Philips Avent SCD809 Manual

Philips Baby-produkt Avent SCD809

Læs gratis den danske manual til Philips Avent SCD809 (14 sider) i kategorien Baby-produkt. Denne vejledning er vurderet som hjælpsom af 51 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 26 anmeldelser. Har du et spørgsmål om Philips Avent SCD809, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/14

English

For your child’s safety and health

Warning!

-Always use this product with adult

supervision.

-Never use feeding teats as a soother,

to prevent choking hazard.

-Continuous and prolonged sucking of

uids will cause tooth decay.

-Always check food temperature before

feeding.

-It is not recommended to use a

microwave to warm up your baby‘s food

or drinks. Microwaves might alter the

quality of food/drinks and destroy some

valuable nutrients and it may produce

localized high temperatures. Therefore,

take extra care if and when you heat up

food in a microwave.

-When heating up liquid or food in the

microwave, only place the container

without screw ring, AirFree™ vent insert,

teat and cap. Always stir heated food to

ensure even heat distribution and check

the temperature before serving.

-Keep all components not in use out of

the reach of children.

-Do not allow child to play with small parts

or walk/run while using bottles or cups.

-Do not place product in a heated oven.

-Drinks other than milk and water, such

as fruit juices and avored sugary drinks,

are not recommended. If used, they

should be well diluted and only used for

limited periods, not constantly sipped.

-Expressed breast milk can be stored

in sterilized Philips Avent bottles/

containers in the refrigerator for up to

48 hours (not in the door) or in the

freezer for up to 3 months. Never

refreeze breast milk or add fresh breast

milk to already frozen milk.

-Always discard any breast milk that is

left over at the end of a feed.

-Do not use abrasive cleaning agents or

anti-bacterial cleaners. Do not place

components directly on surfaces that have

been cleaned with anti-bacterial cleaners.

4213.354.3991.1 (12/17)

www.philips.com/avent

Philips Consumer Lifestyle BV

Tussendiepen 4, 9206 AD Drachten,

Netherlands / Pays-Bas

Trademarks owned by the Philips Group /

Marque déposée du groupe Philips

Marchio ownd da Philips Group

www.philips.com

-Plastic material properties may be aected

by sterilizing and high temperatures.

This can aect the t of the cap.

-Inspect before each use and pull the

feeding teat in all directions.Throw away

any part at the rst signs of damage or

weakness.

-Do not alter the product or parts of it

in any way. This may result in unsafe

functioning of the product.

AirFree™ vent insert

Benet: The AirFree™ vent insert keeps the

teat full of milk during feeding, even while

the bottle is held horizontally. This supports

an upright feeding position for your baby

in order to reduce air ingestion. This helps

reduce common feeding issues including

wind and reux (GER).

Assembly: Place the AirFree™ vent insert in

the bottle before you assemble the screw

ring with teat.

Warning: When you prepare formula, make

sure that all the formula is fully dissolved to

avoid blocking the AirFree™ vent insert.

Note: Always make sure the teat is full of

milk by turning the bottle upside down

before feeding your baby. While feeding,

make sure that the AirFree™ vent insert

points upwards, in line with your baby‘s

nose (see image).

Compatibility: The AirFree™ vent insert only

works with 4 oz/125 ml, 9 oz/260 ml and

11 oz/330 ml Philips Avent Anti-colic bottle

and Classic+ bottles, teat and screw ring.

The AirFree™ vent insert is not compatible

with the (I/II/III) variable ow teat and the

Natural bottle range.

Note: When using an 11 oz/330 ml bottle, the

AirFree™ vent insert insert will keep the teat

full of milk but it could be that you see fewer

air bubbles.

Philips Avent Anti-colic bottles and Classic+

bottles can also be used without the

AirFree™ vent insert.

Before rst and every use

Disassemble all parts and clean them

in warm soapy water and rinse them

thoroughly. Sterilize the parts in boiling

water for 5 minutes or by using a Philips

Avent sterilizer. This is to ensure hygiene.

During sterilizing in boiling water, make

sure that the pan contains enough water

and prevent the bottle or other parts from

touching the side of the pan. This can cause

irreversible product deformation, defect or

damage that Philips cannot be held liable

for. Make sure that you wash your hands

thoroughly and that the surfaces are clean

before contact with sterilized parts. Place

all bottle parts on a clean paper towel or

on a clean drying rack and allow them to air

dry. Excessive concentration of detergents

may eventually cause plastic components

to crack. Should this occur, replace

immediately. This product is dishwasher safe

- food colourings may discolour parts. Clean

and sterilize all parts before each use. For

hygiene reasons, we recommend replacing

teats after 3 months.

Assembly

When you assemble the bottle, make sure

you place the cap vertically onto the bottle

so that the teat sits upright (see image for

more details). The teat is easier to assemble

if you wriggle it upwards instead of pulling it

up in a straight line.

Maintenance teat and AirFree™ vent insert

Do not leave a feeding teat and/or AirFree™

vent insert in direct sunlight or heat, or

leave in disinfectant (‘sterilizing solution’)

for longer than recommended, as this may

weaken the parts. Keep parts in dry, covered

container.

Choosing the right teat for your baby

The Philips Avent teats are separately

available with dierent ow rates to help your

baby with drinking. Over time you can change

the teat accommodating the individual needs

of your baby. Philips Avent teats are clearly

numbered on the side to indicate ow rate.

Make sure you use a teat with the correct

ow rate when you feed your baby. Use a

lower ow rate if your baby chokes, is leaking

milk or has trouble adjusting to the drinking

speed. Use a higher ow rate if your baby

falls asleep during feeding, gets frustrated

or when feeding takes a very long time.

Produkt Specifikationer

Mærke:	Philips
Kategori:	Baby-produkt
Model:	Avent SCD809

Har du brug for hjælp?

Hvis du har brug for hjælp til Philips Avent SCD809 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Baby-produkt Philips Manualer

Philips Avent Ultra Air SCF085 Manual

8 Juni 2025

Philips Avent SCF093 Manual

30 Marts 2025

Philips Avent SCD308 Manual

26 Marts 2025

Philips Avent SCF354 Manual

15 Januar 2025

Philips Avent SCF377 Manual

15 Januar 2025

Philips AVENT SCD657 Manual

24 December 2024

Philips SCD271 Manual

6 December 2024

Philips AVENT SCF608 Manual

1 September 2024

Philips Avent SCF166 Manual

1 September 2024

Philips AVENT SCF972 Manual

1 September 2024

Baby-produkt Manualer

Nyeste Baby-produkt Manualer

Chipolino Mermaid Manual

17 Juni 2025

Chipolino Hippo Manual

17 Juni 2025

Chipolino Cars Manual

17 Juni 2025

Chipolino Lambada Manual

15 Juni 2025

Baby Trend Comet Stellar 3-in-1 Quick-Fold Playard Manual

14 Juni 2025

Baby Trend Simply Smart 2.0 Nursery Center Manual

14 Juni 2025

Baby Trend Fitted Sheets Manual

13 Juni 2025

Childhome Eltra Manual

8 Juni 2025

Thermobaby Daphne Manual

8 April 2025

Ikea GULDVÄVARE 705.736.94 Manual

3 April 2025