OSD Audio Black MOV50-70V Manual

OSD Audio Ikke kategoriseret Black MOV50-70V

Læs gratis den danske manual til OSD Audio Black MOV50-70V (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 11 anmeldelser. Har du et spørgsmål om OSD Audio Black MOV50-70V, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

MOV5 70V

Weathe Proof 5 Watt 70V MONO

Outdoor Volume Control/Attenuator

Basic Connections:

1) All 70V Speaker Connections are in Parallel. The

MOV50-70V has two options for connecting to the

70Volt Amplifier. Number one, , features a Daisy Chain

single connection from the Amplifier (like our PA270

AMP/MIXER) to the first Attenuator. The two-conductor

wire splits between connecting to the first Attenuator

and Second Attenuator. This step will be repeated,

depending on how many Attenuators are connecting.

Number 2, , has a two-the Home Run connection

conductor wire coming from each Attenuator back to

the 70V Amplifier. Our PAM245 features 1 to 5 channel

connections where the cables will be home run from

each of the individual Attenuator back the respective

five-channel connections.

3) The Common and Output of each Attenuator

connects to the Common and desired color- coded

wattage wire on the Primary of the 70 Volt Transformer.

Or the Common and Output of each attenuator

connects to the negative (black) and Positive (red) for a

speaker with built in transformer. Then the wattage is

set with the selector the Home Run connection featured

on next page below)

Transformer

Waterproof

Housing

Input

from Amplifier

Output

to Speakers

Rotary

Knob

Option 1: Daisy Chain, single Amp connection

2) The Common and 70Volt outputs of the Amplifier

connect to the Common and Input of each Attenuator

whether all are coming directly from the Amplifier in

“Home Run” or from the Attenuator to the previous

Attenuator in the “Daisy Chain”

10 Step,

33dB Plus Full Off

OSD Audio · 775 Columbia St., Brea CA 92821 · www.osdaudio.com

OSD Audio Limited Warranty

OSD Audio will repair or replace any defect it in material

or workmanship which occurs during normal use of this

product with new or rebuilt parts free of charge in the

US for five years from date of original purchase. This

warranty does not cover damages in shipment, failure

caused by other products not supplied by OSD Audio or

failures due to accident, misuse, or alteration of the

equipment. This warranty is extended only to the

original purchaser and a purchase receipt, invoice or

other proof of original date will be required before

warranty repairs are provided

Mail in service can be obtained during period by

emailing . A return authorization

RMA@osdaudio.com

number must be obtained in advance and be marked on

the outside of the shipping carton.

This warranty gives you specific legal rights and may

have other rights (which vary from state to state). If a

problem with this product develops during or after the

warranty period please contact OSD Audio or your

dealer

OSD Audio · 775 Columbia St., Brea CA 92821 · www.osdaudio.com

Power Rating:

The MOV50-70V is rated at 50W so the speaker(s)

connected to it needs to total 50 watts or less for each

of each Attenuators.

Picking the right Distribution Amplifier:

The amplifier must have a 70Volt output. It must have

an output power rating equal to or higher than the total

wattage of the system after you have calculated the

total number of watts for all the speakers combined. If

you had four speakers at 5 watts each (20 total) and one

speaker set to 10 watts (20 + 10 = 30), your amplifier

must be rated at least 30 watts minimum. If you had five

speakers at 10 watts each (50 total) and another 5 five

speakers at 5 watts each (25 + 50 = 75), you would need

an amplifier rated at a minimum 75 watts.

Note: the total wattage of your system with all speakers

combined should be 80 to 90 percent of the rated

power of the amplifier. Our PAM245 is 240 Watts. 80%

to 90% is 192watts to 216 watts. Your system must total

less than the 216 watts at a minimum.

MOV5 70V

Weathe Proof 5 Watt 70V MONO

Outdoor Volume Control/Attenuator

Option 2: Home Run, for Multiple Connections to the Amp/Mixer/Preamp like the PAM245 with its Five Channel Output

Produkt Specifikationer

Mærke:	OSD Audio
Kategori:	Ikke kategoriseret
Model:	Black MOV50-70V

Har du brug for hjælp?

Hvis du har brug for hjælp til OSD Audio Black MOV50-70V stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret OSD Audio Manualer

OSD Audio Black S80 MK2 Manual

23 Juli 2025

OSD Audio SKR120 Manual

22 Juli 2025

OSD Audio BK50W70T Manual

21 Juli 2025

OSD Audio SVC-300 Manual

21 Juli 2025

OSD Audio C1070V Manual

20 Juli 2025

OSD Audio SVC405 Manual

20 Juli 2025

OSD Audio Black NC10 Manual

19 Juli 2025

OSD Audio Black NCR10 Manual

18 Juli 2025

OSD Audio Black NC5LCR Manual

18 Juli 2025

OSD Audio Black NC6 Manual

18 Juli 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

LC-Power LC6550B-SI V3.1 Manual

13 August 2025

Adj FX Beam Manual

13 August 2025

Rowenta Gourmet Pro OC7888 Manual

13 August 2025

American Audio ActivePod Manual

13 August 2025

Adj Galaxian Gem LED Manual

13 August 2025

American Audio DCD-PRO600 Manual

13 August 2025

Asus PEN SA201H Manual

13 August 2025

American Audio Revo II Manual

13 August 2025

Rowenta Perfecto Combi ES4210 Manual

13 August 2025

American Audio CPX 12A Manual

13 August 2025