Philips Avent SCF813 Manual

Philips Baby-produkt Avent SCF813

Læs gratis den danske manual til Philips Avent SCF813 (14 sider) i kategorien Baby-produkt. Denne vejledning er vurderet som hjælpsom af 15 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 8 anmeldelser. Har du et spørgsmål om Philips Avent SCF813, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/14
English
For your child’s safety and health
Warning!
-Always use this product with adult
supervision.
-Never use feeding teats as a soother,
to prevent choking hazard.
-Continuous and prolonged sucking of
uids will cause tooth decay.
-Always check food temperature before
feeding.
-It is not recommended to use a
microwave to warm up your baby‘s food
or drinks. Microwaves might alter the
quality of food/drinks and destroy some
valuable nutrients and it may produce
localized high temperatures. Therefore,
take extra care if and when you heat up
food in a microwave.
-When heating up liquid or food in the
microwave, only place the container
without screw ring, AirFree™ vent insert,
teat and cap. Always stir heated food to
ensure even heat distribution and check
the temperature before serving.
-Keep all components not in use out of
the reach of children.
-Do not allow child to play with small parts
or walk/run while using bottles or cups.
-Do not place product in a heated oven.
-Drinks other than milk and water, such
as fruit juices and avored sugary drinks,
are not recommended. If used, they
should be well diluted and only used for
limited periods, not constantly sipped.
-Expressed breast milk can be stored
in sterilized Philips Avent bottles/
containers in the refrigerator for up to
48 hours (not in the door) or in the
freezer for up to 3 months. Never
refreeze breast milk or add fresh breast
milk to already frozen milk.
-Always discard any breast milk that is
left over at the end of a feed.
-Do not use abrasive cleaning agents or
anti-bacterial cleaners. Do not place
components directly on surfaces that have
been cleaned with anti-bacterial cleaners.
4213.354.3991.1 (12/17)
www.philips.com/avent
Philips Consumer Lifestyle BV
Tussendiepen 4, 9206 AD Drachten,
Netherlands / Pays-Bas
Trademarks owned by the Philips Group /
Marque déposée du groupe Philips
© 2017 Koninklijke Philips N.V.
All rights reserved
Marchio ownd da Philips Group
© 2017 Koninklijke Philips N.V.
Tutti i diritti riservati
www.philips.com
-Plastic material properties may be aected
by sterilizing and high temperatures.
This can aect the t of the cap.
-Inspect before each use and pull the
feeding teat in all directions.Throw away
any part at the rst signs of damage or
weakness.
-Do not alter the product or parts of it
in any way. This may result in unsafe
functioning of the product.
AirFree™ vent insert
Benet: The AirFree™ vent insert keeps the
teat full of milk during feeding, even while
the bottle is held horizontally. This supports
an upright feeding position for your baby
in order to reduce air ingestion. This helps
reduce common feeding issues including
wind and reux (GER).
Assembly: Place the AirFree™ vent insert in
the bottle before you assemble the screw
ring with teat.
Warning: When you prepare formula, make
sure that all the formula is fully dissolved to
avoid blocking the AirFree™ vent insert.
Note: Always make sure the teat is full of
milk by turning the bottle upside down
before feeding your baby. While feeding,
make sure that the AirFree™ vent insert
points upwards, in line with your baby‘s
nose (see image).
Compatibility: The AirFree™ vent insert only
works with 4 oz/125 ml, 9 oz/260 ml and
11 oz/330 ml Philips Avent Anti-colic bottle
and Classic+ bottles, teat and screw ring.
The AirFree™ vent insert is not compatible
with the (I/II/III) variable ow teat and the
Natural bottle range.
Note: When using an 11 oz/330 ml bottle, the
AirFree™ vent insert insert will keep the teat
full of milk but it could be that you see fewer
air bubbles.
Philips Avent Anti-colic bottles and Classic+
bottles can also be used without the
AirFree™ vent insert.
Before rst and every use
Disassemble all parts and clean them
in warm soapy water and rinse them
thoroughly. Sterilize the parts in boiling
water for 5 minutes or by using a Philips
Avent sterilizer. This is to ensure hygiene.
During sterilizing in boiling water, make
sure that the pan contains enough water
and prevent the bottle or other parts from
touching the side of the pan. This can cause
irreversible product deformation, defect or
damage that Philips cannot be held liable
for. Make sure that you wash your hands
thoroughly and that the surfaces are clean
before contact with sterilized parts. Place
all bottle parts on a clean paper towel or
on a clean drying rack and allow them to air
dry. Excessive concentration of detergents
may eventually cause plastic components
to crack. Should this occur, replace
immediately. This product is dishwasher safe
- food colourings may discolour parts. Clean
and sterilize all parts before each use. For
hygiene reasons, we recommend replacing
teats after 3 months.
Assembly
When you assemble the bottle, make sure
you place the cap vertically onto the bottle
so that the teat sits upright (see image for
more details). The teat is easier to assemble
if you wriggle it upwards instead of pulling it
up in a straight line.
Maintenance teat and AirFree™ vent insert
Do not leave a feeding teat and/or AirFree™
vent insert in direct sunlight or heat, or
leave in disinfectant (‘sterilizing solution’)
for longer than recommended, as this may
weaken the parts. Keep parts in dry, covered
container.
Choosing the right teat for your baby
The Philips Avent teats are separately
available with dierent ow rates to help your
baby with drinking. Over time you can change
the teat accommodating the individual needs
of your baby. Philips Avent teats are clearly
numbered on the side to indicate ow rate.
Make sure you use a teat with the correct
ow rate when you feed your baby. Use a
lower ow rate if your baby chokes, is leaking
milk or has trouble adjusting to the drinking
speed. Use a higher ow rate if your baby
falls asleep during feeding, gets frustrated
or when feeding takes a very long time.

Produkt Specifikationer

Mærke: Philips
Kategori: Baby-produkt
Model: Avent SCF813

Har du brug for hjælp?

Hvis du har brug for hjælp til Philips Avent SCF813 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Baby-produkt Philips Manualer

Philips

Philips Avent ultra soft SCF091 Manual

14 August 2025
Philips

Philips Avent SCY965 Manual

9 Juli 2025
Philips

Philips Avent SCF224 Manual

6 Juli 2025
Philips

Philips Avent SCF797 Manual

25 Juni 2025
Philips

Philips Avent Ultra Air SCF085 Manual

8 Juni 2025
Philips

Philips Avent SCF093 Manual

30 Marts 2025
Philips

Philips Avent SCF076 Manual

26 Marts 2025
Philips

Philips Avent SCD308 Manual

26 Marts 2025
Philips

Philips Avent SCY963 Manual

13 Marts 2025
Philips

Philips Avent SCY962 Manual

13 Marts 2025

Baby-produkt Manualer

Nyeste Baby-produkt Manualer

Jane

Jane Anti-choking feeder Manual

11 August 2025
Foppapedretti

Foppapedretti Jubox Manual

6 August 2025
Thule

Thule Sleek Bassinet Manual

2 August 2025
Thule

Thule Sapling Elite Manual

2 August 2025
Ikea

Ikea BÖRJA 405.968.14 Manual

29 Juli 2025
Ikea

Ikea BÖRJA 005.968.11 Manual

29 Juli 2025
Stokke

Stokke Limas Carrier Manual

28 Juli 2025
Stokke

Stokke Sleepi Changing Table Manual

27 Juli 2025
Ikea

Ikea MATA 905.969.39 Manual

27 Juli 2025
Evenflo

Evenflo Soft Infant Manual

25 Juli 2025