Ozito PXUBP-520 Manual

Ozito Batteri PXUBP-520

Læs gratis den danske manual til Ozito PXUBP-520 (2 sider) i kategorien Batteri. Denne vejledning er vurderet som hjælpsom af 11 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 6 anmeldelser. Har du et spørgsmål om Ozito PXUBP-520, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR

YOUR BATTERY.

1. Before using the charger read all instructions and cautionary markings on the charger, battery

pack and the product using the battery pack.

2. This charger is not intended for any uses other than charging Ozito Power X Change rechargeable

batteries. Any other use may result in risk of re, electric shock or electrocution.

3. Do not place any object on top of the charger or place the charger on a soft surface that may

result in excessive internal heat. Place the charger in a position away from any heat source.

4. To reduce risk of damage to the electric plug and cord, pull by the plug rather than the cord when

disconnecting the charger.

5. Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise

subjected to damage or stress.

6. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord

could result in the risk of re, electric shock or electrocution.

7. Do not operate the charger if it has received a sharp blow, been dropped or otherwise damaged in

any way. Have it checked by an electrician or power tool repairer.

8. Do not disassemble charger. Take it to an electrician or power tool repairer when service or repair

is required. Incorrect reassembly may result in a risk of electric shock, electrocution or re.

9. To reduce risk of electric shock, unplug the charger from the outlet before attempting any clean-

ing. Removing the battery pack will not reduce this risk.

10. Never attempt to connect 2 chargers together.

11. The charger is designed to operate on standard household electrical power (240 volts). Do not

attempt to use it on any other voltage!

12. The battery pack is not fully charged out of the carton. First read the safety instructions and then

follow the charging notes and procedures.

13. DO NOT STORE OR USE the battery pack in locations where the temperature may reach below 0ºC

or exceed 50ºC (such as inside sheds or metal buildings in summer). This is important and will

prevent damage to the battery pack.

14. Do not incinerate the battery pack even if it is seriously damaged or is completely worn out. The

battery can explode in a re.

15. Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks

or cracks, immediately discontinue use and do not recharge.

16. During charging, the battery must be placed in a well ventilated area.

BATTERY SAFETY WARNINGS

ELECTRICAL SAFETY

WARNING! When using mains-powered tools, basic safety precautions,

including the following, should always be followed to reduce risk of re, electric

shock, personal injury and material damage.

Read the whole manual carefully and make sure you know how to switch the tool off in an

emergency, before operating the tool.

Save these instructions and other documents supplied with this tool for future reference.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and

New Zealand.

This tools charger is double insulated, therefore no earth wire is required.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or

similarly qualied persons in order to avoid hazard.

Note: Double insulation does not take the place of normal safety precautions when

operating this tool. The insulation system is for added protection against injury resulting

from a possible electrical insulation failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool. Before

use, inspect the extension lead for signs of damage, wear and ageing. Replace the

extension lead if damaged or defective.

When using an extension lead on a reel, always unwind the lead completely. Use of an

extension lead not suitable for the power input of the tool or which is damaged or defective

may result in a risk of re and electric shock.

To reduce the risk of electric shock, we recommend the use of a residual current device

(rated 30mA or less).

This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance by a person responsible for

their safety.

Children should be supervised to ensure that they do not play with the appliance.

SPECIFICATIONS

Input: 18V

Battery Capacity: 5.2Ah Li-ion

Power Consumption: 94Wh

Weight: 0.88kg

1. Battery

2. Battery Release Button

3. Charge Indicator Button

ozito.com.au

CARING FOR THE ENVIRONMENT

Power tools that are no longer usable should not be disposed of with

household waste but in an environmentally friendly way. Please recycle

where facilities exist. Check with your local council authority for

recycling advice.

Recycling packaging reduces the need for landll and raw materials.

Reuse of recycled material decreases pollution in the environment.

Please recycle packaging where facilities exist. Check with your local

council authority for recycling advice.

DESCRIPTION OF SYMBOLS

Warning

Do not store or use battery in

temperatures exceeding 50 C°

Volts Hertz

Alternating Current

Direct Current

Milliamperes

Watts

Amp Hour

HzV

ac/~

Lithium Ion Battery

Do not put in the rubbish

Do not get battery wet

Recycle Battery

Do not incinerate

Regulatory Compliance

Mark (RCM)

Do not store battery when the charge

is low; store between 40-60%.

40-60%

5.2Ah BATTERY

INSTRUCTION MANUAL

PXUBP-520

BATTERY CHARGE INDICATOR

The purchased battery is equipped with a

battery charge indicator to show the state of

the battery charge.

Press the charge indicator button and look to

see which LED lights.

Battery requires immediate charging

Low state of charge, requires charging soon.

Mid state of charge

Full state of charge.

Note: The battery needs to be removed from the tool to check the state of charge.

BATTERY PROTECTION SYSTEM

The tool is equipped with a battery protection system, which helps to ensure longevity

of the battery.

