Posiflex CD-3602U Manual
Posiflex
Stregkodelæser
CD-3602U
Læs nedenfor 📖 manual på dansk for Posiflex CD-3602U (21 sider) i kategorien Stregkodelæser. Denne guide var nyttig for 17 personer og blev bedømt med 3.5 stjerner i gennemsnit af 9 brugere
Side 1/21
1
Package Contents
CD- 2U 360
2D image scanner
USB cable
Quick setup guide
CD- 2R 360
2D image scanner
RS-232 cable
Quick setup guide
Parts of the 2D Image Scanner
Trigger Button1
Scan Window
w/ Object Detector
Mounting Screw Hole
Beeper Hole
Interface Cable Connector
CD- 2 (U/R) 360
2D Image Scanner
Quick Setup Guide
CD-3602U/R Ver. A0
2
Scanner Maintenance
The scanner is designed for long-term trouble-free operation and rarely
requires any maintenance. Only an occasional cleaning of the scanner window
is necessary in order to remove dirt and ngerprints.
Wipe the scan window with a soft lint-free cloth and a non-abrasive cleaner to
avoid the scan window from being scratch and damag . The scan window ed ed
can be cleaned while the scanner is running.
The standard interface cable is attached to the scanner with a 10-pin modular
connector. When the connector is properly seated, it is secured in the scanner
by a exible retention tab. The cable is designed to be eld replaceable.
Replacement cables can be obtained from your authorized distributor. To
replace the cable, take the following steps.
1. Make sure the power of both the host terminal and the scanner is powered
o.
2. Disconnect the old scanner cable from the host terminal.
3. Press down the retention tab, and gently pull out the cable.
4. Insert the new interface cable into the bottom of the scanner until it clicks.
Then, plug the new cable into the host.
Troubleshooting
This section contains information about how to solve problems that you may
encounter when operating the scanner. If a trouble occurs please refer to the ,
following diagnostic tips as a mean to solve the trouble. However, before
referring to the tips, make sure that the scanner is installed well. If the problem
remains, contact your dealer.
Problem
Diagnostic Tips
The scanner is on but cannot read
any barcode.
The scanner window is dirty. Clean the scanner
window as described in the Scanner
Maintenance section.
The presented barcode type is not enabled. Use
this guide to tell the scanner to accept that type
of barcode.
The host terminal has disabled the scanner.
Check the setup of host terminal.
The barcode type presented is not supported by
the scanner.
The scanner does not accept more
than two or three barcode labels.
Determine whether the required barcode types
are enabled or not.
Produkt Specifikationer
| Mærke: | Posiflex |
| Kategori: | Stregkodelæser |
| Model: | CD-3602U |
Har du brug for hjælp?
Hvis du har brug for hjælp til Posiflex CD-3602U stil et spørgsmål nedenfor, og andre brugere vil svare dig
Stregkodelæser Posiflex Manualer
18 September 2024
6 September 2024
6 September 2024
12 August 2024
9 August 2024
8 August 2024
8 August 2024
7 August 2024
6 August 2024
6 August 2024
Stregkodelæser Manualer
- Stregkodelæser Steren
- Stregkodelæser CipherLab
- Stregkodelæser Newland
- Stregkodelæser Adesso
- Stregkodelæser Baracoda
- Stregkodelæser Palm
- Stregkodelæser Brady
- Stregkodelæser Qian
- Stregkodelæser Honeywell
- Stregkodelæser Motorola
- Stregkodelæser Psion
- Stregkodelæser Qoltec
- Stregkodelæser König
- Stregkodelæser Socket Mobile
- Stregkodelæser Mach Power
Nyeste Stregkodelæser Manualer
24 Marts 2025
24 Marts 2025
26 Februar 2025
23 Februar 2025
23 Februar 2025
23 Februar 2025
23 Februar 2025
23 Februar 2025
21 Februar 2025
20 Februar 2025