Privileg RSIO 3T224 E Manual

Privileg Opvaskemaskine RSIO 3T224 E

Læs gratis den danske manual til Privileg RSIO 3T224 E (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Privileg RSIO 3T224 E, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

DAILY REFERENCE

GUIDE

Before using the appliance carefully read Health and Safety guide.

APPLIANCE

PRODUCT DESCRIPTION

CONTROL PANEL

1. Upper rack

2. Foldable aps

3. Upper rack height adjuster

4. Upper spray arm

5. Lower rack

6. Space Zone

7. Cutlery basket

8. Lower spray arm

9. Filter Assembly

10. Salt reservoir

11. Detergent and Rinse Aid dispensers

12. Rating plate

13. Control panel

1. On-O/Reset button with indicator light

2. Program selection button

3. Salt rell indicator light

4. Rinse Aid rell indicator light

5. Program number and delay time indicator

6. Display

7. Delay indicator light

8. Half Load indicator lights

9. Push & Go button

10. Delay button

11. Half Load button with indicator light

12. Tablet (Tab) button with indicator light

13. Start/Pause button with indicator light

0000 000 00000

S i :erv ce

1112

1 2 3 4 5 6 7 8 9 10

11 12 13

You can download the Safety Instructions and the Use and Care Guide, by visiting our website

docs.whirlpool.eu and following the Instructions on the back of this booklet.

FIRST TIME USE

SALT, RINSE AID AND DETERGENT

ADVICE REGARDING THE FIRST TIME USE

After installation, remove the stoppers from the racks and the reta-

ining elastic elements from the upper rack.

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and

on the machine’s functional components.

• It is important that the salt reservoir be never empty.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher (see PRO

DUCT DESCRIPTION) and should be lled when the SALT REFILL indi-

cator light in the control panel is lit .

1. Remove the lower rack and unscrew the

reservoir cap (anticlockwise).

2. -Only the rst time you do this: ll the salt re

servoir with water.

3. Position the funnel (see gure) and ll the salt

reservoir right up to its edge (approximately

1 kg); it is not unusual for a little water to leak

out.

4. Remove the funnel and wipe any salt residue

away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get

into the container during the wash program (this could damage the

water softener beyond repair).

Whenever you need to add salt, it is mandatory to complete the

procedure before the beginning of the washing cycle.

SETTING THE WATER HARDNESS

To allow the water softener to work in a perfect way, it is essential that

the water hardness setting is based on the actual water hardness in

your house. This information can be obtained from your local water

supplier.

The factory setting is for average (3) water hardness.

• Switch on the appliance by pressing the button.ON/OFF

• Switch o the appliance by pressing the button.ON/OFF

• Hold down button for 5 seconds, until you hear a beep.P

• Switch on the appliance by pressing the button.ON/OFF

• The current selection level number and the salt indicator light both

ash.

• Press button to select the desired hardness level (Psee WATER HARD-

NESS TABLE).

• Switch o the appliance by pressing the button.ON/OFF

Setting is complete!

As soon as this procedure is complete, run a program without loading.

Only use salt that has been specically designed for dishwashers.

After the salt has been poured into the machine, the SALT REFILL indi-

cator light switches o.

If the salt container is not lled, the water softener and the

heating element may be damaged as a result.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid dispenser shouldA

be lled when the RINSE AID REFILL indicator light in the control

panel is lit.

1. Open the dispenser by pressing and pulling up the tab on the lidB .

2. Pour in the rinse aid (max.110 ml), making sure it does not overow

from the dispenser. If this happens, clean the spill immediately with a

dry cloth.

3. Press the lid down until you hear a click to close it.

NEVER pour the rinse aid directly into the appliance tub.

ADJUSTING THE DOSAGE OF RINSE AID

If you are not completely satised with the drying results, you can ad-

just the quantity of rinse aid used.

• Switch the dishwasher on using the button.ON/OFF

• Switch it o using the button.ON/OFF

• Press button three times - a beep will be heard.P

• Switch it on using the button.ON/OFF

• The current selection level number and rinse aid indicator light ash.

• Press button to select the level of rinse aid quantity to be supplied.P

• Switch it o using the buttonON/OFF

Setting is complete!

If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied.

The LOW RINSE AID indicator light will not be lit if you run out of rinse

aid.

A maximum of 5 levels can be set according to the dishwasher model.

The factory setting is specic to the model, please follow instruction

above to check this for your machine.

• If you see bluish streaks on the dishes, set a low number (1-2).

• If there are drops of water or limescale marks on the dishes, set a

mid-range number (3-4).

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser use the opening device A.

Introduce the detergent into the dry

dispenser B only. Place the amount

of detergent for pre-washing directly

inside the tub.

1. When measuring out the detergent re-

fer to the mentioned earlier information

to add the proper quantity. Inside the

dispenser B there are indications to help

the detergent dosing.

2. Remove detergent residues from the

edges of the dispenser and

close the cover until it clicks.

3. Close the lid of the detergent dispenser by pulling it up until the

closing device is secured in place.

The detergent dispenser automatically opens up at the right time ac-

cording to the program.

If all-in-one detergents are used, we recommend using the TABLET

button, because it adjusts the program so that the best washing and

drying results are always achieved.

Water Hardness Table

Level

°dH

German degrees

°fH

French degrees

1 Soft 0 - 6 0 - 10

2 Medium 7 - 11 11 - 20

3 Average 12 - 17 21 - 30

4 Hard 18 - 34 31 - 60

5 Very hard 35 - 50 61 - 90

Produkt Specifikationer

Mærke:	Privileg
Kategori:	Opvaskemaskine
Model:	RSIO 3T224 E

Har du brug for hjælp?

Hvis du har brug for hjælp til Privileg RSIO 3T224 E stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Opvaskemaskine Privileg Manualer

Privileg RUO 3T133 A F X Manual

31 August 2025

Privileg P2F HD624 A Manual

31 August 2025

Privileg P0I ECO D551 S Manual

18 Juli 2025

Privileg P0I ECO D541 S Manual

18 Juli 2025

Privileg P0F ECO D541 S Manual

21 Januar 2025

Privileg P0U ECO D541 S Manual

21 Januar 2025

Privileg P0B ECO D541 X Manual

21 Januar 2025

Privileg PV2FC10BS7A0S Manual

14 Januar 2025

Privileg P0F ECO D551 S Manual

14 Januar 2025

Privileg P0U ECO D551 S Manual

14 Januar 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Element ENB6631PEBB Manual

13 September 2025

Siemens SN66M080EU Manual

13 September 2025

Element ENB5322HECW Manual

13 September 2025

Meireles MLL158W Manual

13 September 2025

Neff S145HTS01G Manual

12 September 2025

Whirlpool ADP 4736 IX Manual

12 September 2025

Barazza 1LVE6I Manual

12 September 2025

Robinhood DWM12P6FSS Manual

12 September 2025

Siemens SK25210EU Manual

12 September 2025

Fagor 4LVF-435AD Manual

12 September 2025