The output power automatically cuts off during operation when the tool and/or battery

are placed under the following situations:

• When the tool is overloaded:

If this occurs, release the trigger switch and remove causes of overload, then pull

the switch trigger again to restart.

• When the remaining battery capacity becomes low:

Recharge the battery pack.

Note: The battery protection system does not in any way damage the tool.

Note: The indicated capacity may be lower than the actual level during use or

immediately after using the tool.

1. OPERATION WARRANTY

IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY YOU

MUST RETURN THE PRODUCT TO YOUR NEAREST BUNNINGS

WAREHOUSE WITH YOUR BUNNINGS REGISTER RECEIPT. PRIOR TO

RETURNING YOUR PRODUCT FOR WARRANTY PLEASE TELEPHONE

OUR CUSTOMER SERVICE HELPLINE:

Australia 1800 069 486

New Zealand 0508 069 486

TO ENSURE A SPEEDY RESPONSE PLEASE HAVE THE MODEL

NUMBER AND DATE OF PURCHASE AVAILABLE. A CUSTOMER

SERVICE REPRESENTATIVE WILL TAKE YOUR CALL AND

ANSWER ANY QUESTIONS YOU MAY HAVE RELATING TO THE

WARRANTY POLICY OR PROCEDURE.

The benets provided under this warranty are in addition to other rights and

remedies which are available to you at law.

Our goods come with guarantees that cannot be excluded at law. You are

entitled to a replacement or refund for a major failure and for compensation

for any other reasonably foreseeable loss or damage. You are also entitled to

have the goods repaired or replaced if the goods fail to be of acceptable

quality and the failure does not amount to a major failure.

Generally you will be responsible for all costs associated with a claim under

this warranty, however, where you have suffered any additional direct loss as

a result of a defective product you may be able to claim such expenses by

contacting our customer service helpline above.

36 MONTH REPLACEMENT WARRANTY

Your product is guaranteed for a period of 36 months from the original date

of purchase and is intended for DIY (Do It Yourself) use only. If a product is

defective it will be replaced in accordance with the terms of this warranty.

Warranty excludes consumable parts.

WARNING

The following actions will result in the warranty being void.

• If the tool has been operated on a supply voltage other than that specied

on the tool.

• If the tool shows signs of damage or defects caused by or resulting from

abuse, accidents or alterations.

• Failure to perform maintenance as set out within the instruction manual.

• If the tool is disassembled or tampered with in any way.

OZITO Australia/New Zealand (Head Ofce)

1-23 Letcon Drive, Bangholme, Victoria, Australia 3175.

CHARGING YOUR LITHIUM ION BATTERY

This battery has been shipped in a low charge condition, and requires charging prior to

use. Allow several cycles of charging and discharging (through use with a compatible

tool) for the battery to reach its optimum performance / runtime.

This battery is compatible with chargers from the 18V Ozito Power X Change range

available through your local Bunnings Warehouse; product availability may differ.

Only use the battery pack with Ozito Power X Change 18V cordless products.

1. Insert the power plug of the charger into the mains socket outlet. The green LED

will begin to ash when properly connected to power supply.

2. Insert the battery pack into the battery charger .

3. Remove battery from the charger once fully charged. Disconnect the charger from

the power supply.

Note: The battery pack can become a little warm during the charging. This is normal.

If the battery pack fails to charge, check:

if there is voltage at the socket outlet

that the battery and charger are properly connected.

If the battery pack still fails to charge, please contact our customer service center.

ONLINE MANUAL

Scan this QR Code with your

mobile device to take you to the

online manual.

PXUBP-520

0219

Produkt Specifikationer

Mærke:	Ozito
Kategori:	Batteri
Model:	PXUBP-520

Har du brug for hjælp?

Hvis du har brug for hjælp til Ozito PXUBP-520 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Batteri Ozito Manualer

Ozito PXBP-340 Manual

9 August 2025

Ozito PXUBP-520 Manual

2 Februar 2024

Ozito PXBC-400C Manual

5 December 2023

Ozito PXCG-USB Manual

10 September 2023

Ozito PXBC-250C Manual

22 Oktober 2022

Ozito PXBP-400 Manual

12 Oktober 2022

Batteri Manualer

Nyeste Batteri Manualer

Milwaukee M12 48-59-2401 Manual

12 August 2025

Snow Joe 24V-SS12-BDL Manual

12 August 2025

Makita PDC1200 Manual

11 August 2025

Sony LBP-HM1 Manual

10 August 2025

Milwaukee M12 B2 Manual

9 August 2025

Milwaukee MXF HD812 Manual

8 August 2025

APC LIBSMG95SUL1PH Manual

6 August 2025

Blaupunkt CR2016 Manual

4 August 2025

Blaupunkt CR2025 Manual

4 August 2025

Guede ProVolt APPV 18-20 Manual

3 August 2025