to 24 hours to get a valid signal. If signal
reception is unsuccessful, place your unit next to a window,
press and hold to force another signal search.
Clock signal reception indicator:
STRONG SIGNAL WEAK SIGNAL NO SIGNAL
MANUALLY SET CLOCK
To set the clock manually, disable the signal reception first.
1. Press and hold .MODE
2. Press or to change the settings.
3. Press to confirm.MODE
4. The settings order is: time zone, 12/24 hr format, hour,
minute, year, calendar mode (day – month / month –
day), month, day and language.
Select the time zone: (P) Pacific, (E) Eastern, (C) Central or
(M) Mountain.
The language options are English (E), German (D),
French (F), Italian (I), and Spanish (S).
To select display mode:
Press to choose between clock with seconds / MODE
weekday / calendar.
TEMPERATURE AND HUMIDITY
To toggle temperature unit:
Press .°C / °F
To auto-scan between sensors:
Press and hold + MEM to display each sensor’s data
for 3 seconds.
To end press .
To toggle between current, minimum and maximum
records for the selected sensor:
Press repeatedly.MEM
To clear the records:
Press and hold .MEM
ICE WARNING
If the channel 1 sensor falls between 3°C to
-2 °C (37°F to 28°F), LED indicator will flash, and will stop
flashing once the temperature is out of this range.
BACKLIGHT
Press to activate backlight for 5 seconds.LIGHT
RESET
Press to return to the default settings.RESET
PRECAUTIONS
• Do not subject the unit to excessive force, shock, dust,
temperature or humidity.
• Do not cover the ventilation holes with any items such as
newspapers, curtains etc.
• Do not immerse the unit in water. If you spill liquid over
it, dry it immediately with a soft, lint-free cloth.
• Do not clean the unit with abrasive or corrosive
materials.
• Do not tamper with the unit’s internal components. This
invalidates the warranty.
• Only use fresh batteries. Do not mix new and old
batteries.
• Images shown in this manual may differ from the actual
display.
2
3
4
5
1
RMR203HGA_M_EN_R2.indd 1 2007.6.21 9:49:08 AM
P/N:086L004999-013 REV1
1/2
www.OregonScientificStore.com
• When disposing of this product, ensure it is collected
separately for special treatment.
• Placement of this product on certain types of wood
may result in damage to its finish for which Oregon
Scientific will not be responsible. Consult the furniture
manufacturer's care instructions for information.
• The contents of this manual may not be reproduced
without the permission of the manufacturer.
• Do not dispose old batteries as unsorted municipal
waste. Collection of such waste separately for special
treatment is necessary.
• Please note that some units are equipped with a
battery safety strip. Remove the strip from the battery
compartment before first use.
The technical specifications for this product and the
contents of the user manual are subject to change without
notice.
SPECIFICATIONS
TYPE DESCRIPTION
MAIN UNIT
L x W x H 73 x 47 x 132.5 mm
(2.87 x 1.85 x 5.22 in)
Weight 241 g (8.5 oz) without battery
Temperature range -5°C to 50°C (23°F to 122°F)
Resolution 0.1°C (0.2°F)
Signal frequency 433 MHz
Humidity range 25% - 95%
Humidity resolution 1%
Power 2 x UM-3 (AA) 1.5 V batteries
REMOTE UNIT (THN132N)
L x W x H 96 x 50 x 22 mm
(3.78 x 1.97 x 0.87 in)
Weight 62 g (2.22 ounces)
Transmission range 30 m (98 ft) unobstructed
Temperature range -20°C to 60°C (-4°F to 140°F)
Power 1 x UM-3 (AA) 1.5 V batteries
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientific.com) to learn more
about Oregon Scientific products. If you’re in the US and
would like to contact our Customer Care department directly,
please visit: www2.oregonscientific.com/service/support
OR
Call 1-800-853-8883.
For international inquiries, please visit: www2.oregonscientific.
com/about/international
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
WARNING Changes or modifications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV
technician for help.
DECLARATION OF CONFORMITY
The following information is not to be used as contact for
support or sales. Please call our customer service number
(listed on our website at www.oregonscientific.com, or on the
warranty card for this product) for all inquiries instead.
We
Name: Oregon Scientific, Inc.
Address: 19861 SW 95th Ave.,Tualatin,
Oregon 97062 USA
Telephone No.: 1-800-853-8883
declare that the product
Product No.: RMR203HGA
Product Name: Temperature and Humidity
Station with Atomic Time
Manufacturer: IDT Technology Limited
Address: Block C, 9/F, Kaiser Estate,
Phase 1,41 Man Yue St.,
Hung Hom, Kowloon,
Hong Kong
is in conformity with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1) This device may
not cause harmful interference. 2) This device must accept
any interference received, including interference that may
cause undesired operation.
© 2007 Oregon Scientific. All rights reserved.
P/N: 086L004999-013
RMR203HGA_M_EN_R2.indd 2 2007.6.21 9:49:09 AM
P/N:086L004999-013 REV1
2 2/

Produkt Specifikationer

Mærke: Oregon Scientific
Kategori: Vejrstation
Model: RMR203HGA

Har du brug for hjælp?

Hvis du har brug for hjælp til Oregon Scientific RMR203HGA stil et spørgsmål nedenfor, og andre brugere vil svare dig


Vejrstation Oregon Scientific Manualer

Oregon Scientific

Oregon Scientific BAR310HG Manual

12 Januar 2025
Oregon Scientific

Oregon Scientific BAR 898 Manual

11 Januar 2025
Oregon Scientific

Oregon Scientific WMR180 Manual

31 December 2025
Oregon Scientific

Oregon Scientific RMR203HG Manual

31 December 2025
Oregon Scientific

Oregon Scientific THC138 Manual

31 December 2025
Oregon Scientific

Oregon Scientific WMR 300 Manual

31 December 2025
Oregon Scientific

Oregon Scientific RAA 501 H Manual

31 December 2025
Oregon Scientific

Oregon Scientific Alizé BAR268HGA Manual

14 December 2024
Oregon Scientific

Oregon Scientific BAR206X Manual

2 September 2024
Oregon Scientific

Oregon Scientific BAR 888A Manual

1 September 2024

Vejrstation Manualer

Nyeste Vejrstation Manualer

Levenhuk

Levenhuk Wezzer SN10 Manual

17 Juni 2025
Levenhuk

Levenhuk Wezzer PH20 Manual

16 Juni 2025
Levenhuk

Levenhuk Wezzer Teo TH10 Manual

16 Juni 2025
Levenhuk

Levenhuk Wezzer Teo TH30 Manual

16 Juni 2025
Levenhuk

Levenhuk Wezzer Teo TH50 Manual

16 Juni 2025
Levenhuk

Levenhuk Wezzer Air PRO DM20 Manual

16 Juni 2025
Levenhuk

Levenhuk Wezzer Teo TH40 Manual

15 Juni 2025
Levenhuk

Levenhuk Wezzer PRO LP240 Manual

15 Juni 2025
Levenhuk

Levenhuk Wezzer BASE L50 Manual

15 Juni 2025
Levenhuk

Levenhuk Wezzer SN70 Manual

15 Juni 2025