Privileg P0B ECO D551 X Manual

Privileg Opvaskemaskine P0B ECO D551 X

Læs gratis den danske manual til Privileg P0B ECO D551 X (16 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Privileg P0B ECO D551 X, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
EN
1
APPLIANCE
PRODUCT DESCRIPTION
1. Upper rack
2. Cutlery rack
3. Foldable aps
4. Upper rack height adjuster
5. Upper spray arm
6. Lower rack
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
4
1
3
2
965 7 8 1210 1311
DAILY REFERENCE
GUIDE
CONTROL PANEL
0000 000 00000
Service:
1
4
5
6
11
7
12
8
9
2
3
10
1. On-O / Reset button with indicator light
2. Program selection button with indicator light
3. Multizone button with indicator light / Tablet (Tab)
4. Eco program indicator light
5. Display
6. Program number and remaining time indicator
7. Tablet (Tab) indicator light
8. Closed water tap indicator light
9. Rinse Aid rell indicator light
10. Salt rell indicator light
11. Push&Go button with indicator light
12. Delay button with indicator light
13. Start/Pause button with indicator light / Drain out
PLEASE SCAN THE QR CODE
ON YOUR APPLIANCE IN ORDER
TO HAVE MORE DETAILED
INFORMATION
Before using the appliance carefully read
Safety Instructions.
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes
and on the machine’s functional components.
• It is mandatory that THE SALT RESERVOIR BE NEVER EMPTY.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be lled when the SALT REFILL
indicator light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the rst time you do this: ll the salt
reservoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the wa-
ter softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential
that the water hardness setting is based on the actual water hardness
in your house. This information can be obtained from your local water
supplier. The factory sets the default value for the water hardness
• Switch on the appliance by pressing the button.ON/OFF
• Switch o the appliance by pressing the button.ON/OFF
• Hold down button START/Pause for 5 seconds, until you hear a beep.
• Switch on the appliance by pressing the button.ON/OFF
• The current selection level number and the salt indicator light both
ash.
• Press button to select the desired hardness level (Psee WATER
HARDNESS TABLE).
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5
Very hard
35 - 50 61 - 90 43 - 62
• Switch o the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches o.
If the salt container is not lled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser should A
be lled when the indicator light in the control RINSE AID REFILL
panel is lit.
1. Open the dispenser by pressing and pulling up the tab on the lid.B
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can ad-
just the quantity of rinse aid used.
• Switch the dishwasher on using the button.ON/OFF
• Switch it o using the button.ON/OFF
• Press button START/Pause three times - a beep will be heard.
• Switch it on using the button.ON/OFF
• The current selection level number and rinse aid indicator light ash.
• Press button to select the level of rinse aid quantity to be supplied.P
• Switch it o using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied.
The LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is specic to the model, please follow instruction
above to check this for your machine.
• If you see bluish streaks on the dishes, set a low number (2-3).
• If there are drops of water or limescale marks on the dishes, set a mid-
-range number (4-5).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C.
Introduce the detergent into the dry dispenser D only. Place
the amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are indiD-
cations to help the detergent dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent dispen-
ser by pulling it up until the closing
device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing
and drying results are always achieved.
Usage of detergent not designed for dishwashers may cause mal-
function or damage to the appliance.
A
B
C
D

Produkt Specifikationer

Mærke: Privileg
Kategori: Opvaskemaskine
Model: P0B ECO D551 X

Har du brug for hjælp?

Hvis du har brug for hjælp til Privileg P0B ECO D551 X stil et spørgsmål nedenfor, og andre brugere vil svare dig


Opvaskemaskine Privileg Manualer

Privileg

Privileg P0F ECO D541 S Manual

21 Januar 2025
Privileg

Privileg P0U ECO D541 S Manual

21 Januar 2025
Privileg

Privileg P0B ECO D541 X Manual

21 Januar 2025
Privileg

Privileg PV2FC10BS7A0S Manual

14 Januar 2025
Privileg

Privileg P0F ECO D551 S Manual

14 Januar 2025
Privileg

Privileg P0U ECO D551 S Manual

14 Januar 2025
Privileg

Privileg P0B ECO D551 X Manual

14 Januar 2025
Privileg

Privileg PV2UC10BS7A0S Manual

14 Januar 2025
Privileg

Privileg PV2PC10BS7A0 Manual

14 Januar 2025
Privileg

Privileg PV2IC10BS7LA0 Manual

14 Januar 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Bosch

Bosch SPV4HMX65K Manual

15 Juni 2025
Bosch

Bosch SMS6HMI00I Manual

15 Juni 2025
Mainstreet Equipment

Mainstreet Equipment 541STAND24KIT Manual

15 Juni 2025
Bosch

Bosch SMV4EVX02F Manual

15 Juni 2025
Pelgrim

Pelgrim GVWC291L Manual

15 Juni 2025
Mainstreet Equipment

Mainstreet Equipment 541STAND24 Manual

15 Juni 2025
CMA Dishmachines

CMA Dishmachines E-AH-EXT Manual

15 Juni 2025
Bosch

Bosch SPV2IKX10K Manual

15 Juni 2025
Champion

Champion DH6000 Manual

15 Juni 2025
Asko

Asko DWC6432FIXXLU Manual

15 Juni 2025